1999 Chevrolet S/t Blazer
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Chevrolet › S/t Blazer › 1999
These records cover every 1999 Chevrolet S/t Blazer. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Owner complaints
5 complaints
What owners report most
Latest complaints
- Tires
I purchase a set of cooper trendsetter SE tires 235/75/15 .and I now have had them replaced twice .both times IS was because for some reason the tires developed very bad vibration . I I now think I am going have to have them changed again .i just want to let u know that I have not caused this by abusing the tires but yet it still happened
- Tires › Sidewall
TL* the contact owns a 1999 chevrolet s/t blazer equipped with goodyear wrangler 105S tires, size: p235/75r15. While the vehicle was being washed, the contact noticed a lot of cracks on the sidewalls of all four tires. The vehicle was not taken to a dealer. The manufacturer was not notified of the failure. The vehicle failure mileage was 141,000 and the tire failure mileage was 10,000.
- Service brakes, hydraulic
Brake failure due to corrosion of brake lines. had to replace calipers due to piston freezing from corrosion, as well as replacing all brake lines after brake petal traveling all the way to the floor when applied. line was leaking above drivers side rear wheel. work completed at chevrolet dealership. *Tr
- Fuel system, gasoline › Delivery › Fuel pump
Fuel pump for 1999 chevy s-blazer 4 dr. Model. Pump has been replaced 4 times within 8 mos. First lasted 7 mos. Second lasted 4 days, third lasted 2 weeks, so far. Wiring harness has been replaced as recommended. Upon replacement of third pump a new relay was installed at the recommendation of auto…
Fuel pump for 1999 chevy s-blazer 4 dr. Model. Pump has been replaced 4 times within 8 mos. First lasted 7 mos. Second lasted 4 days, third lasted 2 weeks, so far. Wiring harness has been replaced as recommended. Upon replacement of third pump a new relay was installed at the recommendation of auto parts store. Second pump replacement produced a trouble code (check engine light) for evaporative emissions, which went away with the installation of third pump. Parts retailer IS starting to get hesitant about replacing this part, but has been as helpful as possible. I think they are more embarrassed about this than anything. Pump will lose the necessary amount of pressure that this application requires. Cold starts are fine, but once running at normal operating temp. The pump will not deliver adequate pressure until engine will eventually stall and will not restart until totally cooled. Original pump quit altogether at 97,000 miles, vehicle now has 104,000 miles and each replacement pump has had same symptoms. *tr
- Exterior lighting › Hazard flashing warning lights › Switch
The multi-function turn signal switch IS defective and causes an audible clicking noise from the dash. this also results in the exterior turn signal lamps to intermittently not function, depending on temperature. the issue IS more prevalent in cooler, colder weather. *jb
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10248444Vehicle Recalls
- 10246631Expanded Availability for Remanufacture and Return (R&R) Electronic Control Modules
- 10232287This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
- 10190934Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the component is constructed of an aluminum alloy.
- 10190933Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the component is constructed of an aluminum alloy.
- 10190932Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes, gouges, etc. The Dealer must insure that such damage is not deeper than what can be sanded or polished off. The wheel must be inspected for cracks. If cracks are found, discard the wheel. Any wheels with bent rim flanges must not be repaired or refinished. Wheels that have been refinished by an outside company must be returned to the same vehicle. The Dealer must record the wheel ID stamp or the cast date on the wheel in order to assure this requirement. Refer to Refinisher's Responsibility Outside Company later in this bulletin.
- 10190931Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes, gouges, etc. The Dealer must insure that such damage is not deeper than what can be sanded or polished off. The wheel must be inspected for cracks. If cracks are found, discard the wheel. Any wheels with bent rim flanges must not be repaired or refinished. Wheels that have been refinished by an outside company must be returned to the same vehicle. The Dealer must record the wheel ID stamp or the cast date on the wheel in order to assure this requirement. Refer to Refinisher's Responsibility Outside Company later in this bulletin.
Every Chevrolet S/t Blazer model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.