2019 Altec ST Spray Truck
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Altec › ST Spray Truck › 2019
These records cover every 2019 Altec ST Spray Truck. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
1 recall names the 2019 Altec ST Spray Truck. Newest first.
Altec Industries Inc. (Altec) is recalling certain 2017-2020 ST Spray Trucks. The battery fuse holder may have been improperly mounted, potentially causing an electrical short circuit.
Risk and remedy
Risk
An electrical short circuit can increase the risk of a fire.
Remedy
Altec will notify owners and will install a new battery fuse holder, free of charge. The recall is expected to begin June 16, 2020. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 758.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10200511Altec has discovered that certain ST550/720/750/900 units built from January 2018 to December 2019 could have incorrect, damaged, or loose fasteners attaching the pressure regulator to its support bracket. Any of these conditions could lead to damage of the primary tank that the pressure regulator bracket is attached to. Altec requires the pressure regulator fasteners to be inspected on the affected units no later than the next scheduled service interval. This inspection can be completed by a customer in less than 15 minutes. If the inspection criteria are not met, order the Pressure Regulator Fastener Kit. Install the kit within 90 days of receipt. This inspection and repair are covered under the Altec Warranty Policy and can be performed by Altec, the customer, or the customers warranty provider. Altec will perform the work for free at an Altec facility.
- 10200318Altec has discovered that certain ST500 and ST600 units built from July 2017 to October 2019 do not have a load rating placard on the outer tubes of the hitch. Overloading the tubes could damage the bumper and/or hitch. Altec requires a placard kit to be installed on each affected unit within 90 days of receipt of this SIL. The placard kit required depends on the unit model. Install the kit upon receipt. This installation is covered under the Altec Warranty Policy and can be performed by Altec, the customer, or the customers warranty provider. Altec will perform the work for free at an Altec facility. If the customer or the customers warranty provider performs the installation, a warranty claim must be submitted to be reimbursed for the cost of the parts and/or labor.
- 10186517The receiver hitch capacity and warning placards were not installed on the affected units. Use of the hitch at loads higher than the design ratings due to the lack of these placards can overload the receiver tube, resulting in damage to the receiver tube and/or the bumper. The Receiver Hitch Placards Kit is included with the SIL. Altec requires this kit to be installed by the next preventive maintenance interval.
Every Altec ST Spray Truck model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.