Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
On certain trucks equipped with michelin 365/85 R20 tires, the tires may not be compatible with the maximum load and maximum speed ratings.
On certain trucks, the tie rod end ball joint dust boot was designed with insufficient sealing ability. this condition could allow contamination to enter into the tie rod end ball joint, abnormally wearing the resin bearing located inside…
On certain passenger vehicles, the occupant position detection system's side sensor IS not installed in the correct position and may fail to shut off the passenger's side impact airbag if the occupant IS out-of-position.
Certain passenger vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. The brake fluid could reach elevated…
On certain trucks,the steering system knuckle arm was designed with an insufficient strength margin. repeated steering operation while stationary, or normal vehicle operation that requires frequent repeated steering operation, could cause…
On certain trucks, some of the huck bolts on the cab may not have been properly installed.
On certain sedans, the left and right rear outboard retractor and turning loop bolts on the seat belts may not have been properly tightened.
On certain MINI vans, condensation from the instrument panel air conditioning ducts may drop through vent holes in the top of the radio and result in a short circuit that subsequently sends direct current to the rear speakers.
On certain motorcycles, the kickstand spring attaching stud may break off allowing the kickstand to deploy into the extended position.
On certain buses equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly IS out of alignment.
On certain buses equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly IS out of alignment.
On certain trucks, the fuel tank mounting strap was not welded to specifications and may fail. the fuel tank strap supports and fastens the steps for the operator and passenger to enter and exit the cab.
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 124, 'accelerator control systems.' in hot ambient conditions, the accelerator pedal arm may stick at the attachment to the…
On certain sport utility vehicles, vibration and heat may cause the tail lamp/stop lamp bulb to loosen in its socket. if this occurs, the bulb may flicker and eventually become inoperative.
On certain passenger vehicles, the rear lamps that provide stop and turn signals and tail lamp functions stop working because of inadequate contact between the bulb and socket. in addition, if one bulbs were to become inoperative while…
On certain transit buses, a light gauge steel was used for the floor frame crossmember located in the floor sub-frame.
On certain passenger vehicles, the internal wiring harness of the outer door handles may accidentally short circuit and open the electrical switch of the door.
On motor homes built on ford e-series chassis, the air filter element material process resulted in an air filter paper element that can smolder or burn. this change in filter paper composition combined with the configuration of the air…
On motor homes built on ford e-series chassis , a diode in the anti-lock braking system (ABS) module may experience an electrical short.
Certain 1998, 2000-2005 my ce, fe, and re school buses built with one or more ce white 30-inch child restraint seats and manufactured between march 25, 1998 and august 24, 2004. the seat cushion retention may not retain the seat in all…
On motor homes built on ford e-series chassis, the air filter element material process resulted in an air filter paper element that can smolder or burn. this change in filter paper composition combined with the configuration of the air…
On motor home chassis built by workhorse and equipped with bosch brakes, the pads can drag on the rotor surface due to the pin slide.
On certain walk-in vans built on ford chassis, the optional heel plate (treadplate/diamond plate) could limit the full movement of the accelerator pedal.
On certain trucks built with iros rear air suspension systems, four rear suspension fasteners may not be tightened sufficiently. this hardware connects the main support members of the rear suspension to the hanger brackets.
On certain buses equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly IS out of alignment.
On certain motorcycles, the clamp that secures the high pressure fuel hose to the fuel rail may be loose.
Certain 2005 my international re school buses manufactured between april 1 and june 16, 2004 which fail to comply with federal motor vehicle safety standard no. 121, air brake systems. two check valves may not have been installed on the…
On certain motorhomes, the outer wheel bearing in the hub of the axle may fail, leading to unexpected separation of the wheel from the axle. this failure may be due to an inadequate amount of grease in the hub assembly or the grease in…
On certain passenger and sport utility vehicles, over an extended period of time, the headlight switch may cease to function.
On certain passenger vehicles, the engine management system software may cause engine hesitation or stalling.