2004 BMW R1100 S
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › BMW › R1100 S › 2004
These records cover every 2004 BMW R1100 S. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Owner complaints
1 complaints
What owners report most
Latest complaints
- Fuel/propulsion system · Power train
I was traveling at 47mph and as I shifted from 4TH to 5TH gear, the bike suddenly lurched with a bang as it decelerated and I lost the ability to accelerate. the engine revved as if the bike was in neutral with the throttle engaged even though I should have been in 5TH gear. I twisted the…
I was traveling at 47mph and as I shifted from 4TH to 5TH gear, the bike suddenly lurched with a bang as it decelerated and I lost the ability to accelerate. the engine revved as if the bike was in neutral with the throttle engaged even though I should have been in 5TH gear. I twisted the throttle back to zero and tried to shift into other gears. even though the shifter was working, the bike would not engage into any gear and was moving only under it's own momentum. there was a grinding noise which was prevalent. I coasted to a stop and tried shifting gears again, but could not get the bike to engage. I heard loud grinding noises when trying to put the bike in gear and then it would stall. after being towed, the BMW dealer confirmed clutch spine failure as root cause. there are numerous incidents of this failure documented on the internet, especially on the r1100s. in looking at the failure itself, one can see that the input spline shaft teeth are about 3/4 sheared as are all the splines on the clutch mating plate except for the ends furthest away from the input shaft. this IS a design error since the input shaft IS 8-10mm short and does not fully engage the full length of the clutch mating splines. therefore load and torque are not equally distributed amongst the full length of all the spines, which results in premature failure. it also appears that the input shaft was not correctly aligned to the chassis upon initial build. the fact that the design does not fully mate all the splines and that it wasn't aligned correctly when built are the root cause for this failure at less than 34,000 miles. not only IS this a costly repair since the entire bike needs to be dis-assembled, it also has the possibility of creating a fatal safety situation depending on if the fail were to occur in heavy traffic, around a curve or when carrying a passenger. *tr
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10249027The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle discharged battery complaints.
- 10182619Discharged Battery Energy Diagnosis Must Be Performed: The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle "discharged battery" complaints. In order to properly repair the vehicle the first time in the workshop, it is very important that the diagnostic test plans are performed to completion, with all results taken into consideration. Without performing the energy diagnosis test plan, the root cause of the discharged battery cannot be identified. This increases the chances of a repeat repair.
Every BMW R1100 S model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.