2004 Bigdog Bulldog
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Bigdog › Bulldog › 2004
These records cover every 2004 Bigdog Bulldog. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
5 recalls name the 2004 Bigdog Bulldog. Newest first.
Big dog IS recalling certain 2004 chopper, bulldog, ridgeback, mastiff, boxer, and pitbull motorcycles. there IS a possible loose connection between the harness connector and the electronic harness controller.
Risk and remedy
Risk
This condition may cause the motorcycle to experience intermittent loss of electrical power to various components, which can lead to, among other things, a loss of headlamp function or a vehicle stall, increasing the risk of a crash.
Remedy
Big dog will notify owners and dealers will repair the motorcycles free of charge. the safety recall began on may 24, 2010. owners may contact big dog at 1-316-219-9121.
On certain motorcycles, the kickstand spring may stretch and detach from the mounting bracket or the kickstand.
Risk and remedy
Risk
This will allow the kickstand to deploy into the extended position and cause a crash.
Remedy
Dealers will install a new kickstand spring free of charge. the recall began on february 17, 2006. owners may contact big dog at 316-267-9121.
On certain motorcycles, the kickstand spring attaching stud may break off allowing the kickstand to deploy into the extended position.
Risk and remedy
Risk
If the kickstand deploys, it could cause a crash without prior warning.
Remedy
Dealers will inspect and install a new kickstand unit. the recall began on december 20, 2004. owners should contact big dog at 316-267-9121.
On certain motorcycles, a screw may become loose in the handlebar control due to the lack of a lock washer and loctite.
Risk and remedy
Risk
This could cause the throttle or front brake control to bind, which could result in a crash.
Remedy
Dealers will install a lock washer and loctite. Owner notification began on april 12, 2004. owners should contact big dog at 1-316-219-7006.
On certain motorcycles, the piston in the rear master cylinder may have been improperly sized, which could cause the rear brakes to drag or lockup.
Risk and remedy
Risk
This could result in a crash.
Remedy
Dealers will remove the piston from the rear master cylinder and replace it with a new piston. Owner notification began on april 12, 2004. owners should contact big dog at 1-316-267-9121.
Defect investigations
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
- Motorcycle Stalling
This RQ was opened based on seemingly related owner complaints involving motorcycles outside the scope of 06V-301.During the course of subsequent discussions with the company, we learned that the earlier model year Big Dogs had a problem with the electronic harness control module connector that they'd previously…
This RQ was opened based on seemingly related owner complaints involving motorcycles outside the scope of 06V-301.During the course of subsequent discussions with the company, we learned that the earlier model year Big Dogs had a problem with the electronic harness control module connector that they'd previously addressed with a TSB.Since the TSB addressed a safety-related issue (stalling), Big Dog agreed to recall the motorcycles subject to the TSB (10V-180).With that decision, ODI agreed to waive requiring a response to its information request and is now closing this RQ.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10026832Bigdog motorcycle: fuel tank vent may become flooded with fuel, causing the motorcycle to run poorly due to a fuel mixture that IS too rich.
- 10020152Horn harness wires may break.
- 10020065Headlamp connector may melt, making bulb replacement difficult.
- 10020045Ehc contact improvement procedure (revised). Current seal does not allow connector pins to seat properly and moisture may be present in connector.
- 10019984Tachometer board replacement - inaccurate tachometer readings or fluctuation in readings due to moisture.
- 10019909Dielectric grease addition to connectors.
- 10010470Ehc replacement. Incorrect electrical component installation resulting in a damaged ehc.
- 10009565Kickstand spring stud fracture. All bigdog 2004 models.
Every Bigdog Bulldog model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.