Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
Seat belts may not have beein installed for all designated seating positions.
Incorrect lug bolts may have been used in the manufacturing of the spare wheel carrier. These lug bolts may break allowing the spare wheel to fall off. consequence of defect: breakage of the lug bolts allowing the spare wheel to fall to…
Incorrect size ear type clamps were used to secure nylon gasoline lines to barbed connector fittings.
There may be an inadequate number of emergency exits on the left side of the bus.
Support tab in front side of jack stand may be inadequately welded or the metal tab may require heavier gauge steel.
Glass element that separates electronic circuitry from pressurized fuel may loosen and create an opening that could allow pressurized fuel to enter body of sensor.
With approximately two threads engagement of steering wheel retaining nut with steering shaft, the steering wheel could separate from the steering column if nut loosens and falls off.
The emergency roof exit release mechanism was installed in an incorrect direction; operating instructions for the roof exit are not concise; and instructions for exit are incorrect.
There IS an inadequate number of emergency exits on the right side of the the bus; driver's door emergency exit label and instructions are not properly located. Window emergency exit instructions are not legible.
Fuel return hoses may break at either crimped coupling, causing a leakage of fuel.
Incorrect screws may have been used in installing the load sensing brake proportioning valve to its bracket causing the clamping load to be less than intended.
Loss of retention of an integral over-travel spring on throttle cable could cause spring dislocation.
Red reflectors tested did not meet minimum of 4.5 candle power per foot candle by as much as 92 percent.
The second row right hand seat assembly has a tilt forward function. A latch retains the seat in the normal ride postion, and this latch may release under severe frontal impact conditions, allowing the seat to pivot forward.
Fuel tank mounting straps may allow minor amount of shifting by fuel tank in a rear end crash with fuel leakage in excess of amount allowed by standard.
Omission of air ducts intended to guide flow of cooling air to left and right front brake calipers could allow brake fluid to exceed allowable operating temperature under certain operating conditions.
Power steering hoses may leak fluid that can spread to the exhaust manifold.
Miswired ground fault interrupter (gfi) receptacle in bathroom does not provide ground fault protection at that receptacle.
Capscrew that attaches steering gear to the steering bracket may loosen and cause the gear to separate from its supporting bracket.
Capscrew that attaches steering gear to the steering bracket may loosen and cause the gear to separate from its supporting bracket.
Incorrect torque on the governor input assembly could cause it to loosen and back out, interfering with the governor housing operation. Also the torsion spring on the accelerator input was installed incorrectly and could dislodge…
Window tint does not meet luminous transmittance requirements of fmvss 205.
Gross vehicle weight ratings and tire information may be incorrect on labels.
Tire placard may contain incorrect gross vehicle weight ratings and tire information.
Vehicle description: stretch limousines altered by kelly/coachworks, inc. limousine may not have alterers tire placard with correct tire size and load information, as required by fmvss 110.
Vehicle description: stretch limousines altered by kelly/coachworks. limousines may not contain alterers certification label in violation of 49 cfr part 567.
Due to overpressurized fuel system and closed emissions control system, there may be excessive hydrocarbon ignition in exhaust stage of engine operation.
A thread engagement problem may cause fuel leakage.
These replacement lamps may not meet lighting requirement of fmvss 108.
These lamps fail to meet the lighting requirements of fmvss 108.