1995 Ford B Series

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 10007319Engine or fuel system concerns when using fuel with greater than 5% biodiesel concentration.
• 6091810Subject regarding proper operation and interpretation of dual air pressure gauge readings.
• 6090087Information on identifying non-approved / alternate refrigerants which could cause safety, and performance concerns if installed in ford a/c systems.
• 6089681Subject on a wire harness terminal repair kit available for repairing electrical wiring harnesses.
• 6089647Subject regarding vehicle lean correction procedure.
• 3056220Unknown
• 635976Subject regarding vehicle lean correction procedure developed for diagnosing and correcting vehicle lean.
• 613353Subject regarding the stoplamp diode location and replacement procedure on vehicles built since 12/90 with hydraulic brakes.
• 609550Hard to start vehicle at cold temperature.*ak
• 608429Vehicles equipped with fd1060 or fd1460 midrange diesel engines may experience a vibration or buzz through the throttle pedal.
• 606868Some medium trucks produced at kentucky assembly plant may exhibit oil leaking out of the transmission shift lever.
• 606491Subject regarding intermittent electrical issues, such as dash lights flashing when the turn signal IS activated.
• 606401Experiencing various intermittent concerns, such as low coolant level sensor leaking coolant into wiring harness.
• 605258Clarification pertaining to the dual air pressure gauge function.
• 604059Ford motor company has released a new electrical grease ( F8AZ - 19g208-aa ) to reduce the possibility of moisture corrosion at the terminals.
• 601366Information on availability of revised coolant level sensor.
• 601325The coolant temperature gauge reading may be inaccurate.
• 601290Information on tire company telephone numbers for customer assistance.
• 601012The use of petroleum-based grease as a lubricant in servicing disc brakes IS no longer acceptable.
• 52807New throttle cable to reduce vibration atthe accelerator pedal.
• 52015Hard starting- possible plugged catalytic converter/muffler (ccm)- vehicles built after 11/29/93 equipped with 1994 emission level fd1060 or fd1460 diesel engine.
• 51957Engine- diesel- fd1060 and fd1460- white smoke from exhaust- service tip.
• 51928Fuel injection pump- bosch- service information for fd1060/1460 diesel engines.
• 51861Fd 1060 engines - new design starter motor to alleviate hard start/no start concerns in cold ambients.
• 51696Fead belt- high wear and/or comes off of the drive pulley- vehicles built from 4/1/92 through 6/1/96 with fd1060 engine.
• 51677No start- starter will not turn engine over- vehicles with fd1060 engine.
• 51544Diagnose the fuel shutoff solenoid on the p-7100 pump.
• 51493The fuel shutoff solenoid on the p-7100 pump.
• 51417Suspension - noise from front spring rear hanger - revised rear spring hanger insulator pad - vehicles equipped with 6000, 7000 or 9000 lb axles built through 10/1/97.
• 51378Engine- fd1060 or fd1460- high vibration at low engine rpm- vibration- high- at low engine rpm- vehicles with fd1060 or fd1460 engine.
• 51377Heater- lack of heat in passenger compartment- vehicles equipped with fd1060 engine- cooling system- engine does not reach operating temperature- vehicles equipped with fd1060 engine.
• 50985Fead belt - high wear and/or comes off the drive pulley - vehicles built from 4/1/92 through 9/1/96 with fd1060 engine.
• 50957Starter - starter does not engage and/or starter may cycle (engage-disengage-engage) while cranking - vehicles equipped with an fd engine and an allison md3000 transmission built through 8/1/96,
• 50905Wiring - electrical diode identification and service replacements.
• 50787New fuel hose to replace the hose used in the low pressure fuel return system - the current hose may show sighn of deterioation or cracks.
• 50784Many manual transmissions that are replaced/repaired under warranty and returned to the wprc show signs of improper/lack of maintenance or misdiagnosis.
• 46478The use of petroleum-based grease as a lubricant in servicing disc brakes IS no longer acceptable because it may be incompatible with the rubber material used in the disc brake system. If petroleum-based grease IS used to lubricate any part of the disc brake system, it could cause rubber parts to swell if lubricant contacts the rubber material.
• 46477The engine coolant temp gauge may read on the cold side of the normal range, or may stay below normal even though the engine IS at its proper operating temp on some vehicles. This IS caused by the coolant temp sending unit not being positioned in the main stream of coolant flow. Install a new temp sender fitting.
• 46476Hard starting or a no start concern may occur on some vehicles. This may be due to diesel fuel draining out of the fuel injection system back into the fuel tank. This condition causes the injection system to lose its prime which leads to longer starter engagement times for engine shutdown period. Install a diesel fuel check valve (f5hz-9285-aa) on the fuel return line at the rear of the engine.
• 46446On f/b series w/ fd 1060 engine there may be a concern regarding insuffi- cient in-cab heat. To resolve this, the current thermostat can be replaced with a new low leak thermostat. The needed parts are available from cummis engine. Refer to tsb 95-20-12.

Every Ford B Series model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.