2009 Prevost W5

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 10228667Air Tanks Draining Sequence. Revision: B - General Update
• 10226928Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
• 10226927Air Tanks Draining Sequence
• 10217314STORAGE AND STARTUP GUIDELINES : part number updates
• 10214937X3 series envirocare - ions air sanitizer
• 10214936STEERING GATEWAY Revision A Cancel watch dog removal from EFD part of the instruction
• 10214935Central hvac merv filters installation
• 10199007STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guidelines in this document during times when: The coach can be operated on a regular/weekly basis while in storage. The coach will be in storage for an extended period without any operation. The coach will return to service following an extended period of downtime.
• 10188231Introducing a new engine coolant into prevost service center network
• 10188230Slide-out Linear Bearing and Guides Kit
• 10186398Rev A: Mention added concerning DDC Series 60 engine SCA requirement
• 10184354Introducing a new engine coolant into service
• 10177808JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
• 10176961STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
• 10174680Prevost vehicle disinfection procedure
• 10174679Storage and startup guidelines - all prevost vehicles & volvo 9700
• 10173171Added: Power cables for L.H. side alternator & fan drive breaker box
• 10164157This instruction sheet explains how to install 780428 door actuator replacement.
• 10158588This Instruction sheet explains how to replace the ?MASTER ID? WITH ?MCM? Module
• 10153350This instruction sheet explains how to install and adjust drag link # 660699
• 10153349This Instruction sheet explains how to replace the "MASTER ID WITH MCM" Module
• 10153344This instruction sheet explains how to install and adjust drag link # 660699
• 10152636This instruction sheet explains how to replace the message center display (MCD)
• 10148078This instruction sheet explains how to replace the left bell crank using kit 161349
• 10138426This instruction sheet explains how to install an ELD interface kit on Pre-OBD Prevost Vehicles equipped with Volvo D13 Engines
• 10138425This instruction sheet explains how to install and adjust drag link # 660699
• 10131545The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
• 10131543This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5/8po, 3/4po, 7/8po, 1 1/8po and 1 3/8po inside diameter (I.D) can be replaced by new WAVE SEAL type constant torque hose clamps.
• 10131435This Maintenance Information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
• 10131433This Maintenance Information explains how to perform an inspection of the vehicle power cables. Power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
• 10126465The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
• 10120433The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
• 10120405The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainless valves stems. Since the older and newer sensors are using different valve stems, replacement of a defective sensor on older vehicles will require the use of a new kit number (valve stem and sensor assembly). The table below provides a quick overview between the older and newer part numbers depending on wheel application.
• 10120399This procedure explains how to perform a STARTER REMOVAL AND INSTALLATION, and does apply to Melco 105P70 starter part number #21212425.
• 10118493This Instruction sheet explains how to remplace MASTER ID? WITH ?MCM? Module
• 10118485This instructions sheet explains how to program a Wabco Smart Trac ABS ECU.
• 10110717This Instruction Sheet explains how to use Retrofit kit for obsoleted small AC condensers (950018 & 950335)
• 10110703This Instruction Sheet explains how to install Keyless Keypad using either kit 069140 or 069141

Every Prevost W5 model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.