PACCAR Incorporated (PACCAR) is recalling certain 2018-2020 Kenworth T270, T370, T440, T470, T660, T680, T880, T800, W900, W990; and 2018-2020 Peterbilt 330, 337, 348, 365, 367, 389, 520, 567, and 579 vehicles. The Dana D-Series axle steer arm fasteners that attach the steering arm to the steering knuckle may fail.
Risk and remedy
Risk
Fastener failure can result in a loss of steering control, increasing the risk of a crash or injury.
Remedy
Dealers will replace and torque the steer arm fasteners, at no charge. Owner notification letters were mailed November 8, 2022. Owners may contact Kenworth customer service at 1-425-828-5888 and Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall are 22 PBB and 22 KWB.
PACCAR Incorporated (PACCAR) is recalling certain 2018-2021 Peterbilt 337, 348, 365, 367, 520, 567, Kenworth T270, T370, T440, T470, T800 and T880 vehicles. The sealing washer may not seat correctly in the pilot bore holes, allowing the high pressure fuel rail assembly to leak.
Risk and remedy
Risk
A fuel leak in the presence of an ignition source increases the risk of a fire.
Remedy
Dealers will inspect the rail threads and fuel lines, and replace the rail as necessary, free of charge. Owners may contact PACCAR customer service at 1-425-828-5888 (Kenworth) or 1-940-591-4220 (Peterbilt). PACCAR's numbers for this recall are 21KWC and 21PBD.
PACCAR Incorporated (PACCAR) is recalling certain 2020-2021 Peterbilt 348, 365, 367, 389, 520, 567 and Kenworth T800, T880, W900, W990 vehicles equipped with Watson and Chalin steerable lift axle suspension systems (model SL2065). The axles may have lower rear pivot bolts that are not long enough to sufficiently engage the locking feature of the…
Risk and remedy
Risk
The short screws can cause the hardware to separate from the suspension system and become road hazards, increasing the risk of a crash and/or injury.
Remedy
PACCAR will notify owners, and dealers will inspect suspect chassis and replace the pivot bolts, as necessary, free of charge. The recall began September 29, 2020. Owners may contact Kenworth customer service at 1-425-828-5888 and Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall is 20PBE and 20KWC.
PACCAR Incorporated (PACCAR) is recalling certain 2020 Kenworth T800, T880 and W990 and Peterbilt 348, 367, 389, 520, and 567 vehicles. The forward rear axle output shafts may have been improperly heat treated during manufacturing, possibly resulting in the shafts fracturing.
Risk and remedy
Risk
If the rear axle output shaft fractures, the shaft or interaxle driveline could detach and become a road hazard, increasing the risk of a crash.
Remedy
PACCAR will notify owners, and dealers will inspect and replace the output shafts, as necessary, free of charge. The recall began February 19, 2020. Owners may contact Kenworth customer service at 1-425-828-5888 or Peterbilt customer service at 1-940-591-4220. PACCAR's numbers for this recall are 19KWE and 19PBG.
PACCAR Incorporated (PACCAR) is recalling certain 2019-2020 Peterbilt 337 and 348 vehicles. An incorrectly located weld in the steering shaft may crack and cause the lower shaft within the steering column to separate from the mating yoke.
Risk and remedy
Risk
If the steering column separates from the mating yoke, loss of steering control can occur, increasing the risk of a crash.
Remedy
PACCAR has notified owners, and dealers will inspect and replace the steering column, if necessary, free of charge. The recall began August 30, 2019. Owners may contact PACCAR customer service at 1-940-591-422. PACCAR's number for this recall is 19PBD.
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
11010926Info Only Unnecessary starter replacements can result from customer complaints regarding engine starting issues. A new Starter Troubleshooting Guide has been created to provide a comprehensive list of starting system checks, which should reduce unnecessary starter replacements and associated warranty claims. Engine starting system warranty claims now require a completed Starter Checklist, a Battery Pack Midtronics Report, and a Cable Drop Midtronics Report. Claims filed without these documents may be denied.
11005516Fix As Fail The height control valve (HCV) rod on vehicles with low air leaf suspensions is prone to toggling over center during rough road conditions. With full suspension articulation, HCV bracket flexes and toggles over center the HCV linkage, which results in either deflated airbags or makes them unable to inflate. Fix-as-fail start date is 07/30/2024.
10232162Fix As Fail Chassis that were manufactured with certain battery cable routing brackets may experience rubbing or chafing of the battery cables.
10225578Info Only - PACCAR is introducing Over-the-Air (OTA) software updates for engine MY17 and newer chassis equipped with Cummins X15, X12, ISX12, ISX12N, L9N, PX-7, and PX-9 engines The technology will leverage the existing Remote Diagnostic cs hardware to deliver secure software updates remotely. This will reduce downtime and save on maintenance costs for eligible vehicles.
10222269Fix-As-Fail On certain chassis with Low Air Leaf Suspension or Low-Low Air Leaf Suspension, the Height Control Valve (HCV) arm may be rubbing on other components when the bend in the arm is facing outboard. Flipping the bend in the HCV arm inboard prevents the rub.
10219235The service information for Bendix Air Dryer maintenance is being updated to include new procedures.
10209699Fix-As-Fail A hill start assist (HSA) valve plumbing revision eliminates ice buildup in the HSA valve exhaust in cold weather.
