Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
Throttle cable may have been damaged during installation resulting in a bend or a kink or chafing and fraying of the braided wire cable. consequence of…
Two throttle return spring defects are involved in this recall. (1) buses equipped with caterpillar engines may have a throttle return spring that breaks and prevents the throttle from returning to idle position when the driver's…
Under certain specific load conditions, such as accidental high speed impacts on the rear suspension system, the rear wheel bearings and hub assemblies could deteriorate.…
The protective sleeve covering of the return fuel hose between the pressure regulator and fuel return pipe was shortened leaving part of the hose exposed. in some instances this part of the hose becomes kinked due to the engine…
A wire from the stop lamp switch to the speed control amplifier IS missing. This wire sends a signal to the cruise control to disengage when the brakes are applied.…
Limousines were built with a clear lens and clear bulb combination for the front park/turn signal lamp assemblies, instead of the amber color as required by fmvss 108, "lamps, reflective devices, and associated equipment."
An interference with the fit of the wheel to the front hub lugs could result in loosening of the lug nuts while driving. consequence of…
The engine air cleaner plastic trim cover could fall off the air cleaner assembly and land on the exhaust manifold creating a fire hazard.…
A resonant vibration can be initiated under certain operating conditions, causing a deterioration of the brake chamber which results in reverse brake cam rotation creating grabby brakes, brake chatter, or spring brake…
Screws holding support framing for liquid propane gas (lpg) tank and generator may not be properly installed and may cause the tank and/or generator to fall off the motorhome while on the highway.…
An incorrect steering shaft retaining nut IS installed on the shaft and can loosen causing steering play. consequence of…
The drag link to pitman arm toggle angle may be greater than design criteria, and may cause the steering to bind. consequence of…
Steering column boot attached to exterior of firewall could be deformed by the sound insulation placed on the firewall and causes interference with the steering shaft u-joint bolt.…
The sealant used on the injection pump could penetrate through the bushing and get between the throttle shaft and bushings causing the shaft to bind.…
The steering wheel to steering column securing nut may be upside down and/or improperly torqued and may loosen. this allows the steering wheel to become disengaged or detached from the steering column.…
Headlamp covers were installed on vehicles in error. causing the cars not to comply with fmvss 108, lamps, reflective devices and associated equipment.…
A support that connects the body to the chassis lies against the brake line that connects the master cylinder to the brake warning switch. continued vibrations may cause the brake lines to wear through and result in loss of…
Under certain conditions the plastic fan for the under floor heater could catch on fire due to the close proximity to the low speed resistor which generates enough heat to ignite the fan.…
The right rear tail lamp assembly may be incorrectly assembled. the misassembled units will result in reduced illumination which will cause the lamp assembly to be in non-compliance with fmvss 108 lamps, reflective devices…
An incorrectly indexed wiring harness may cause the center high mounted stop lamp to remain illuminated when the headlights or parking lamps are on. fmvss 108 lamps, reflective devices and associated equipment requires…
The center control arm of the steering linkage system may develop a crack if the steering wheel IS repeatedly operated while vehicle IS in parked position. the steering center arm may eventually break.…
The rear wheel brake lines are subject to damage from road debris which would cause brake fluid leakage. consequence of…
The wheel lug nuts may have been improperly tightened. also, the steering shaft clamp bolts may not be properly tightened. consequence of…
The bolt in the upper steering column u-joint clamp may have been over torqued and may break. consequence of…
The push-pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out.…
The brass fitting on one end of the low pressure lp gas hose could be inadequately crimped to the hose allowing gas to leak. consequence of…
Improperly heat treated steel rollers used in the rear wheel parking brake system causes the rollers to become brittle and may fracture.…
Battery cap vents may be partially or completely blocked with plastic flashing. consequence of…
The seat belts loosen as truck IS driven. the non locking retractor takes up any belt slack, giving false impression that the belt IS still tight.…
Front axle springs may crack in the spring eye area. consequence of defect: spring could become detached severely limiting vehicle control which may…