Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
Vehicle description: trucks assembled with skf level 2 truck hub units (thu) received from meritor. these hubs can fatigue crack.
Vehicle description: sport utility vehicles. the left side and right side instrument panel wiring ground attachment screws could loosen over time.
Vehicle description: MINI vans built for fleet sales only. the headlamp module does not identify the park lamp as "drl" as requirement of fmvss 108, "lamps, reflective devices, and associated equipment."
Vehicle description: pickup trucks equipped with manual transmission, V10 engines and four-wheel-drive transfer cases. under sustained maximum rated vehicle load, while driving up a steep grade in four-wheel-drive low range in hot…
Vehicle description: passenger vehicles. the front suspension lower control arms may have been inadequately welded between the pivot tube and the arm.
Vehicle description: MINI vans. the wiring that initiates the driver and/or passenger air bag could electrically short circuit to ground. a short circuit to ground that exists immediately after turning the ignition key to the "on" or…
Vehicle description: heavy duty trucks equipped with hydraulic brakes. the hydraulic brake tube to the front left brake can contact the bottom frame rail flange.
Vehicle description: motor home chassis. these vehicles do not comply with the dash light intensity requirement of fmvss no. 101, "controls and displays."
Vehicle description: passenger vehicles. moisture can enter the air bag inflatable restraint electronic control module (ecm) and cause corrosion on portions of the ecm printer circuit boards.
Vehicle description: motorcycles. These motorcycles were built with a rear shock absorber front eye that could break.
Vehicle description: motorcycles. these motorcycles were built with a swingarm that could break.
Vehicle description: motorcycles. these motorcycles were built with a fuel tank vent valve assembly that could become plugged.
Vehicle description: motorcycles. these motorcycles were built with a fuel tank mount system that could, in the event of a crash, allow the fuel tank to separate from the motorcycle.
This IS not a safety recall in accordance with the safety act. however, it IS deemed a safety improvement campaign by the agency. vehicle description: passenger vehicles. if the convertible top cover IS not installed correctly, it…
Vehicle description: heavy duty trucks equipped with dual steering. the steering column welds on these vehicles can fracture, allowing the steering column to separate.
Vehicle description: passenger vehicles. the terminals at the headlight switch and wiring harness connector can experience heat damage as a result of overheating.
Equipment description: aluminum light truck rims. these rims fail to comply with the marking requirements of fmvss no. 120, "tire selection and rims for motor vehicles other than passenger cars."
Equipment description: aluminum light truck rims. these rims fail to comply with the marking requirements of fmvss no. 120, "tire selection and rims for motor vehicles other than passenger cars."
Vehicle description: heavy duty trucks equipped with dana/sprague windshield wiper assemblies. the knurled pivot shaft (which operates the windshield wiper arm) IS welded to a lever, which connects to linkage from the wiper motor. the…
Vehicle description: folding trailers. improper tire clearance (less than 5/8") between the wheel and front frame cross member can result in the tire rubbing the metal frame.
Vehicle description: passenger vehicles. it IS possible that the retaining clip that secures the brake booster pushrod to the brake pedal arm was not properly installed during production. it IS possible for the clip to detach from the…
Equipment description: forged aluminum bus wheels, size 22.5" x 8.25", part no. 883613, and shipped to oems. these wheels are below design specifications and internal requirements which can cause the unsupported open end of the wheel to…
Vehicle description: sport utility vehicles equipped with four-wheel-drive (4X4), 17" chrome steel wheels. the clamp load can be lost on the wheel lugs due to insufficient wheel contact area with the hub. in some cases, the contact…
Vehicle description: bumper-pull horse trailers. the safety cables, used to maintain a connection between the trailer and tow vehicle, are not equipped with thimbles and thus do not conform to sae J684.
Vehicle description: motorcycles. these motorcycles were built with a sidestand switch that could become inoperative
Vehicle description: motorcycles. the rear brake line can chafe, resulting in loss of brake fluid.
Vehicle description: motorcycles. motion of the battery cable can lead to breakage of its terminal.
Vehicle description: all wheel drive passenger minivans. (This includes all 1992 AWD aerostars not previously included in safety recall 97v-204/97s83). These vehicles can develop powertrain bending resonance or transfer case output shaft…
Vehicle description: sport utility vehicles equipped with 4-wheel drive and automatic transmissions. automatic transmission fluid could be vented onto the hot exhaust system as a result of unanticipated heat generation in the…
Vehicle description: pickup trucks equipped with 6" beds manufactured from january 5, 1998 through june 4, 1999, do not not fully satisfy the post crash test static rollover requirements of fmvss no. 301, "fuel system integrity."…