Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
On certain motor homes equipped with samsung microwave ovens, models mr1031wb, mr1032bb, mr1033sb, mr1351wb, and mr1352bb, the microwaves were produced with a defective membrane panel. these microwave ovens have the one touch instant cook…
On certain dump trucks built on kenworth T800 or W900 chassis and outfitted with a factory installed rigid lift-axle, the lift-axle could detach from the dump truck. one or more of the six bolts that affix each lift-axle bracket may not…
On certain converter dollies, the check valve between the air reservoir and the booster valve was installed in the reverse position with the arrow on the valve pointing towards the air reservoir.
On certain converter dollies, there IS a clearance problem between the loop on the trailer and the loop on the dolly. the hook on the end of the chain will not pass between the loop and the pintle hook.
On certain fifth wheel trailers equipped with samsung microwave ovens, model mr1032bb, the microwaves were produced with a defective membrane panel. these microwave ovens have the one touch instant cook function for items such as popcorn…
On certain van trailers equipped with a specific brake chamber, the chamber has a pushrod length that IS shorter than recommended.
The tire inflation pressure indicated on the vehicle certification label IS not correct. The labels show the maximum tire pressure as 240 kpa/32 psi when it should be shown as 240 kpa/35 psi. as a result of this error, the load ratios for…
On certain vehicles, the trunk lid springs could fail in the closed trunk lid position.
On certain shuttle bus chassis, due to the location of the 90 gallon fuel tank, a leak in a weld where the tank contacts the lower fuel tank support can occur.
Certain motor home chassis fail to conform to the requirements of federal motor vehicle safety standard no. 121, 'air brake systems.' in a situation in which multiple alarms are active, a check engine, stop engine, or similar warning…
The left and right side curtain air bags in certain vehicles involved in this campaign may not fully deploy rapidly enough when activated in a side impact collision. during a side impact test conducted by the insurance institute for…
On certain passenger vehicles involved in this campaign, the lower control arm ball stud nut/washer assemblies with washers were made of the wrong material. the washers may fracture and become loose or fall away from the vehicle, reducing…
On certain shuttle bus chassis, the brake assemblies exhibit elevated temperatures that can lead to catastrophic deterioration of the wheel end components such as bearings, races, spindles, knuckles, seals, hubs, rotors, patch bolts…
On certain fire trucks, one or both of the cab tilt cylinders may lock when the cab IS being lowered. this can happen if a velocity fuse trips in either of the cylinders.
Certain vehicles equipped with supercharged 2.0L 4-cylinder (lsj) engine were built with a fuel feed pipe that could crack and leak fuel near the fuel rail. If fuel leaks from the fuel feed pipe, there would be a noticeable fuel odor…
On certain vehicles, the foot of the driver's side seat riser may develop a crack, resulting in reduced strength of the seat anchorage.
On some trailer mounted aerial work platform booms, certain personnel platform elevating jibs and associated composite bearings can fail.
On certain emergency/fire/rescue single and tandem axle chassis, the brake air lines may have been incorrectly routed.
Certain buses involved in this campaign fail to comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages." the driver's seat tether strap was not installed.
On certain trucks built with 8,000 or 6,000 pound front axles and four-piece spindle nut sets, premature front ,wheel bearing wear may be caused by inconsistent bearing endplay adjustment.
On certain motor homes equipped with an independent front suspension (ifs) gen II built by holland USA, the gear plate support gussets were removed. this can allow the plate to flex during a static steer condition.
On certain class 8 chassis built with hendrickson lift axles which contained webb brake drums, the brake drums could experience premature crack of the braking surface resulting in reduction or complete loss of braking on that wheel end or…
On certain passenger vehicles, the dimmer control for the instrument panel lights could fail due to heat buildup.
On certain sport utility vehicles, the wire harness of the driver's front air bag was incorrectly wired.
On certain school buses and truck model vehicles manufactured between february 28, 1999, through april 5, 2004, the anti-lock brake system electronic control unit (ecu) may misinterpret a corrupt wheel speed signal.
On certain passenger vehicles equipped with 2.4L non-turbocharged engines and automatic transaxles, the power steering pressure hose may contact the automatic transaxle differential cover, potentially damaging the hose.
On some motorcycles, under certain assembly conditions, the electrical power supply cable to the starter motor may come into direct contact with the oil cooler return pipe. this could cause the insulation on the starter cable to degrade.
On certain chassis equipped with the sealco 508 rubber band check valve that IS used on the 110502 brass control port cap assembly which IS installed in the control port of sealco's 11050, 110700 and 110800 spring brake control valves may…
On certain chassis equipped with the sealco 508 rubber band check valve that IS used on the 110502 brass control port cap assembly which IS installed in the control port of sealco's 11050, 110700 and 110800 spring brake control valves may…
On certain motor homes, the water heater was installed under the slide-out, which made it possible for fumes to enter the coach when the water heater IS lit and the coach IS parked with the slide-out extended.