Recalls › 96I002000

NHTSA recall 96I002000 · Incomplete vehicle

Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings

Ford Crown Victoria

Reported Mar 13, 199617,600 vehicles affectedFORD MOTOR COMPANYBuilt Nov 1, 1991 – Dec 1, 1992

The remedy

Dealers will inspect the rear brake lines, and if necessary, replace a section of the rear brake lines if it IS leaking. Also the rubber shield on the line will be inspected to verify that it IS properly located and it will be secured with an additional worm-drive type clamp.

Official recall at NHTSA ↗

Ask AI about this recallChatGPTClaudePerplexityGoogle AIGrok

Vehicles in this recall

Notes

System: brakes; hydraulic; lines; hose; non-metallic. Vehicle description: non-abs equipped police vehicles. Description of problem: this IS not a safety recall in accordance with federal regulation 573. However, it IS deemed a safety improvement campaign by the agency. The rear brake line can come into contact with a body weld flange at the lower dash panel during pursuit or slalom type police maneuvers.consequence of problem: this condition can wear a small hole in the brake linecausing gradual brake fluid leakage eventually resulting in the loss of therear service brakes.note: ford has decided to conduct a safety improvement service campaign toinspect the brake lines on these police vehicles. Owners can contact fordat 1-800-392-3673.