Navistar, Inc. (Navistar) is recalling certain 2000-2003 International 8100, 2001-2003 International 9100i, 2001-2007 International 9400i, 2001-2010 International 9200i, 2002-2007, 2009 International 8500, 2003-2007, 2013 International 9900i, 2003-2018 International 8600, 2004, 2007 International 9900iX, 2008-2018 International ProStar, 2010-2011, 2013…
Risk and remedy
Risk
Low visibility or obstructed back up lights may not alert other drivers that the vehicle is backing up, increasing the risk of a crash.
Remedy
Dealers will replace the existing rear stop/turn signal lights, free of charge. Owner notification letters were mailed May 06, 2024. Owners may contact Navistar's customer service at 1-800-448-7825. Navistar's number for this recall is 23514.
On certain trucks, the diesel engine/generator unit can be started remotely by a person in the truck cab while its protective cover IS removed; and under certain conditions the engine may re-start after the emergency fuel cutoff IS used to shut down the unit.
Risk and remedy
Risk
An unexpected starting of the diesel engine/generator unit, when the protective cover IS removed and maintenance IS being performed, may result in personal injury.
Remedy
Dealers will update the auxiliary power system with a new electronic control unit containing programming to prevent diesel engine/generator operation while its protective cover IS removed. new warning labels will be installed on the diesel engine/generator unit and cover. Orange conduit will be installed on all high voltage power cables. the recall began on june 29, 2007. owners may contact international at 1-800-448-7825.
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
11010428This article addresses chassis lean conditions on all chassis. This does not include any diagnostics for body leans such as a cab lean. Keep in mind that a chassis lean may cause or accentuate a cab lean. Filling out the printable form and using the notes in blue will help you to determine the source of the lean and identify the action and parts required to correct the lean.
10251414Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison transmission or PSI engine.
10251409Suggested alignment target values when performing a vehicle axle alignment.
10246231J1939 Data Link Source Address Information
10243610How to request a horsepower quote; all International and Cummins engines
10241555J1939 Data Link Source Address Information
10241554J1939 Data Link Troubleshooting
10234000Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles equipped with PSI engines or Cummins ISB engine with Allison transmissions
10227455J1939 Data link source address information
10185108ECM Calibration for DPF Replacement; only trucks and busses built with 2007- 2009 MaxxForce DT/9/10. 2010-2012 MaxxForce DT/9/10, 2007-2009 MaxxForce V8, 2008-2009 MaxxForce 11/13 engines
10181960Cab Lean Concern
10179294Driveline Information Center and Troubleshooting Procedures
10179289Repair Procedures for Vehicles Struck by Lightning
10177096A/C Refrigerant and Oil Capacities
10173025Cleaning and Disinfecting Trucks and Buses
10172045J1939 Data Link Troubleshooting
10170952Bendix EC80 Blank Module Replacement Program; This document will guide the user through selecting the correct ABS module when it has been determined a replacement is needed. Only Models with EC-80 ABS Controller
10169879Key Codes and Key Cutting Information (Not for CV Series)
10165643Oil Capacities; All Electronic International Engines 1994 - Present. Cummins ISB, ISM & ISX
10163416Suspension Lean Diagnostics; All models
10156576Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure
10156324Driveline Information Center and Troubleshooting Procedures