Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
Certain cut-away incomplete trucks equipped with lt225/75r16e tires fail to comply with the requirements of federal motor vehicle safety standard no. 120, 'tire selection and rims for motor vehicles other than passenger cars.' the tire…
Certain 2004-2005 sport utility vehicles and certain 2001-2003 sport utiity vehicle having rear liftgate components serviced with 2004 equivalent components fail to comply with the requirements of federal motor vehicle safety standard no.…
On certain trucks, the air suspension height control valve may not be installed correctly.
Certain seat belt buckles on some motor homes fail to conform to the load requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
On certain passenger vehicles, the hazard switch and flasher system function may degrade over time because of distortion and material transfer of the contacts of certain hazard switch relays which occurs due to substantially increased…
On certain passenger vehicles equipped with a front passenger power seat, when installing certain rear-facing infant child seat bases onto the seat with an excessively high seatbelt tension, it may be possible to unseat a component called…
Certain passenger cars fail to comply with the requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." all three rear seat positions and the front passenger position are equipped with seat belt…
Certain passenger cars fail to comply with the requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." all three rear seat positions and the front passenger position are equipped with seat belt…
On certain trucks, the brake pedal pushrod was not tightened properly during assembly.
On certain vehicles, there IS a defect in the interaxle driveline yokes. the bolt holes located on the earwork of the male shaft yokes were manufactured with an oversized minor thread diameter.
On certain vans built on ford e250/e350 chassis and equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly IS out of alignment.
On certain passenger vehicles, the high pressure diesel pumps were produced with an improper fastener, which could allow diesel fuel to escape from the pump.
On certain sport utility vehicles, the accessory tow hitch attachment bolts may not have been tightened to the proper specification.
Certain buses fail to comply with the requirements of federal motor vehicle safety standard no. 217, "bus emergency exits and window retention and release." these buses lack the correct number and size of emergency exits.
On certain sport utility vehicles, the accelerator cable may prevent the throttle from returning to the idle position.
On certain passenger vehicles, the right and/or left rear seat belts may not lock properly due to missing retaining pins on the housing.
On certain trucks, the power feed harness p92-1993 terminals were not properly crimped.
On certain sedans and convertible model vehicles, the right steering knuckle may have been damaged during the component manufacturing process.
On certain motorcycles, the main wire harness has a ground distribution connector that IS incorrectly assembled. some electrical circuits may overheat and short, including the fuel pump.
On certain fire trucks equipped with the all wheel steer option, the position of the front axle IS sensed by an optical encoder mounted to the bottom of the front axle kingpin, which IS protected from the elements by an outer case. this…
On certain motorcycles, the front brake hose can become trapped between the lower steering flange and the steering lock peg when the vehicle IS cornering.
On certain sport utility vehicles built with a 5.7L, 4.7L, or 3.7L engine, the positive battery cable may contact the front suspension upper control arm mounting bracket.
On certain travel trailers, during production, the wiring was routed over the top of the gray holding tank on the backside in a location where the wiring could become pinched by the heat plenum framing.
On certain sport utility vehicles built with 3.0L V6 engines, the accelerator cable may prevent the throttle from returning to the idle position.
Certain truck bodies built on isuzu chassis fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." the turn signal flash rate IS excessive and does not…
On certain motorcycles, an adapter in the rear brake line connects a rigid section to a flexible section. if the rigid section IS not properly engaged in the adapter, it IS possible for a leak to develop.
On certain passenger vehicles equipped with front seat heating systems, upon entering and exiting the vehicle, excessive contact with the side bolster that IS contained in the seat's backrest may damage the heating mat located in this…
Certain police motorcycles were built with a defective wiring harness. the antilock brake system (ABS ) IS wired through the same fuse circuit as the ABS malfunction warning light.
On certain trucks, the cable end of the parking brake cable, where it attaches to the parking brake lever, IS designed improperly. repeated normal parking brake operation may cause the cable end to become improperly seated in the parking…
On certain trucks, the rubber portion of the fuel injection pipe clamps could deteriorate. normal vehicle operation could cause the deteriorated clamp to loosen and drip.