2007 International 4000

Recalls

1 recall names the 2007 International 4000. Newest first.

• Electrical system

  Jun 5, 2008NHTSA 08V25800051,588 vehicles

  Navistar IS recalling 51,588 heavy trucks, commercial buses and school buses manufactured between november 21, 2000 and may 21, 2008, equipped with one or more remote power modules. the potting material that encapsulates the circuit board of the vehicle's remote power module may not sufficiently seal the circuit board from water and contamination…

  Risk and remedy

  Risk

  A fire could cause personal injury or death.

  Remedy

  Navistar will notify owners and repair the vehicles free of charge. the recall began on july 10, 2008. owners may contact navistar at 1-280-461-1890.

  Full recall details →

Owner complaints

Latest complaints

• Nov 28, 2016AL260,000 mi
  Engine
  TL* the contact owns a 2007 international 4000. While having the vehicle serviced at a repair shop, it was brought to the contact's attention that the oil pan had fractured and was leaking oil onto the engine block. The contact stated that the mechanic would have to change the heat exchanger to…

  TL* the contact owns a 2007 international 4000. While having the vehicle serviced at a repair shop, it was brought to the contact's attention that the oil pan had fractured and was leaking oil onto the engine block. The contact stated that the mechanic would have to change the heat exchanger to repair the vehicle. The vehicle was repaired. The vin was not included in nhtsa campaign number: 08v258000 (electrical system). The manufacturer was notified. The approximate failure mileage was 260,000.

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 11010428This article addresses chassis lean conditions on all chassis. This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean.
• 10253979This document is to guide users to eliminate brake pedal rattle noise.
• 10251414Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison transmission or PSI engine.
• 10251409Suggested alignment target values when performing a vehicle axle alignment.
• 10246231J1939 Data Link Source Address Information
• 10243610How to request a horsepower quote; all International and Cummins engines
• 10243596General Wheel Speed Sensor Troubleshooting
• 10243595Diagnosis of chassis wander complaints.
• 10241555J1939 Data Link Source Address Information
• 10241554J1939 Data Link Troubleshooting
• 10234000Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles equipped with PSI engines or Cummins ISB engine with Allison transmissions
• 10227455J1939 Data link source address information
• 10222490Pico Scope CCOS (Crankcase Separator Test)
• 10219330PicoScope Test One Channel RCT
• 10219325PicoScope Test Resistance and Ohmmeter
• 10219319PicoScope Test for Datalink (CAN) Health Shorts & opens
• 10219314PicoScope Test - Battery Loss of Charge - Parasitic Draw Test
• 10209487Calculating pulses per mile (speedometer setting); only models equipped with International engines
• 10204139Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
• 10204137J1939 Data Link Troubleshooting
• 10204136Dual Drive Cab Throttle Position Harness for APS/IVS throttle pedals; only models with both left hand and right hand drive.
• 10204134WABCO Full Power Brake Diagnostic Code (DTC) Index
• 10201758Engine Oil Capacities. All International electronic engines 1994 to present and Cummins ISB, ISM, or ISX engines
• 10199915General wheel speed sensor troubleshooting
• 10198708Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
• 10189743Suggested alignment target values when performing a vehicle axle alignment
• 10189741Frame Rail Straightness Inspection Procedure
• 10185108ECM Calibration for DPF Replacement; only trucks and busses built with 2007- 2009 MaxxForce DT/9/10. 2010-2012 MaxxForce DT/9/10, 2007-2009 MaxxForce V8, 2008-2009 MaxxForce 11/13 engines
• 10181960Cab Lean Concern
• 10179296Codes 141, 142, and 621 in a 2-box ECM/IDM; only models with 2-box ECM/IDM from 2003-2007
• 10179294Driveline Information Center and Troubleshooting Procedures
• 10179289Repair Procedures for Vehicles Struck by Lightning
• 10177096A/C Refrigerant and Oil Capacities
• 10173025Cleaning and Disinfecting Trucks and Buses
• 10172045J1939 Data Link Troubleshooting
• 10169879Key Codes and Key Cutting Information (Not for CV Series)
• 10166288Uneven Brake Pad Wear Between the Inner and Outer Pads on Hydraulic Brake /Pin Slide Vehicles; only models built after 1/2004
• 10165643Oil Capacities; All Electronic International Engines 1994 - Present. Cummins ISB, ISM & ISX
• 10163416Suspension Lean Diagnostics; All models
• 10162034J1939 Data Link Source Address Information

Every International 4000 model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.