2005 International 8600
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › International › 8600 › 2005
These records cover every 2005 International 8600. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
4 recalls name the 2005 International 8600. Newest first.
Navistar, Inc. (Navistar) is recalling certain 2000-2003 International 8100, 2001-2003 International 9100i, 2001-2007 International 9400i, 2001-2010 International 9200i, 2002-2007, 2009 International 8500, 2003-2007, 2013 International 9900i, 2003-2018 International 8600, 2004, 2007 International 9900iX, 2008-2018 International ProStar, 2010-2011, 2013…
Risk and remedy
Risk
Low visibility or obstructed back up lights may not alert other drivers that the vehicle is backing up, increasing the risk of a crash.
Remedy
Dealers will replace the existing rear stop/turn signal lights, free of charge. Owner notification letters were mailed May 06, 2024. Owners may contact Navistar's customer service at 1-800-448-7825. Navistar's number for this recall is 23514.
On certain heavy duty trucks equipped with caterpillar diesel engines, the engine electrical ground cable that connects the engine block with the starter may be routed in a way that could cause chafing against the starter's positive battery cables.
Risk and remedy
Risk
If chafing occurs between the positive and negative cables, an electrical short may result and may cause a vehicle fire, possibly resulting in property damage, personal injury or death.
Remedy
Dealers will inspect the engine ground cables for proper routing. if any chafing IS found, the engine block ground cable will be replaced with a shorter (280mm) cable and any other damaged cables will be replaced and routed correctly free of charge. the recall began on december 21, 2005. owners may contact international at 1-800-448-7825.
On certain vehicles equipped with air operated fifth wheel slides and an msva 7-pack accessory controller, the 7-pack can allow water to contaminate its circuit board. this could result in inadvertent operation of the fifth wheel slide control.
Risk and remedy
Risk
If the slide control actuates while the vehicle IS in motion, momentum from the trailer can cause the fifth wheel to slide without input from the driver, which could result in a crash without warning.
Remedy
Dealers will relocate the msva 7-pack to a less water intensive environment. a new msva 7-pack base, that has been improved to prevent water intrusion, and all air accessory solenoids will be installed free of charge. the recall began on august 5, 2005. owners may contact international at 1-800-448-7825.
On certain trucks, the bolts that mount the front of the cab to the mounting brackets were not properly torqued at the manufacturing plant.
Risk and remedy
Risk
These bolts can loosen during normal vehicle use and fall out. this may lead to the cab separating from the vehicle's chassis during a vehicle crash that may result in property damage, personal injury or death.
Remedy
As an interim action, dealers will properly tighten the existing cab mounting bolts and replace any missing bolts. as soon as parts are available, dealers will replace all sixteen bolts and tighten them properly. an interim letter was sent to owners on february 11, 2005. another letter was sent to owners on april 8, 2005, as soon as parts are available. owners should contact international at 1-800-448-7825.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 11010428This article addresses chassis lean conditions on all chassis. This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean.
- 10251414Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison transmission or PSI engine.
- 10251409Suggested alignment target values when performing a vehicle axle alignment.
- 10246231J1939 Data Link Source Address Information
- 10243610How to request a horsepower quote; all International and Cummins engines
- 10243596General Wheel Speed Sensor Troubleshooting
- 10243595Diagnosis of chassis wander complaints.
- 10234000Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles equipped with PSI engines or Cummins ISB engine with Allison transmissions
- 10227455J1939 Data link source address information
- 10222490Pico Scope CCOS (Crankcase Separator Test)
- 10219330PicoScope Test One Channel RCT
- 10219325PicoScope Test Resistance and Ohmmeter
- 10219319PicoScope Test for Datalink (CAN) Health Shorts & opens
- 10219314PicoScope Test - Battery Loss of Charge - Parasitic Draw Test
- 10219307PicoScope Test 5V & 12V Intermittent Open and Short circuit diagnostics
- 10209487Calculating pulses per mile (speedometer setting); only models equipped with International engines
- 10208431J1939 Data Link Source Address Information
- 10204139Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
- 10204137J1939 Data Link Troubleshooting
- 10201758Engine Oil Capacities. All International electronic engines 1994 to present and Cummins ISB, ISM, or ISX engines
- 10200831Cab water leak troubleshooting tips
- 10199915General wheel speed sensor troubleshooting
- 10198708Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
- 10189743Suggested alignment target values when performing a vehicle axle alignment
- 10189741Frame Rail Straightness Inspection Procedure
- 10181960Cab Lean Concern
- 10179294Driveline Information Center and Troubleshooting Procedures
- 10179289Repair Procedures for Vehicles Struck by Lightning
- 10177096A/C Refrigerant and Oil Capacities
- 10173025Cleaning and Disinfecting Trucks and Buses
- 10172045J1939 Data Link Troubleshooting
- 10170952Bendix EC80 Blank Module Replacement Program; This document will guide the user through selecting the correct ABS module when it has been determined a replacement is needed. Only Models with EC-80 ABS Controller
- 10169879Key Codes and Key Cutting Information (Not for CV Series)
- 10165643Oil Capacities; All Electronic International Engines 1994 - Present. Cummins ISB, ISM & ISX
- 101645098600/TranStar Hood Latches Do Not Fit Correctly. Only models that have had or will have the hood latches and/or the fender extensions replaced.
- 10163416Suspension Lean Diagnostics; All models
- 10162034J1939 Data Link Source Address Information
- 10160941Suggested alignment target values when performing a vehicle axle alignment
- 10156576Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure
- 10156324Driveline Information Center and Troubleshooting Procedures
Every International 8600 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.