Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
On certain class 8 heavy duty trucks equipped with r. H. Sheppard M90 steering gears, an incorrect hose was used for the high-pressure line between the power steering pump and the steering gear. the hose IS rated at 2000 psi, while it…
Certain sedans fail to comply with federal motor vehicle safety standards no. 210, "seat belt assembly anchorages," and no. 214, "side impact protection." these vehicles were manufactured with welds between the door striker and belt-line…
On certain heavy duty trucks equipped with meritor wabco pneumatic anitlock brake system (ABS) valve packages, the assembly bolts on these valve packages were not tightened correctly.
Certain fifth wheel trailers and truck campers equipped with model hp 6000 automatic changeover regulators. these regulators contain two rubber diaphragms in which the second diaphragm can tear under pressure resulting in a propane leak.
On some motorcycles, the rear fender front mounting tabs securing the rear fender can fracture, causing the rear fender to break away from the frame and drop onto the rear tire.
Certain heavy duty class 8 trucks fail to comply with the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." two reflectors are missing from the end of the frame crossmember.
On certain rear diesel motor homes equipped with optional gas generators, the generator fuel fill gas cap provided with the unit may not completely seal against the rim of the fill tube.
On certain motorcycles, fuel can leak from the fuel pump flange.
On certain passenger vehicles equipped with a traction control system, the odometer in the subject vehicles registers distance in kilometers instead of miles as IS specified in the design. the odometer does not have a label that indicates…
On certain coaches and bus shells equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to…
On some travel trailers equipped with optional underslung spare tire carriers, the locking pin for the spare tire carrier may not have been installed.
Certain light duty pickup trucks equipped with a heavy duty service package fail to comply with the requirements of fmvss no. 120, "tire selection and rims for motor vehicles other than passenger cars." a typographical error occurred…
On class a motor homes built with a steerable auxiliary axle and equipped with certain meritor-wabco brake system two and four port relay valves, the valve may stick open when a high-pressure brake application IS released.
The steering knuckle castings on certain passenger vehicles may have been contaminated during the casting process.
Certain motorcycles were built with a front shock mount that IS cracked and could break allowing the suspension to drop unexpectedly.
On certain motorcycles, the clips that retain the wiring for the front fender tip light can become detached from the fender, causing the wires to fray and short.
On certain 28' van trailers supplied to usf dugan, cracks have occurred in the crossmembers above the suspension.
On certain motor homes built on prevost chassis, the steering gear box IS mounted on a support located under the driver's seat floor. on motor home models, this support varies in height with the optional interior height. with 83 and 86…
Vehicle description: taurus/sable vehicles equipped with 3.0L and 3.8L engines and mustang vehicles with 3.8L and 5.0L engines. it IS possible for the engine cooling fan bearing to seize.
Vehicle description: trucks equipped with e-tech engines. a condition exists on the auxiliary drive shaft of the e-tech engine that causes the loss of power steering on vehicles where the power steering pump IS mounted off the front of…
Motorhomes equipped with drag link assemblies containing 20-edl model ball sockets and manufactured by trw. certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature…
Vehicle description: certain sport utility vehicles fail to comply with the requirements of fmvss no. 210, "seat belt assembly anchorages." some vehicles were produced with rear outer seat belt shoulder guide anchor bolts that were…
On certain trucks equipped with caterpillar 3406e and C-15 engines, interference between the positive battery cable and stud mounting electronic control module (ecm) to the engine exists. chafing can wear through the battery cable…
Vehicle description: certain MINI vans without anti-lock braking systems (ABS) fail to comply with the requirements of federal motor vehicle safety standard no. 135, "passenger car brake systems." due to inappropriate brake pipe layout…
Vehicle description: motorcycles. threaded fasteners used to attach the fuel pump to the fuel tank may not have been properly tightened.
Vehicle description: certain buses fail to comply with the requirements of federal motor vehicle safety standard no. 120, "tire selection and rims for motor vehicles other than passenger cars." the tire placard label contains an…
Vehicle description: certain MINI vans built with second row 50/50 split bench seats or captain's chairs, fail to comply with the requirements of fmvss no. 225, "child restraint anchorage systems." the seat latch anchor wire diameter IS…
Vehicle description: certain sedans and coupes fail to comply with the requirements of federal motor vehicle safety standard no. 209, "seat belt assemblies." certain rear seat belt buckles were improperly manufactured.
Vehicle description: recycler top select 1000/2000 and garbage side loader expert 2000 trucks which use the hollow shaft steering gear box(es). some steering gear boxes were originally assembly with very little grease.
Vehicle description: fire truck chassis with caterpillar 3126 engines. the alternator cable was routed over the top of the alternator, and in some cases, allowed the cable to make contact with and wear on structural members of the engine…