2017 Alfa Romeo 4C Spider

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 10236933wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
• 10234468Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates. NOTE: **Verify current warranty policy to determine if digital imaging pre authorization is required or Pre Approval is required from Regional Office depending on market.** This bulletin involves inspecting and if necessary removing corrosion and refinishing the suspect aluminum panels on the vehicle, hood, door, fenders, hinges, swing gates or liftgate panels.
• 10234420Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
• 10230183No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration
• 10230180Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle.
• 10229810Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates. NOTE: Digital imaging pre authorization is required for Smart Warranty Base dealers or Pre Approval is required from Regional Office depending on market. This bulletin involves inspecting and if necessary removing corrosion and refinishing the suspect aluminum panels on the vehicle, hood, door, fenders, hinges, swing gates or liftgate panels.
• 10229572Approved Use of Weld Through Primers This bulletin documents the FCA US LLC position regarding the use of weld through primer when using Squeeze Type Resistance Spot Welding (STRSW) and Gas Metal Arc Welding (GMAW) processes when welding steel body panels and structural components.
• 10229041Battery Drain Concern, Dual USB Port Normal Operational Draw, Extended Illumination Or Extended Operation After Key Off
• 10227983If a Mopar oil filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils.
• 10225424Approved Use of Weld Through Primers This bulletin documents the FCA US LLC position regarding the use of weld through primer when using Squeeze Type Resistance Spot Welding (STRSW) and Gas Metal Arc Welding (GMAW) processes when welding steel body panels and structural components.
• 10225287Approved Use of Weld Through Primers This bulletin documents the FCA US LLC position regarding the use of weld through primer when using Squeeze Type Resistance Spot Welding (STRSW) and Gas Metal Arc Welding (GMAW) processes when welding steel body panels and structural components.
• 10224927Flash: Body Control Module (BCM) Diagnostic and System Improvements This bulletin involves reprogramming the BCM with the latest available software. Customers may experience one or more of the following:When ?Race Mode? is selected and during high-performance driving (i.e. track usage), the fuel gauge does not accurately report the actual fuel level as the tank approaches empty. The Forward Collision Warning (FCW) system may be disabled intermittently. The last bar on the fuel gauge will not turn off, even if the fuel tank is empty. If the battery state of charge drops below 75%, the rear defrost will turn off after 15 minutes.
• 10224758No Communication with Chassis Domain Control Module (CDCM) This bulletin involves replacing the CDCM, if required. Some customers may notice the odometer is flashing. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC) has been set:U1A07-87-CDCM (Chassis Domain Control Module) - Missing Message.
• 10224752Broken Glove Box Door Handle This bulletin involves replacing the glove box door. Some customers may notice that the glove box door handle is broken.
• 10224751Odor Coming from Engine Compartment This bulletin involves replacing the cowl seal gasket and sealing off the two ventholes in the hood. Customers may notice a smell in the passenger compartment while operating the vehicle in traffic conditions (Stop and Start, 2nd and 3rd gear,parking maneuvers).
• 10224724Radio Software Enhancements This bulletin involves reprogramming the radio with the latest available software.The customer should be informed that after the reprogram, the radio will need to have the phones paired to the Entertainment Telematics Module (ETM). The operative details for pairing telephones and settings are shown in the Owner Handbook of the infotainmentmodule. Some customers may experience one or more of the following:Navigation takes too long to recover after losing satellite signal. Certain Android phones have reduced Bluetooth functionality. Display is stuck on black screen. Display frozen on Alfa Romeo logo. Radio intermittently reboots. Oil level displayed on the ETM is incorrect. Auto-play does not maintain ?ON? status after the network goes to sleep. Park Assist Module (PAM) graphics stayed on screen even after dismissing via Rotary Pad. Lane Departure menu option available in a vehicle without the lane departure warning option. In addition, the following improvements are included:Radio station preset bar updated to include seven presets and a shortcut to the rest of the presets. Radio menu updated to show frequency, stations names, and favorite numbers. Remove kilohertz (KHz) and megahertz (MHz) and show frequency in figures. Show three alternative navigation routes, instead of just one. Reduce Point Of Interest (POI) categories and show address, phone number, and direction. Improve location input for navigation routing. The zoom feature on navigation map can be accessed without changing menus. When using navigation guidance, more details will be given on the next turn, exit number, street name, and complete address. Numbers are larger on the touch screen when dialing. Improved speech for navigation. Maps update. Update to Bluetooth device compatibility. On Menu, the "Apps" icon will be changed to ?Car" icon. Show phone info instead of phone repetition. Show navigation info instead of navigation repetition.
• 10224722Audio System Warning Light Illuminated This bulletin involves checking and installing a protective cover on the amplifier. The customer may describe that the when the audio system warning light is illuminated the radio will turn on but with no audio sound.Upon further investigation the technician may find that the following Diagnostic Trouble Codes (DTCs) have been set:U1746-87 - AMP (Amplifier Module)-Missing Message. B10AA-4A - Check Configuration Failed-Incorrect Component Installed. U197C-83 - Message Transm2 Plausibility Error-Value Of Signal Protection Calculation Incorrect. U0186-31 - Lost Communication With Audio Amplifier - No Signal.
• 10223855Washer Fluid Level Sensor Prior to replacing this part due to "Low Washer Fluid" tell tale light on the dash and the washer fluid bottle is full, please perform the this inspection. Inspect the sensor for a fluid coating on the sensor pins. Orange colored rain repellant can cause this fluid build-up. Clean the pins, drain the reservoir, and fill with Mopar approved washer fluid. Check to determine if the issue has been resolved. Continue with repair if necessary. Also, please inform the customer not to use Rain-X in the system to avoid this issue. Please contact Chuck Hood at cell (248) 613-7591 if you have questions or need additional information. Thank you.
