2024 Bentley Redundant Bentayga

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 11011583DTC P096C00 and / or P096F00 evident within the Engine Control Module. Customer statement: Engine warning light illuminated within the DIP Workshop findings: One or a combination of the following DTCs are evident within the Engine Control Module (ECM) P096C00 Transmission coolant valve electrical malfunction And / or P096F00 Transmission coolant valve short circuit to ground
• 11011515High pitched whistle from the engine - Warning light within the DIP - Engine not running smoothly - Numerous DTC's. Customer statement/Workshop findings Emission control warning light evident within the DIP Engine not running/idling smoothly High pitched whistle from the right and left hand side of the engine TIP: Refer to video within the Bentley Hub referencing TPI 2075922/- A selection of DTCs are evident (as per TPI Event memory entries)
• 11010204Black 'S' Front door badge missing from Black Edition specification vehicles (SC24/30).
• 11009729Front door clash condition with the rear door brightware or clash between the front and rear door brightware. Customer statement / workshop findings: The front door inner panel hem is clashing with the rear door lower brightware during the closing operation of the front door or, The rear door lower brightware is clashing with the front door brightware
• 11009724Rear lid or boot - Water ingress diagnosis. Customer statement: Water ingress within the rear lid Water dripping from the rear lid Water ingress is evident within the boot Water in some isolated cases may be heard moving/sloshing from the inside of the rear lid
• 11009723Noises from Panoramic sun roof.
• 11009717Front windscreen - Water ingress - Left or right hand side Or water ingress from the top of the front windscreen. Customer statement / workshop findings: Water ingress into the cabin (Front windscreen)
• 11009715Keyless entry system (KESSY) function was found to be disabled when the vehicle was parked for a short duration of time. Customer statement / workshop findings: Keyless entry system (KESSY) function is disabled when the vehicle is parked for a short duration of time Technical background: The reported symptom is due to the Battery management shut off stages being too early due to the battery size being incorrectly entered on replacement
• 11009616Loading system message in the Infotainment screen (screen stuck). Customer statement / workshop findings: The Infotainment system is stuck on the loading screen Loading system, please wait message is visible on the Infotainment screen
• 11009579Measured values - Cycle recording instructions. Technical background The instructions within the Measure section of this TPI have been generated to guide operatives through the process for recording Measured values in cycles by using self diagnosis, the Instructions also detail how to locate corresponding files which are required for analysis.
• 11009451DTC P057300: Brake Switch "A" Circuit High evident within the ECM(s) - Various warnings evident within the DIP. Customer statement / workshop findings: The following symptoms may be evident (depending on Model Year) 23 Model Year: Drive system warning / safeguard warning in the DIP DTC P057300: Brake Switch "A" Circuit High evident within the Engine Control Module(s) 24 Model Year: Engine warning light evident within the DIP along with Drive system warning / safeguard warning in the DIP DTC P057300: Brake Switch "A" Circuit High evident within the Engine Control Module(s)
• 11008718Engine light in the DIP - Various oxygen sensor / Fuel ratio DTCs logged within the Engine Control Module(s). Customer statement / workshop findings: Engine light in the DIP - Various oxygen sensor / Fuel ratio DTCs logged within the Engine Control Module(s).
• 11008716Engine light in the DIP - Various Camshaft adjuster DTCs logged within the Engine Control Module(s). Customer statement / workshop findings: Engine light in the DIP - Various Camshaft adjuster DTCs logged within the Engine Control Module(s).
• 11008402Rattle / vibration noise from the dashboard (Drivers side) - Head Up Display (HUD) trim panel. Customer statement / workshop findings: Rattle / vibration noise from the dashboard (Drivers side) - Head Up Display (HUD) trim panel.
• 11008369Issues with mobile phone wireless charging - Wireless charging does not work. The customer complains that the mobile device sometimes cannot be charged wirelessly.
• 11008228Options to move the passenger front seat to business, VIP and relaxed are greyed out (Not available in TSR) Customer statement / workshop findings The options to move the passenger front seat to VIP - BUISNESS and RELAXED are greyed out in the TSR, pressing states the function is not available.
• 11008227Lower and/or upper front suspension lever bushes - Warranty replacement guidelines.
• 11008224Driver / Passenger door(s) creak on close - All models (front and / or rear).
• 11007605Options to move the passenger front seat to business, VIP and relaxed are greyed out (Not available in TSR). Customer statement / workshop findings: The options to move the passenger front seat to VIP - BUISNESS and RELAXED are greyed out in the TSR, pressing states the function is not available
• 11007604EPB Warning light in DIP - Front door/s power latch system intermittent - DTC U112300 within Address 03 and Address 46. Technical background: The micro switch signal of the door lock is not recognised or is recognised briefly, a counter press of the door by the operative is required to clearly recognise the signal Insufficient back pressure of door (door closing loads / seal load) results in the pawl microswitch signal becoming too short. This short signal is then calculated as an error state by address 0003 -Brake electronics.
