Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
The base marking on the 9005 bulb was incorrectly marked as type HB4 instead of HB3.
Cruise control system IS susceptible to water contamination and, if it becomes wet while in use, could create a short circuit.
The hub may separate from the discs of the rotors.
The king pin that IS used to join a trailer to the tractor at the couplings may fracture.
Loose retaining nut on steering wheel could cause the steering wheel to feel loose.
Due to cracking of a rubber diaphragm in the fuel pressure regulator, leakage may occur.
Shields on the fronts of the midship mounted fuel tanks were omitted during assembly.
Premature wear in the idler arm pivot bearing and or ball joint attachments could occur.
The lock cylinder override mechanism may fail and prevent a person on the inside from using the turn knob to exit the vehicle.
Misrouting of turbocharger oil feed pipe could allow pipe to contact the positive battery cable connecting stud on the starter motor.
Tire size data on certification label IS incorrect.
Front lower suspension arm forks could deform after substantial impacts, such as in an accident.
Front wheel bearing adjusting nut retaining keys may be missing from front axle assemblies, allowing the nut to loosen.
Due to improper seating, there could be a clearance between the wear washer and axle lug, or between the wear washer and the inner race of the bearing.
The loop on the end of the shoulder strap IS only glued together, rather than glued and sewn.
Inadequate heat shield above catalytic converter could overheat.
Under certain circumstances, the tv monitors may fall from their receptacles.
Under certain conditions, a reverse current might flow through a wire cable between the air recirculation switch and a microswitch.
Tires may develop a flex break in the lower sidewall prior to completing the required fmvss 109 endurance compliance testing.
The composition of certain non-genuine replacement preheat tubes can cause combustion.
Fails to meet requirement of fmvss 119, dot symbol not shown.
Short circuits may occur in the eyebrow panel which IS located in the front of the refrigerator.
Switches may not actuate the service reservoir low pressure warning buzzers and lights at pressures below 60 pounds per square inch. Consequence of defect: driver would not be warned of air brake system low pressure and loss of brake…
If cruise control main switch IS in the on position when engine IS started, system can be affected by a short duration voltage drop caused by optional hi-power (H340) radio.
If front wheel hits a bump during hard braking, vibration can overload the compression bar of the front brake assembly.
The single strap slide that IS positioned on the right and left side of the upper harness may slip.
A small nylon bushing in the cruise control servo bail may slip out of place, causing intermittent and unexpected increases in engine speed or dieseling (engine run on with ignition off).
A secondary heat shield collar may have been omitted from the furnace exhaust tube.
The accelerator pedal stopper may be bent when excessive downward force IS applied after pedal has contacted the stopper.
External cracks above the number 3 cylinder (1984 models) or rocker arm cover gaskets splitting (1985 models) could allow oil to leak onto the exhaust manifold.