1995 International Harvester 8200
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Vehicles › International Harvester › 8200 › 1995
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
These records cover every 1995 International Harvester 8200. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
3 recalls name the 1995 International Harvester 8200. Newest first.
These vehicles were built with an improperly plumbed brake system which affects the braking on the rear axle when running either bobtail or pulling a trailer.
This condition can affect the stopping ability of the vehicle because the front steer axle brakes and trailer's brakes would be doing most of the braking. Increased stopping distances would be required causing accelerated wear on the steer axle and the trailer brakes.
Navistar dealers will inspect vehicles and repair by installing brake lines and fittings as required.
During assembly, the tie rod end nuts were not properly torqued. Extremely low torque can allow movement beween the ball stud and the tie rod arm causing damage.
This condition can affect the driver's ability tosteer the vehicle increasing the potential for a vehicle accident.
Dealers will check the torque on the ball studs of the suspect axles and bring the torque up to rockwell's specifications.
The base of the electronic accelerator pedal IS made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall IS not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the mounting pads on the base of the pedal assembly to fail and totally separate from the firewall.
This can cause loss of speed control, driver distraction, and result in an accident.
Dealers will inspect the accelerator pedal assembly and install a plate between the accelerator mounting base and the firewall on those units where the base IS not broken and has no visible signs of a crack. If the base IS broken or cracked, the accelerator assembly will be replaced with a new redesigned accelerator pedal assembly.
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.