2000 International Harvester 4700 LP
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › International Harvester › 4700 LP › 2000
These records cover every 2000 International Harvester 4700 LP. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
2 recalls name the 2000 International Harvester 4700 LP. Newest first.
On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes.
Risk and remedy
Risk
The combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers.
Remedy
International will notify its customers and repair the buses free of charge. the recall began october 29, 2004.
Vehicle description: school/transit buses and medium duty trucks. the castings used on the power steering pumps were not built to match the engineering drawings, resulting in a thin wall in the pump casting or a complete connection of two passages that are supposed to be separated to control fluid flow. the fluid flow may be reduced to less than the…
Risk and remedy
Risk
An increase in stopping distance at slow engine speeds can result, increasing the possibility of a crash.
Remedy
Dealers will inspect and replace all pumps that have the defective casting numbers.
Defect investigations
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
- Overheating front and rear brakes
This investigation focused on international medium duty trucksand school bus chassis weighing up to 33,000 pounds, equipped with hydraulic brakes and built with the bosch zero offset pin slide (zops)brake system calipers.international used the zops calipers from april 1997 through june 2002.odi was concerned about…
This investigation focused on international medium duty trucksand school bus chassis weighing up to 33,000 pounds, equipped with hydraulic brakes and built with the bosch zero offset pin slide (zops)brake system calipers.international used the zops calipers from april 1997 through june 2002.odi was concerned about reports of the brake calipers sticking in the applied position, resulting in excessive heat.as the investigation progressed, odi became aware of wheel end fires, some of which occurred on school buses.during the investigation odi obtained warranty data which was sorted and analyzed by vrtc test engineers and odi to gain an understanding of the magnitude of the problem.after a thorough warranty data analysis, related testing and document reviews, odi met with international, shared the data analysis and shortly afterwards, international agreed to a safety recall.further details are included on pages 2 - 4.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10044292International: after lining condition and wear, fastener torque, component lubrication have been verified on the brakes because of the chatter or squealing on the trucks, a procedure will be performed. No model or model years are listed. Updated 12/20/13.
- 10044291International: procedure information to resolve issue of overheating and smoking of low mileage, single wheel end brake. Updated 11/4/14. Updated 1/27/15. Updated 1/30/15.