• 11007603Issues with wireless charging/wireless charging does not work. Customer statement / workshop findings: The customer complains that the mobile device sometimes cannot be charged wirelessly. One of the following three situations is described: The phone gets very hot while charging and charging is cancelled. The phone is not charged and the following message is shown on the MMI: The device cannot be charged as there is another object in the charging cradle. The phone does not start charging after it has been placed in the charging cradle. The phone or individual processes are switched off to protect the phone as a result of heat generation. The mobile device supports wireless charging or the customer uses a charging cover that enables wireless charging
• 11007601Passenger door control unit replacement (SC24/18). Technical background: Customer experiences 12V battery completely flat. This is caused due to headlight fans which are turning on after the car has been locked. Chip Mismatch during production of PCBs of passenger door CU is keeping the BUS awake and headlight fans being on and draining 12V battery.
• 11007599Software update to 0042 / 07D2 (Driver door control module) and 0052 / 07D3 (Passenger door control module) - SC24/16. Technical background: The rear door strikers require checking for correct alignment and adjustment (if required)
• 11007588Creaking/squeak noise from the front suspension (upper inner lever bushes).
• 11007426Fatigue warning is not visible within the Infotainment screen menu after the Data bus control unit replaced (SC24/20) Technical background: When initialising and calibrating the replacement Data bus control unit (J533) one of the adaption channels may not have been written correctly. As a result, the menu entry for the fatigue warning in the Infotainment screen is missing
• 11007161Passenger door control unit replacement (SC24/18). Technical background: Customer experiences 12V battery completely flat. This is caused due to headlight fans which are turning on after the car has been locked. Chip Mismatch during production of PCBs of passenger door CU is keeping the BUS awake and headlight fans being on and draining 12V battery.
• 11007157Fatigue warning is not visible within the Infotainment screen menu after the Data bus control unit (J533) was replaced.
• 11007152Calendar function - No longer available. Technical background: The Calendar service is no longer available as the service has been deactivated for technical reasons; this applies to all vehicles. The possibility of reactivating it is currently being evaluated
• 11006105Bentayga rear brake noise/squeal - Repair method depending on the brake noise frequency (Iron brakes only). Scenario 1 Vibration of 1.2 to 1.4 KHz is produced from the rear brakes whilst braking at low speed Whilst braking at low speed, a vibration of 1.2 to 1.4 KHz or 5 KHz can be produced from friction between the rear brake pad and disc resulting in rear brake noise/squeal Scenario 2 Vibration of 3.4 KHz is produced from the rear brakes While braking at low speed a vibration of 3.4 KHz can be produced during brake application at low speed resulting in rear brake noise/squeal Scenario 3 Vibration of 5 KHz is produced from the rear brakes whilst braking at low speed Whilst braking at low speed, a vibration of 5 KHz can be produced from friction between the rear brake pad and disc resulting in rear brake noise/squeal.
• 11003660DTC P0B2500 logged within address 0021 (Battery Energy Control Module 2) - Dynamic ride system warning visible. Customer statement: Bentley dynamic ride system fault is displayed within the Drivers Instrument Panel (DIP) Workshop findings: DTC P0B2500 - Hybrid/EV Battery "A" Voltage low is stored within address 21- Battery Energy Control Module 2 Technical background: Possible internal fault with the super capacitor
• 11003655Software update to 0042 / 07D2 (Driver door control module) and 0052 / 07D3 (Passenger door control module) - SC24/16. Technical background: The rear door strikers require checking for correct alignment and adjustment (if required) Software updates must also be applied to following control modules on vehicles which are specified with the power door function: Driver door control module (Diagnostic address 0042 / 07D2) And Passenger door control module (Diagnostic address 0052 / 07D3)
• 11003191DTC P0B2500 logged within address 0021 (Battery Energy Control Module 2) - Dynamic ride system warning visible. Customer statement / workshop findings Customer statement: Bentley dynamic ride system fault is displayed within the Drivers Instrument Panel (DIP) Workshop findings: DTC P0B2500 - Hybrid/EV Battery "A" Voltage low is stored within address 21- Battery Energy Control Module 2 Technical background: Possible internal fault with the super capacitor
• 11000747Fatigue warning is not visible within the Infotainment screen menu after the Data bus control unit (J533) was replaced. Customer statement / workshop findings Fatigue warning is not visible (Figure 1) within the Infotainment screen menu after replacement of the Data bus control unit (J533).
• 11000693Unintended sounding of the Alarm siren - Following activation of the ignition or whilst the vehicle is left standing. Workshop findings The following DTCs could also be evident within diagnostic address 0046 and/or 00BB and/or 00BC B131DF5: alarm system siren supply voltage lower limit value less than B131D29: sirens / alarm horn for anti-theft warning system Range/Performance B131D29: anti-theft alarm system siren / alarm horn signal, not valid