1978 Autocar RB2
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Autocar › RB2 › 1978
These records cover every 1978 Autocar RB2. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
5 recalls name the 1978 Autocar RB2. Newest first.
Some of the involved vehicles were not inspected for adequate clearance between the steering shaft and its firewall opening. Inadequate clearance could result in the steering column becoming scored or severed by the firewall sheet metal.
Risk and remedy
Remedy
Dealer will inspect vehicles and, if necessary, enlarge the firewall opening to provide the minimum 3/8 inch clearance for the steering shaft. Any scored or cut shafts will be replaced without charge to owner.
Lockwashers, used to retain the engine"s fan mounting bolts, may have been omitted during assembly, causing the bolts to loosen and allowing the fan to separate from its mounting hub.
The metal stiffener at the rear of the splash shield may become bent during servicing or by abuse. This can allow the splash shield and stiffener or one of its attaching bolts to rub against and cut the steering shaft.
Risk and remedy
Remedy
The splash shield stiffener will be removed and the steering shaft will be replaced, if damaged.
The windshield wiper may over-travel its designed sweep angle during its initial stroke with the possibility of temporary wiper immobilization.
Risk and remedy
Remedy
Dealer will install a restriction fitting in the control valve at no cost to owner.
The hose clamp, which was installed around the steering column boot seat to keep noise and dirt from entering the cab, may loosen.
Every Autocar RB2 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.