Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
Certain passenger vehicles equipped with rear suspension knuckle bolts that are not to specification and could fracture under high loads that can occur in some driving conditions.
On certain class a motor homes, the spacer plate under the trailing arms had a transverse weld which creates a heat riser and cause the trailing arms to crack.
On certain motorcycles, an electronic component failure could occur in the electric harness control (ehc) module.
Certain trailers fail to comply with the requirements of federal motor vehicle safety standard no. 120, "tire selection and rims for motor vehicles other than passenger cars." the trailers were inadvertently equipped with an incorrect…
On certain pickup trucks equipped with an automatic transmission, there IS a possibility that the parking brake pedal cable lock nut may not have been tightened to the proper torque specification. in this condition, the lock nut may…
Certain two-seater coupes fail to comply with the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." the front side marker light, that IS behind the front wheel, needs to…
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 124, 'accelerator control systems.' if one of the two accelerator pedal return springs fails and the temperature IS -22 degrees f…
On certain single axle brush chipper trailers, fatigue and cracks can occur in the tongue weldment.
On certain motor homes, a circuit design resulted in a 12.1 amp circuit draw in the brake light circuit when it IS protected by a 10 amp circuit breaker.
Certain trucks, sport utility vehicles, and vans equipped with bosch hydro-boost brake assemblies, the hydraulic brake booster pressure accumulator may crack and separate from the hydro-boost assembly during normal operating conditions.
Certain trailers, equipped with truck-lite brand model 44,40 or 30 stop/tail light and front/rear side marker lights with no reflex lens or reflective material, fail to comply with the requirements of federal motor vehicle safety standard…
Certain bentley aftermarket fuel pump noise reduction kits, p/nos pf59918pa and pf59918pb, suitable for use on 2000-2002 my bentley arnage red label vehicles and 2001 my bentley arnage LE mans and lwb vehicles. the fuel pump outlet hose…
Certain aftermarket federal-mogul wagner and USA brand brake hardware kits for use on passenger cars and produced between november 18, 2004 and january 19, 2005. the subject kits were produced with missing parts which prevents the kit…
Certain ic ce 2005 school buses manufactured between april 27 and october 13, 2004. the locknut that secures the hydraulic brake pivot bolt may not be torqued properly.
On certain transit buses manufactured with detroit diesel series 50 engines, the turbocharger compressor wheel can break, resulting in shaft imbalance and lubricating oil passes into the exhaust system.
On certain drill rigs and well service rigs equipped with bendix antilock brake system (ABS), the air brake valving installed on the drive axles of certain tri-drive axle IS inadequate and it does not have the correct air valve…
On certain transit buses equipped with arvinmeritor urresko tie rod clamps, heat treatment of clamps created a surface hardness that could lead to a fracture of the clamps.
Certain bfgoodrich land terrain p235/75r15 tires, manufactured during the weeks of february 29 and through august 19, 2004, are missing the tire treadwear indicator required by federal motor vehicle safety standard no. 109, new pneumatic…
On certain minivans and sport utility vehicles, the steering column may be incorrectly assembled, which could result in a loss of steering control.
Certain my 2003 thru 2005 blue bird micro bird and conventional school buses. these buses do not have the tire load range on both the tire information label and certification decal as required by federal motor vehicle safety standard no.…
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 212, 'windshield mounting.' the windshield urethane bead may not have adhered to the body in certain areas during the cure…
On certain sport utility vehicles, the fuel tank filler tube inlet check valve may not fully close at the end of refueling. this could allow some fuel to escape from the vehicle filler neck.
On certain heavy duty class 8 fire trucks equipped with arvinmeritor urresko tie rod clamps, heat treatment of clamps created a surface hardness that could lead to a fracture of the clamps.
On certain heavy duty class 8 trucks equipped with bendix automatic brake systems (ABS), the brakes may have a system fault that may not be detected by the ABS electronic control uunit (ecu) and therefore will not generate an ABS warning…
On certain heavy duty class 8 trucks equipped with arvinmeritor urresko tie rod clamps, heat treatment of clamps created a surface hardness that could lead to a fracture of the clamps.
On certain heavy duty class 8 trucks equipped with arvinmeritor urresko tie rod clamps, heat treatment of clamps created a surface hardness that could lead to a fracture of the clamps.
Certain cummins isb diesel engines equipped with federal-mogal 12 and 24 volt fuel lift pumps for use in certain school buses, transit buses, and emergency vehicles. the fuel pump could fail to transfer fuel appropriately creating an…
Certain passenger vehicles with four or five doors and originally sold in or currently registered in connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey…
On certain transit buses equipped with detroit diesel series 50 engines, the turbocharger can fail allowing lubricating oil to enter the exhaust system.
Hid headlight conversion kits. These lighting sources do not conform the electrical specifications that IS required by federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment."