Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
The console mounted shift lever may disengage from the shift control cable bracket causing loss of gear indicator reference and shift selector operation.
The right front brake hose may rub against the tire during a full lock left turn, which may eventually cause wear through of the brake hose on the right front side.
The parking brake may not exert sufficient force to enable the vehicle to conform to the grade holding requirements of fmvss 121.
The electronically controlled motor pump power steering system may malfunction, causing intermittent loss of power steering assist and requiring varying degrees of increased steering effort.
The black plastic push pins used to attach the pads to seat structure can be removed by children.
A washer in the cargo area light may not be properly attached, and may have fallen in the cargo light during assembly. If this occurred, and the three position light switch IS in the middle position, and the tailgate IS open, the washer…
The fan blade or the fan shroud can fracture due to insufficient fore and aft clearance in the lower area of the fan shroud.
The windows do not meet the retention requirements of fmvss 217. The exit catch pulled loose before the window broke.
The rear tandem axle brakes do not meet the service brake application time requirements of fmvss 121.
When the automatic transmission shift lever IS placed in the park position, the park pawl does not always abut or engage the park gear.
When the automatic transmission shift lever IS placed in the park position, the park pawl does not always abut or engage the park gear.
The bottom cushion of the child safety seat failed to meet the flammability requirements of fmvss 213.
The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
The directions for threading the shoulder straps through the metal retention slides are unclear.
The incomplete vehicle document required by 49 cfr 568.4 has incorrect information concerning gvwr, front gawr, and tire pressures.
Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it IS closed.
These vehicles have front axles with brake cam operation opposite to the rotation of the brake drum (cam opposite), and there IS a tendency for brakes to chatter under low air pressure, resulting in vibrations. The vibrations induce…
The spring brake units can fail to release from the parking or applied position due to a misalignment between the spring plate and the spring housing. The condition can be either intermittent or permanent.
The left and right seat safety belt assemblies are not interchangeable. Some left seat safety belt assemblies were installed on the the right side of the car.
The stone bennett shifters do not indicate the relative position of the shift lever to the driver.
A misadjustment of the park lock cable in the column shift assembly makes it possible for the steering column to lock while the vehicle IS in motion and the ignition switch IS in the off position.
A misadjusted transmission cable can allow the engine to be started while the transmission IS in a forward or reverse drive gear.
The passenger's side easy-entry seat adjuster may fail fully lock into position after the seat back has been tilted forward and the seat slid forward, then returned to its original postition.
The cooking range and the furnace are located next to each other in the motorhome. When the furnace IS in operation, it can draw air over the range top, causing a downdraft onto the range top.
Reservoir interior paint was allowed to enter the air reservoir check valve, and the valve IS not properly seated.
The hook size of the throttle return spring IS too small resulting in a tight fit around the anchor nut, causing the throttle return spring to break prematurely.
An unauthorized and unnamed material was introduced into the truck tire base stock, and tires were built and cured with the miscompounded truck tread base material.
A hydraulic fluid leak may develop in the webster hydraulic pump.
A hydraulic leak may develop in the webster cooling fan.
The rear emergency door exit identification and the operating instructions may not be installed.