• 10223559Blind Spot Or Park Assist Warnings, False Activation
• 10223079Battery Drain Concern, Dual USB Port Normal Operational Draw, Extended Illumination Or Extended Operation After Key Off
• 10221787USB PORT, Media Hub For Android Auto and Apple Carplay issues, do not replace this part. Android Auto and Apple Carplay applications may not operate with the vehicle if an aftermarket cable is being used. Verify the functionality of these applications using an OEM Apple Lightning cable or an OEM provided USB cable for Android phones before performing any additional troubleshooting. For questions regarding Android Auto or Apply Carplay functionality, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
• 10221597No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration
• 10221594Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle.
• 10221277Customer Complaint May Include Engine Oil Leak Or Consumption
• 10221228WIRING, Body Before replacing this harness, please contact FCA Redacted Content to see if a repair kit is available for your application. If no response in 15 minutes, proceed with repair. Please email pictures of harness defects to FCA Redacted Content
• 10221153Battery Tester Warranty Code Procedures, Midtronics Charger Update Process
• 10221152Battery Tester Warranty Code Procedures, Medtronic Update Process
• 10221150Gear Ratio DTC?s, Transmission Shift Concerns, Does Not Shift At Times, Shudders
• 10221097Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.
• 10220697Battery Drain Concern, Dual USB Port Normal Operational Draw, Extended Illumination Or Extended Operation After Key Off
• 10220101Use of Aftermarket Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of aftermarket parts.
• 10220099Use of Salvage/Recycled Parts This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the use of recycled or salvage parts.
• 10220098Authentic Mopar Glass Replacement This bulletin involves discussing FCA US LLC position with regard to collision repair industry awareness regarding the recommended usage of Authentic Mopar Glass.
• 10220097Repair Parts Used For Structural Repairs This bulletin involves discussing FCA US LLC position with regard to structural repair parts usage.
• 10220071wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
• 10219880Flash: Powertrain Diagnostic and System Improvements This bulletin involves reprogramming the Engine Control Module (ECM), also known as a Powertrain Control Module (PCM) with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following DTCs have been set:P0455-00 - Evaporative Emission System Leak Detected (Large Leak). P0087 - Fuel Rail Pressure Too Low - Bank 1. P2172 - Throttle Actuator Control System - Sudden High Air Flow Detected. P0171 - System Too Lean Bank 1. P0236 - Turbocharger/Supercharger Boost Pressure Sensor Performance. P0363 - Misfire Detected - Fueling Disabled. P1CEA - Boost Side EVAP Purge System Performance. P250B - Engine Oil Level Sensor Circuit Performance. P0139 - O2 Sensor Circuit Slow Response Bank 1 Sensor 2. P015A - O2 Sensor Delayed Response - Rich To Lean Bank 1 Sensor 1. P0440 - Evaporative Emission System Incorrect Flow. P0441 - Evaporative Emission System Incorrect Purge Flow. P0002 - Fuel Quantity Regulator 1 Control Circuit Performance. P0244 - Turbocharger/Supercharger Wastegate Solenoid ?A? Range/Performance. P062A - Fuel Pump ?A? Control Circuit Range/Performance. P0128 - Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature). P0514 - Battery Monitor Module Temperature Monitoring Performance. P2AC0 - Intake Air O2 Sensor Reference Voltage Circuit Range/Performance Bank 1. P0402 - Exhaust Gas Recirculation ?A? Flow Excessive Detected. P2B89 - Intake Air O2 Sensor Circuit Low Voltage. P0456 - Evaporative Emission System Leak Detected (Very Small Leak). In addition, customers may experience the following condition:Stall upon restart after refueling.
• 10219866RAN / RAP Radio Enhancement This bulletin involves reprogramming the radio with the latest available software.The customer should be informed that after the reprogram the radio will need to have the phones paired to the Entertainment Telematics Module (ETM). The operative details for pairing telephones and settings are shown in the Owner Handbook of the infotainmentmodule. Some customers may experience one or more of the following:Display is stuck on black screen. Display frozen on Alfa Romeo logo. Radio intermittently reboots. Oil level displayed on the ETM is incorrect. Auto-play does not maintain ?ON? status after the network goes to sleep. Park Assist Module (PAM) graphics stayed on screen even after dismissing via rotary. Improved speech for navigation. Loss of favorite contacts. Lane Departure menu option available in a vehicle without the lane departure warning option. In addition, the following improvements are included:Maps update. Update to Blutooth device compatibility. On Menu, the "Apps" icon will be changed to ?Car" icon. Show phone info instead of phone repetition. Show navigation info instead of navigation repetition. Show audio info instead of audio repetition. Optional routes like Google maps. When changing tracks the album art does not change to match the current song/track.
• 10219841Restraints Information Sheet (I-Sheet) has been added to Star Parts. Print I-Sheet for technician use.
• 10219831Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
• 10219830Washer Fluid Level Sensor Prior to replacing this part due to "Low Washer Fluid" tell tale light on the dash and the washer fluid bottle is full, please perform this inspection: Check if float sensor is rotated off location from the bottle anti-rotation features that surround the SENSOR. Check to determine if the issue has been resolved. Continue with repair if necessary. Please contact Chris Koch at cell (248) 248-622-6417 if you have questions or need additional information.

Every Alfa Romeo 4C Spider model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.