1991 Nissan 300ZX
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Nissan › 300ZX › 1991
These records cover every 1991 Nissan 300ZX. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Owner complaints
12 complaints1 involved a crash1 injuries
What owners report most
Latest complaints
- Service brakes
TL* the contact owns a 1988 (na) nissan 300zx. While driving approximately 35 mph, the brakes seized without warning. The vehicle was not repaired. The vehicle was taken to an independent mechanic who stated that the vehicle was working up to specification. The manufacturer was not notified. The approximate failure mileage was 124,000.
- Fuel system, gasoline › Fuel injection system
There was a constant fuel smell inside vehicle, dealer said fuel injectors had to be replaced.*ak
- Power train › Automatic transmission · Power train › Driveline › Universal joint
Automatic transmission completely failed, u-joints on driveshaft worn out. *yh
- Fuel system, gasoline › Fuel injection system › Injectors
Fuel injectors leak fuel into the engine compartment. it's an on going problem. Dealer fixed vehicle at 40 thousand miles under warranty. But at 80 thousand miles it IS happened again. *ak
- Power train › Automatic transmission
Automatic transmissions on this cars are frequently breaking which may create sudden lock of rear wheels which may cause spin or slide of car and create accsiddent. Same transmission on nissan trucks, 240sx, mazda mpv, infiniy J30, I30. This probles happens in about 10TH to 15TH car. Some people had this problem more than 4 times.
- Fuel system, gasoline › Fuel injection system
The fuel injector's leak and spray gas over the engine. Could result in a vehicle fire. Dealer has been contacted. *ak
- Air bags › Frontal
During a frontal impact at speeds of 35 to 45mph, the driver's side air bag did not deploy. *ak
- Power train › Automatic transmission
Automatic transmission slipping. *ak
- Service brakes, hydraulic › Foundation components › Disc › Rotor
Rotors warp continuously. Had changed five times. *ak
- Engine and engine cooling › Exhaust system › Emission control › Gas recirculation valve (egr valve) · Power train › Axle assembly › Axle shaft › Seal · Service brakes, hydraulic › Foundation components › Master cylinder
Rear axle seal failed. *Sd
- Power train › Clutch assembly
Clutch master cylinder failed twice, emitting burning odor. *skd
- Electrical system › Ignition · Power train › Automatic transmission · Power train › Clutch assembly
Transmission failure.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10243708DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10239062SILICONE-BASED LUBRICANT OR GREASE CAN DAMAGE ELECTRICAL COMPONENTS SERVICE INFORMATION Do not apply Silicone-based lubricants or grease to, or around, any interior electrical components. To avoid the risk of death or severe personal injury, do not directly spray Silicone-based lubricant or grease, or inadvertently overspray Silicone-based lubricant or grease onto any interior electrical components. These types of lubricants can be detrimental to the proper operation of electrical components.
- 1023906012 VOLT BATTERY TESTING FOR IN-SERVICE VEHICLES SERVICE INFORMATION The following Service Information lists NNA procedural recommendations for establishing good connections while performing 12V battery testing. These recommendations are expected to promote uniformity during the connection process, therefore reducing the number of incorrect Test with DCA and Replace results. HINT: If 12 volt batteries are allowed to discharge for a prolonged period of time, battery life may be drastically reduced. This condition may lead to premature battery replacement and customer dissatisfaction. IMPORTANT: CPX-900 is now an accepted testing tool to use along with or in place of the DSS-5000 CPX-900 operating instructions are found at: https://nissancpx900.midtronics.com/ DSS-5000 operating instructions are found at: https://nissandss5000.midtronics.com/ DCA-8000 is now a required testing tool to be used for all warranty replacement decisions. The DCA-8000 is also a more efficient charger than previously available, and will charge any available 12 volt lead acid battery safely and accurately as long as all precautions and inputs are made correctly. The DCA-8000 operating instructions are found at: https://nissandca8000.midtronics.com/
- 10235710INTELLIGENT KEY REPLACEMENT OR SWAPPING BETWEEN VEHICLES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin.
