Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
School, transit, or heavy duty vehicles equipped with spicer 6,000 or 8,000 lb. Front steer axles. the tie rod end can pull outboard and separate from the tie rod tube due to improper thread engagement between the male tie rod end and the…
Vehicle description: motorcycles. the fuel hose can fail resulting in a fuel leak near the rear cylinder of the motorcycle and under the rider seat.
Vehicle description: motor homes equipped with tag axles. there IS reduced braking ability on the rear axle due to the tag axle ABS sensors reading "no tire/wheel rotation," under heavy braking conditions. the sensors detect that the…
Vehicle description: passenger vehicles. a defective weld was discovered on the weld nut for the bolt used to secure the front shoulder seat belt guides.
Vehicle description: school and transit buses mounted on chassis equipped with an option for three batteries. the battery cables may not have been routed properly allowing the cable to be chafed or pinched.
Vehicle description: MINI vans. these vehicles were produced with a higher than specified electrical load through the accessory power feed circuit. the potential for contact between the B2 (battery), A2 (accessory), and P1 (proof)…
Vehicle description: MINI vans. heat generation in the wiring harness to the fuel pump/sender assembly can cause an electrical short. the vehicle could experience a loss of power and become immobilized and the fuel gauge may be erratic.
Vehicle description: sport utility vehicles. the coupling that connects the steering column shaft to the intermediate steering shaft IS cracked. this could allow the steering shafts to separate.
Vehicle description: heavy duty trucks. the hook on the throttle return springs can fracture at low mileage.
Vehicle description: pickup trucks, crew cabs, utility trucks and sport utility vehicles. these vehicles were built with the polarity of the wiring for the zero adjust brake switch reversed from what was specified on the switch drawing.…
Vehicle description: model 3500 light duty trucks only. operation of the headlamps over an extended period of time can result in headlamp switch failure, causing the headlamps or park lamps to go out.
Vehicle description: van and wagon model passenger vehicles. if water/road salt gets on the interior floor of the vehicle in the proximity of the air bag electronic control module (aecm), the aecm can corrode. the resulting corrosion…
Vehicle description: passenger vehicles. the sound absorbing mat attached to the inside of the b-pillar side trim panel could have been improperly installed. surface and edges of the mat could have been damaged during the assembly…
Vehicle description: school buses equipped with 30-inch and 34-inch seats and barriers or 36, 39, and 45-inch seats and barriers with offset legs installed in the first body section behind the driver. when narrow seats and barriers (30"…
Vehicle description: medium duty trucks. a small seal boot in the self-adjusting brake system located on the right rear slack adjuster may have been torn in the movement of the vehicle during the assembly process.
Vehicle description: transit buses. the tether plates, which are attached to the rear of both the upper and lower frames of the suspension unit, contain a sharp edge which can cause premature weat of the nylon tethers. this does not…
Vehicle description: school buses mounted on navistar chassis. the standard cross view mirror assemblies installed on these buses do not conform to the requirements of fmvss no. 111, "rearview mirrors."
Vehicle description: motorcycles built with 19" front wheels. the front inner tube located in the front wheel assembly can deform causing loss of air pressure.
Vehicle description: class a motor homes. these motor homes, when fully equipped and loaded with typical cargo, will experience an overloaded condition on the rear axle.
Vehicle description: class 8 heavy duty truck chassis equipped with mack 16,000 lb., 18,000 lb., or 20,000 lb. Heavy duty steering axles. the inner wheel bearing cone for the steering axle wheel hub assembly does not properly fit onto…
Vehicle description: trailers manufactured by various builders for straightline manufacturing. the axles and axle components can bend and even break on some units allowing the axle to strike the frame causing damage to the axle and axle…
Vehicle description: passenger vehicles equipped with the optional traction control system. due to improper design of the rear brake tube distribution, if one of the dual brake lines fails when the driver applies the brake, the vehicle…
Vehicle description: passenger vehicles. the headlights and taillights may not automatically illuminate in low ambient light when the headlight switch IS placed in the "auto" position.
Vehicle description: fire trucks. the cab tilt system contains a 12 volt electrical solenoid assembly as an accessory to the cab tilt electric motor/hydraulic pump assembly. rain, snow, salt spray or other corrosive environment can…
Vehicle description: MINI vans equipped with integrated dual child seats. some of these vehicles may be missing a seat belt retractor clutch spring and/or pawl spring in the child seat. if the clutch spring was missing, the seat belt…
Vehicle description: sport utility vehicles. as a result of water ingress and subsequent ice blockage, the transmission breather tube can become clogged, expelling transmission fluid from the dipstick tube onto hot engine components.
Vehicle description: carpenter front engine, spring suspension school buses. due to frame flexing, both the front spring hanger mounting bolts and the steering box mounting bolts can loosen allowing subsequent fracture or torque loss…
Vehicle description: motorcycles. the engine cam bolt can lose its clamp load and/or break.
Vehicle description: vans and vans used for conversion. if a heavy object impacts the metal casing of the air bag electronic control module (aecm), located under the driver seat, the module could inadvertently deploy the air bags.
Vehicle description: passenger vehicles. the rear suspension crossmember may be missing spot welds.