Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
On certain suburban model P-40 (stock number 2230) furnaces for use on park model trailers, the fans on the defective combustion air blower are improperly oriented. this results in an inadequate supply of combustion air to the burner in…
On certain park model trailers equipped with suburban model P-40 (stock number 2230) furnaces, the fans on the defective combustion air blower are improperly oriented. this results in an inadequate supply of combustion air to the burner…
On certain trucks, the cotter pin that goes through the drag link ball stud at the connection to the pitman arm IS missing. this pin prevents the castle nut from loosening.
Certain trucks equipped with engine starters (code 08wwn or 08wwp) built by leece-neville. these starters have a defective terminal adapter stud. the stud IS used only at the positive battery connection to the starter solenoid. it was…
Certain class a motor homes equipped with an electdraulic-braking device built by ausco. when activated, the master cylinder applies the brakes on the tag axle. if the motor home IS traveling, the tag axle brakes could lock-up.
On certain buses equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the…
On certain passenger vehicles, the engine ground strap was manufactured improperly. as a result of the improper "crimping" of the ground strap connectors to the braided ground strap, the engine ground strap may not provide the proper…
On certain motorcycles, fractures can occur on either the left or right fuel tank at the top of the joint where the bracket IS welded to the tank back plate.
Certain hopper bottom farm trailers fail to comply with the requirements of federal motor vehicle safety standard no. 121, "air brake systems." the suspension on these trailers IS not equipped with an anti-lock brake system (ABS) as…
On certain heavy duty trucks equipped with dana spicer tandem drive axle models ds463, an undersized attachment weld may fracture without warning.
On certain transit buses equipped with adhesively bonded aluminum bus door panels, due to an imperfect bonding of the door panel skin to the panel frame, environmental moisture may infiltrate regions of imperfect bonding and cause…
On certain motor coaches/motor homes equipped with electronic throttle control/accelerator pedals supplied by williams controls industries, the weld attaching the clevis to the plate has insufficient penetration and could allow the clevis…
On certain bumper-pull horse trailers, the safety cables, used to maintain a connection between the trailer and tow vehicle, are not equipped with thimbles and thus do not conform to sae J684.
On certain trucks, a capacitor in the power line control (plc) filter could overheat and/or ignite when subjected to reverse polarity electrical spikes.
On certain school buses, misalignment of the fan drive system components can cause premature belt and pulley bearing wear.
Certain MINI vans fail to comply to the requirements of federal motor vehicle safety standard no. 120, "tire selection and rims for motor vehicles other than passenger cars." an incorrect gross axle weight rating (gawr) was indicated on…
Certain heavy duty trucks converted from sleepercabs to day cabs and equipped with a detroit diesel optimized idle system. the idle system was not completely disabled in the cab conversion process.
On certain motorcycles, a fuel valve's outlet nipple, to which the fuel line attaches, may pull out of the fuel valve, allowing fuel to exit onto the motor and primary drive.
On certain motorcycles, the fuel tanks may have been improperly mounted to the motorcycle. this can put unnecessary stress on the tank mounting tabs, causing these tabs to fail, with the possibility of fuel spillage.
On certain passenger vehicles, the lower steering column shaft coupling may have been installed onto the input shaft of the steering rack with too much clearance between the bottom of the coupling and the steering rack input shaft housing.
On certain travel trailers, the electrical wiring installed in the rear of the refrigerator compartment could contact the top metal fins of the refrigerator condenser coil. the heating coil and fins could reach temperatures that approach…
On certain passenger vehicles, a problem in the manufacturing process of the rear brake rotors may have resulted in the creation of a crack where the brake disc and the parking brake drum meet. further cracking of the rotor could occur…
On certain transit buses equipped with vanner 60 series battery equalizers, the equalizer could fail to operate properly and cause malfunction of the battery charging system.
On certain vehicles equipped with teleflex morse electric floor pedals. under heavy use, one of the pedal dual return-spring arms on the floor-mounted electric pedals may fail. a failure could cause the vehicle to accelerate unexpectedly.
On certain buses equipped with electronic throttle control/accelerator pedals supplied by williams controls industries. The weld attaching the clevis to the plate has insufficient penetration and could allow the clevis to separate from the…
On certain passenger vehicles, a component in the inflator of some passenger air bag modules was not welded properly.
On certain transit buses equipped with adhesively bonded aluminum bus door panels, due to an imperfect bonding of the door panel skin to the panel frame, environmental moisture may infiltrate regions of imperfect bonding and cause…
On certain motor homes built on prevost chassis and equipped with slide-out rooms, the microprocessor that controls the slide-out operation generates a false situation which tells the slide-out mechanism to operate. when this happens, a…
On certain passenger vehicles, the brake master cylinders may not function properly in ambient temperatures below freezing 32 degrees fahrenheit and lower).
On certain two-wheel drive (2WD) passenger vehicles, it IS possible for the bolts that join the rear brake and hub assembly to the rear axle carrier to be loose due to insufficient tightening during the assembly process.