2006 Freightliner Century ST
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Vehicles › Freightliner › Century ST › 2006
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
These records cover every 2006 Freightliner Century ST. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
5 recalls name the 2006 Freightliner Century ST. Newest first.
On certain truck-tractors equipped with holland simplex SE or SE II fifth wheels, the latch lever pivot bolt assembly may have been over-tightened which could distort the pivot bolt spacer sleeve. corrosion or contaminates in the pivot may cause it to bind and prevent the fifth wheel jaw from latching securely around the trailer king pin.
There IS a possibility that the fifth wheel may fail to latch without the driver's knowledge. when the occurs, the driver could drive away and the trailer could become disengaged increasing the risk of a crash.
Dealers will replace the pivot bolt and sleeve with a hex head shoulder bolt and washer. the recall began on january 3, 2008. owners may contact freightliner at 1-800-547-0712.
On certain trucks equipped with rack and pinion steering, the ball socket assembly at the inner end of the driver side tie rod may be damaged in a sharp turn. excessive tie rod angles may loosen the tie rod in the ball socket or damage the threaded tie rod socket attachment to the steering rack on the driver side. the threaded end of the ball socket…
A fractured tie rod assembly will make the vehicle more difficult to control at higher speeds and a crash may occur.
Dealers will change the front axle steering stops to prevent interference in the tie rod ball socket assembly and steering components will be replaced free of charge. the recall began on july 8, 2008, and will be mailed in phases through december 31, 2008. owners may contact freightliner at 1-800-547-0712.
On certain trucks equipped with rack and pinion steering, the tie rod arms may have been incorrectly installed. the threaded end of the ball socket assembly may fracture and separate.
A fractured tie rod assembly will make the vehicle more difficult to control at higher speeds and a crash may occur.
Dealers will inspect for installation of the steering arms. steering components will be replaced on trucks that have incorrectly installed tie rod arms. the recall began on may 1, 2008. owner may contact freightliner at 1-800-547-0712.
Certain freightliner school bus chassis, heavy trucks, and thomas built school buses manufactured between july 2002 and july 3, 2007, equipped with bendix SR-7 spring brake control valves. the parker scv brass 90 degree single check valves (scv) which attach to the supply port of a bendix SR-7 spring brake modulating valve can break apart. pieces of the…
These conditions could either result in leakage and cause a delay in the application of the spring brake without warning or possibly lead to unintended vehicle rollaway or brake drag which could result in a vehicle crash, personal injury, or death.
Freightliner will notify owners and repair the vehicles free of charge. the recall began on january 11, 2008 to freightliner, sterling, and freightliner custom chassis owners; to thomas built bus owners on february 1, 2008. owners can contact freightliner at 1-800-547-0712.
Certain freightliner school buses and trucks manufactured from october 23, 2004, to march 21, 2006. during the steering column manufacturing process two welds may have been missing.
Columns with two welds missing may fatigue and fracture and allow the steering wheel to progressively be moved out of its normal position which may cause the steering to respond differently than expected. if this condition IS ignored, a crash may occur.
Freightliner will notify owners and inspect and repair the affected vehicle free of charge. the recall began on august 30, 2007. owners can contact freightliner at 1-800-547-0712.
Tl*the contact owns a 2006 freightliner century st. the contact stated that the vehicle would not pass inspection because the s-cam was frozen. there have been no failures to date. the vin, engine size, and number of cylinders were unknown. the current mileage was 21,763.
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
A consumer complaint was filed with the agency on august 22, 2009, by an independent contractor leasing a 2009 freightliner cascadia.the complaint alleges that in april of 2009 at approximately 50,000 miles he experienced a seal rupture in the rack and pinion assembly.a new seal was installed and at 56,000 miles he found his right steer tire completely bald.the repair shop identified an internal failure of the rack and pinion assembly causing the rapid wear of the tire.odi has identified ewr field reports related to failed rack and pinions on the subject vehicles.the reports identify either an internal failure of the rack and pinion assembly that resulted in crashes or a looseness of the inner tie rod end of the rack and pinion resulting in a poor alignment and premature tire wear.information received during this investigation from freightliner detailed failures of the rack and pinion assemblies on the subject vehicles.these failures were the result of the left hand inner tie rod end becoming loose over time.when the tie rod becomes loose, it may separate from the rack and pinion assembly and make the vehicle difficult to steer.frieghtliner has concluded that a defect related to motor vehicle safety does exist on the subject vehicles and has initiated a safety recall (09v-357) that will remedy all of them.this recall involves removing the tie rod and adding a compound to it that will prevent the tie rod from coming loose over time.a copy of the recall IS attached.freightliner's action resolves the issues raised by this investigation and, therefore, this investigation IS closed.
On november 19, 2007, freightliner filed defect report 07v-530 which outlines a safety recall program to notify the affected owners and correct the affected vehicles.
As a result of the odi investigation, freightliner has agreed to recall (number 07v-289) all of the vehicles manufactured with steering columns potentially missing welds.the recall remedy will involve inspecting the recalled vehicles for missing welds and if found replace the steering column.early warning aggregate data submitted to nhtsa by freightliner suggested that a steering problem (ewr code 01) existed for the 2004 and 2005 century and columbia class vehicles.the count of field reports submitted for the first quarter of 2006 was higher than the average of the previous 6 quarters for the aggregate steering data.odi's further review of the ewr data foundfield reports that described steering column failures as a result of steering column welds cracking or breaking.information received from freightliner detailed failures of the steering columns on the subject vehicles.these failures were the result of missing and cracked welds on the steering column assembly.during testing of vehicles containing defective steering columns, odi determined that weld failures in the steering column create a situation where the vehicle becomes difficult to steer or may startle the driver upon failing, thus presenting a safety risk.a copy of the recall IS attached.freightliner's action resolves the issues raised by this investigation and, therefore, this investigation IS closed.
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.