Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
Certain motor homes built on chevrolet chassis were produced with a body wiring harness with no protective conduit in the area under the driver's feet to reduce the potential for harness wear. the body wiring harness includes sdm wiring…
On certain fifth wheel trailers, propane lines were incorrectly positioned during manufacturing and do not have sufficient clearance between the floor of the slide room and the outside wall of the slide room.
On certain fifth wheel trailers, there IS a 12 volt light in the bunk bed area. this light can come into contact with the bunk mattress when the bunk IS in the closed position.
On certain motor homes equipped with ngi air pressure gauges located on the dash panel, the gauge IS giving a false reading.
Certain my 2004-2006 freightliner custom chassis B2 school buses and thomas built C2 school buses built with air or hydraulic brakes with a one valve park brake system and park brake release interlock manufactured between june 17, 2004…
On certain motor homes built on ford e-series chassis, the air filter element material process resulted in an air filter paper element that can smolder or burn. this change in filter paper composition, combined with the configuration of…
Certain towable travel trailers fail to conform to the requirements of federal motor vehicle safety standard no. 110, 'tire selection and rims.' these trailers are missing the tire information placard.
Certain motor homes built on workhorse chassis and equipped with actia corporate instrument clusters fail to comply with the requirements of federal motor vehicle safety standard (fmvss)nos. 101 "controls and displays" and no. 105…
On certain trucks, the hose connecting the engine block to the frame IS routed near the engine's turbocharger. heat from the turbocharger may cause the hose to melt.
On certain motor homes built on freightliner chassis and equipped with i-shafts supplied by zf heavy duty steering, the steering shaft assemblies with lower yokes may have been incorrectly machined. the steering shaft splines could push…
On certain vans built on ford E-450 and GMC C-550 chassis and equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly IS out of alignment.
Certain truck chassis cabs fail to comply with the requirements of federal motor vehicle safety standard no. 205, 'glazing materials.' the windshield installed was solid tempered glass instead of the intended laminated glass.
Certain trucks equipped with dual rear wheels fail to comply with the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices and associated equipment." the trucks may have been inadvertently manufactured…
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 206, "door locks and door retention components." an incorrect right front door latch reinforcement plate may have been…
On certain buses equipped with seat belts, the t-nut which holds the seat leg to the floor track IS missing machined bevels.
On certain class b motor homes built on chevrolet chassis, when the rear axle lift kit was installed, the u-bolt nuts were not tightened properly.
On certain vans equipped with the power liftgate option, the power liftgate motor automatically disengages after the liftgate IS powered open.
On certain sport utility vehicles, the material used to manufacture the front disc brake calipers may be brittle due to improper metallurgy.
On certain vans and sport utility vehicles, the front windshield wiper motor armature shaft may break.
Certain pickup trucks have galvanized-braided-steel tailgate support cables used to support the tailgate in the full open (horizontal) position. over time these cables can corrode and fracture when loads are applied to them.
Certain trailers fail to comply with the requirements of federal motor vehicle safety standard no. 223, "rear impact guards." proper rear impact guards were not installed on these trailers.
Certain light trucks fail to comply with the requirements of federal motor vehicle safety standard no. 206, "door locks and door retention components." an arc weld IS missing on some right side rear door upper latch assemblies.
On certain motorcycles, the handle bar clamp bolts were not sufficiently tightened.
On certain travel trailers built with the optional fuel station and equipped with a great plains fuel pump, the fuel pump can leak fuel.
On certain pickup trucks, the bead of the tire may be damaged due to improper assembly of the tires onto the wheels.
Certain conventional and fifth wheel travel trailers may have been equipped with improperly hardened axle wheel studs.
Certain motorcycles fail to comply with the requirements of federal motor vehicle safety standard no. 120, "tire selection and rims for motor vehicles other than passenger cars." the vehicle identification number (vin) decal located on…
Certain blue bird my 2006 micro bird school buses fail to comply with the requirements of federal motor vehicle safety standard no. 301, "fuel system integrity." the affected buses were produced with an 8 inch bumper rather than a 10 inch…
On certain vehicles, the bolted connections on the suspension's double wishbones may come loose over time or under extreme loading.
On certain horse trailers equipped with electric brakes which are built with a break-away control unit. these units are not wired correctly.