10208758Due to major data carriers phasing out 3G networks, chassis currently utilizing first generation Peoplenet Mobile Gateway (PMG001) will experience severe 3G service degradation as early as January of 2022. Chassis currently utilizing 3G antennas as a primary antenna may experience this degradation.
10206087Information Only: An improved procedure has been developed for servicing the fuel filter on model 348 chassis equipped with a PX-9 and 11 5/8 frame rails.
10201965Fix-As-Fail Due to undersupply issues, only a limited supply of Diesel Exhaust Fluid (DEF) sensors are available. As a temporary solution, after PACCAR confirms a DEF sensor is not available, a temporary software update will allow a vehicle to continue operation with a failed DEF sensor by disabling the DEF sensor diagnostics.
10201956Information Only - Rear axle Quarter Fenders with less than two inches of clearance between the top of the quarter fender and the bottom of the trailer/equipment are susceptible to damage. The lack of clearance could result in cracked/broken quarter fenders or complete separation if undetected or un-remedied.
10199985Fix-as-Fail: Radio does not mute when truck with auto trans is placed in reverse. Software flash resolves issue.
10198814Safety Recall TSE Brake Chamber Air Leak NHTSA ID: 21V328. Meritor brake chambers were built with a misaligned park spring, which may cause a fatigue hole in the diaphragm and an internal air leak. The affected brake chambers will be replaced.
10198809Safety Recall Cummins Fuel Rail Leak NHTSA ID: 21V391 / TC: 2021-323, Cummins Recall: C2423.Cummins PX9 and ISX12 fuel rails may leak around a sealing washer, potentially resulting in fuel leaks.Undetected prolonged diesel fuel spray in the presence of an ignition source may increase the risk of fire.
10188550Information Only Windshield washer pumps have a high No Trouble Found rate. Washer pumps may fail to spray due to a clogged filter.
10186168SmartNav 2.0 Hardware retrofit for quality validation and vehicle validation units.
10182219Fix as Fail: Peterbilt has introduced an improved mounting bracket for low mount air tanks for vehicles built between January 01, 2017 and July 06, 2020. Torsional vibration may stress the currently-installed brackets and cause them to fail near the bottom of the frame rail.
10180809Safety Recall: Peterbilt has decided that a condition could exist in certain model 348, 365, 367, 389, 520, and 567 vehicles built between 11/19/2019 and 4/09/2020. Vehicles equipped with Watson & Chalin SL2065 lift axles may have lower rear pivot bolts that are not long enough to sufficiently engage the locking feature of the corresponding nuts. In some cases, this condition may cause a loss of clamp load of the pivot joint (arm to axle). Extended use of the lift axle in this condition can result in foreign object debris on the roadway, increasing the risk of a crash and/or injury.
10180726Information only: In 2020, Peterbilt and Kenworth began using the same M10, M12, M16, and M20 frame fasteners on all vehicles. Torque specifications for these fasteners are different from previous fasteners.
10179370Fix as Fail: Peterbilt has determined that certain model 348, 365, 367, 382, 384, 386, 388, 389, 567, 579, and 587 trucks, built between 4/13/2010 and 3/16/2020 and equipped with a flush mounted battery box, utilized rubber washers that could rub through and cause the aluminum box mounting tabs to rub directly on the steel frame brackets. This could result in cracked battery box mounting angles. Resolution is to add the reinforcement bracket(s) to affected vehicles.
10177021Information Only: This bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplete information.
10177019Fix as Fail: For all conventional models, except 387/587, equipped with Side-of-Cab (SOC) exhaust and built from 03/6/2006 to 1/20/2020, the clamps that secure the SOC exhaust stacks may not be tightened properly. This may allow the exhaust stack to rotate and contact the cab or sleeper.
10176033Information only: Hendrickson Softek front axle maintenance intervals and requirements.
10173205Information Only: Proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
10169787Information Only - Vehicles built with NAMUX software from 2013 to present may experience accuracy issues with the tachometer. The issue can be temporarily resolved using any one of the included procedures.
10169785Safety Recall: Peterbilt Motors Company has determined that a defect, which relates to motor vehicle safety, may exist in certain model 348, 367, 389, 520 or 567 vehicles manufactured between November 22, 2019 and December 5, 2019. Output shafts may not have been correctly heat-treated and could break near the pinion nut. Resolution is to inspect the driveshaft to verify the julian date, and if witin th esupect date rate,, replace the output shaft.
10168703Information Only: This bulletin provides guidance for repairing an air-conditioning system after internal failure of the A/C compressor.
10165583Information Only This bulletin provides information about the California Air Resources Board (CARB) Periodic Smoke Inspection Program (PSIP) and Heavy Duty Vehicle Inspection Program (HDVIP).
10164412Safety Recall: Defectective lower hsaft to u-joint yoke in non-telescoping steering columns due to supplier weld not creating enough penetration and can crack, which could lead to a loss of steering and increase risk of crash or injury. Resolution is to inspect for defective identified manufacturing lot and replace steering column if determined defective.
10164378Fix-As-Fail - Composite fittings used in the cooling system may crack, resulting in coolant leaks. Brass fittings are available to replace the composite fittings.
10164375Fix-As-Fail: Two separate causes have been identified as root cause of intermittent low coolant indicator illumination.
10162392Information Only - Quick Reference Guide for Electric harness damage repairs.
10161054Non-Safety Campaign - Certain chassis equipped with certain Goodyear tires received a Greenhouse Gas (GHG) label that does not reference the correct tire emissions identifier related to new rolling resistance data.
Every Peterbilt 348 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.