Prevost is recalling certain model year 2009-2010 H3-45 and model year 2009 H3-41, X3-45, XLII Converted Coach Shells and XLII-45 Entertainer Converted coach and model year 2008 H3-VIP coach shells. The mechanical springs used to return the accelerator pedal to idle after the driver lifts their foot off the pedal may break.
Risk and remedy
Risk
If the springs break, the pedal may not return to idle once the driver lifts their foot off the pedal. This unintended acceleration increases the risk of a crash.
Remedy
Prevost will notify owners, and dealers will replace the affected accelerator pedals, free of charge. The recall began on December 17, 2013. Owners may contact Prevost at 1-418-883-2888. Prevost's recall number is SR13-72.
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
10231098Improved bearings are now available to replace the original bearings used on some Prevost vehicles idler pulleys.
10231093STEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139
10228667Air Tanks Draining Sequence. Revision: B - General Update
10226925Halogen to LED fog light replacement kit. Revision: C - Advanced kits canceled
10217314STORAGE AND STARTUP GUIDELINES : part number updates
10214935Central hvac merv filters installation
10199007STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guidelines in this document during times when: The coach can be operated on a regular/weekly basis while in storage. The coach will be in storage for an extended period without any operation. The coach will return to service following an extended period of downtime.
10184354Introducing a new engine coolant into service
10179434STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020
10177808JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
10176961STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
10174680Prevost vehicle disinfection procedure
10174679Storage and startup guidelines - all prevost vehicles & volvo 9700
10173171Added: Power cables for L.H. side alternator & fan drive breaker box
10164157This instruction sheet explains how to install 780428 door actuator replacement.
10158588This Instruction sheet explains how to replace the ?MASTER ID? WITH ?MCM? Module
10153349This Instruction sheet explains how to replace the "MASTER ID WITH MCM" Module
10131545The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
10131543This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5/8po, 3/4po, 7/8po, 1 1/8po and 1 3/8po inside diameter (I.D) can be replaced by new WAVE SEAL type constant torque hose clamps.
10131435This Maintenance Information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
10131433This Maintenance Information explains how to perform an inspection of the vehicle power cables. Power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
10126465The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
10120433The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
10120410Use this maintenance information procedure to resolve an undesired behaviour on 2008-2012 vehicles. In sleep mode, certain marker lights may remain illuminated.
10120405The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
10120403This Instruction sheet explains how to prevent AC Copper Pipes Chaffing at Engine Bulkhead
10118493This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? Module
10118485This instructions sheet explains how to program a Wabco Smart Trac ABS ECU.
10110717This Instruction Sheet explains how to use Retrofit kit for obsoleted small AC condensers (950018 & 950335)
10110703This Instruction Sheet explains how to install Keyless Keypad using either kit 069140 or 069141
10110678This Instruction Sheet explains how to retrofit the DEF tank left side filler neck on H3 VIP motorhomes with central or small a/c system
Every Prevost H3 Vip model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.