- 10235707VEHICLE KEY NOT DETECTED / AUTHENTICATED, ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10232658REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10232657WHEEL BEARING COLLISION DAMAGE This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10232656WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10232652DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10206391STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10192305SERVICE INFORMATION Information necessary to service the Supplemental Restraint System (SRS) safely is included in the "RESTRAINTS" section of the Electronic Service Manual (ESM) for each vehicle. IMPORTANT: Turn the ignition switch OFF, disconnect both battery terminals, and wait at least 3 minutes before performing any service on the SRS. See this bulletin for further detail.
- 10192233Nissan Original Equipment or Genuine Accessory Alloy wheels, along with their finish coating (clear, chrome, titanium, etc.), are specifically developed to achieve Nissan design and performance standards. These Original Equipment or Genuine Accessory wheels are subjected to testing to ensure they meet Nissan's standards. Nissan Original Equipment Alloy or Genuine Accessory wheels subjected to aftermarket chroming may no longer continue to meet these standards and may be seriously damaged. Therefore, Nissan most strongly discourages, and recommends that these wheels NEVER be subjected to, aftermarket chroming. See this bulletinfor further detail.
- 10192217If YOU CONFIRM: A vehicle needs to have the brake rotors resurfaced (front or rear). ACTION: Use the ProCut PFM Series on-car brake lathe to perform brake rotor resurfacing and follow the tips listed in this bulletin. - The ProCut PFM Series brake lathe has been chosen as the approved tool for rotor resurfacing. - The ProCut PFM Series brake lathe can be ordered from TECH-MATE at 1-800-662-2001. - ProCut technical support or service can be obtained by calling 1-800-543-6618. NOTE: Brake rotors may need to be resurfaced during routine brake repair or for brake "judder" incidents. - Brake judder: A brake pedal pulsation and/or steering wheel shimmy when braking that occurs when there is too much thickness variation of the brake rotors (see NTB00-033). See this bulletin for further detail.
- 10192216SERVICE INFORMATION - This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item listed, if any should occur. - Most brake incidents fall into the following categories: a. Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released. b. Brake Judder: A vibration that can be felt in the vehicle, steering wheel or brake pedal when the brakes are applied. c. Pedal Feel: The effort needed to operate the brakes is too high or too low. SERVICE PROCEDURE 1. Verify the condition by road testing the vehicle with the customer. 2. Determine the specific brake incident based on the description in the Service Information above. 3. Follow the appropriate repair procedure(s), listed on the following pages, for your specific incident. See this bulletin for further details.
- 10192145SERVICE INFORMATION This bulletin provides information to identify: - A leaking strut or a shock absorber that qualifies for replacement under warranty. - A strut or shock absorber that has slight oil seepage, a condition which is considered normal, does not affect strut/shock absorber operation or performance, and does not require replacement. - A strut or shock absorber that should be replaced due to rod resistance/noise issues. See this bulletin for further detail.
- 10188377STRUT AND SHOCK ABSORBER REPLACEMENT GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- 10185459AIR BAG DEPLOYMENT PROCEDURE This bulletin is no longer active. Please discard previous versions of NTB92-096.
- 10178244VOLUNTARY SERVICE CAMPAIGN ON 1990-93 300ZX IGNITION POWER TRANSISTOR UNIT Service Campaign ID # P4120 is no longer active. Repair orders opened after this bulletins published date are no longer eligible for reimbursement under Campaign ID # P4120. Discard all previous versions of P4120.
- 10051767Nissan: lock/unlock request button on outside handle does not respond.
- 10032506Nissan: vent control valve replacement. When replacing the evap canister vent control valve for reason: use the one listed on page 2; for vent control valve replacement procedure, refer to the appropriate section of the electronic service manuals (esm; when installing the new valve, do not add any lube to its o ring; for frontier (D40 series) only, install the protector listed in parts information. Includes 2005-09 frontier. Updated 12/8/10.
- 10031305Nissan: tire pressure monitoring system (TPMS) warning light on/flashing. No models or model years listed. Updated on 08-11-2011.
- 10030165Nissan: the 12 volt battery IS an important part of the vehicle electrical system and IS required to stay connected when the engine IS running. To prevent damage to vehicle electronic components follow the instructions/cautions. No model years listed.
- 52164Transmissions detent holes eliminated from adapter plate.
- 39162Voluntary service campaign on ignition power transistor unit.
Every Nissan 300ZX model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.