2012 Terex Aerial Devices
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Terex › Aerial Devices › 2012
These records cover every 2012 Terex Aerial Devices. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
10 recalls name the 2012 Terex Aerial Devices. Newest first.
Terex South Dakota (TSD) is recalling certain 2007-2016 vehicles equipped with Terex C4000, FC, HR, HRX, SCM, TC, TCX, TL, TPL, and XT aerial devices and digger derricks used for utility line work. In the event of a short circuit of a tool plugged into the onboard electrical socket, the GFPE breaker may not trip at the proper current before the user…
Risk and remedy
Risk
Without proper protection against electrical shock, the user has a greater risk of injury.
Remedy
TSD will notify owners, and dealers will replace the breakers with GFCI breakers that will trip at a lower current, free of charge. The recall began on June 27, 2017. Owners may contact TSD Customer Service Department at 1-800-982-8975. TSD's number for this recall is SN658.
Terex South Dakota (TSD) is recalling certain 2012-2017 Digger Derricks and Aerial Devices, models C4000, C5000, C6000, C7000, General, HR, OM, RM,RMX, SC, SCM, TC, TCX, TL, TM, and XT, built on Freightliner chassis with SmartPlex engine controls. The vehicles have a switch to monitor whether the hood is open or not. If the switch thinks that the hood is…
Risk and remedy
Risk
If the hood switch prevents the remote engine controls from shutting the vehicle engine down in the event of a hydraulic issue on the Aerial or Digger Derrick, it may increase the risk of an injury.
Remedy
TSD will notify owners, and dealers will reprogram the vehicles to only disable the engine start function if the switch indicates that the hood is open, free of charge. The recall began on June 28, 2017. Owners may contact TSD Customer Service Department at 1-800-982-8975. TSD's number for this recall is SN659.
Terex South Dakota (Terex) is recalling certain model year 2011-2016 HR, HRX, TC, TCX, and SML aerial devices. The affected aerial devices may have inadequate welds at the boom tip leveling sprockets. A failure of these welds may result in the platform tilting unexpectedly.
Risk and remedy
Risk
If the platform tilts unexpectedly, the user may fall, increasing their risk of injury.
Remedy
Terex will notify owners. Terex will notify owners and provide a leveling sprocket for any unit with a cracked weld on the leveling sprocket or provide a reinforcement kit for any unit without a cracked weld on the leveling sprocket, free of charge. The recall began on May 24, 2016. Owners may contact Terex South Dakota at 1-800-982-8975. Terex's number for this recall is SN638.
Terex South Dakota, Inc. (Terex) is recalling certain model year 2007-2013 TLM37, TLM40, TLM41, and TLM50 aerial devices manufactured March 29, 2007, to January 31, 2013. The aerial devices have the pedestal attached to the lift turrets that may crack due to missing reinforcements.
Risk and remedy
Risk
Cracks, if not repaired, may result in the failure of the aerial pedestal, increasing the risk of injury to the operator or those nearby.
Remedy
Terex will notify owners, and dealers will install reinforcement plates on the pedestal, free of charge. The recall began on April 22, 2016. Owners may contact Terex customer service at 1-800-982-8975. Terex's number for this recall is SN622.
Terex South Dakota, Inc. (Terex) is recalling certain 2008-2015 TLM37, TLM37P, TLM39, TLM41, TLM50, TLM55, and TLLM60 aerial devices manufactured June 18, 2008, to September 28, 2015. On the affected devices, both the boom tip leveling cylinder and the master cylinder at the elbow may make contact with the structural components, potentially damaging the…
Risk and remedy
Risk
Repeated contact may result in the rod eyes cracking. This cracking can lead to the failure of the boom tip leveling cylinder rod eye and the platform tilting unexpectedly which could cause the occupants to fall from the aerial platform, increasing their risk of injury.
Remedy
Terex will notify owners, and dealers will modify the aerial devices to prevent the components from making contact. The recall began on April 11, 2016. Owners may contact Terex customer service at 1-800-982-8975. Terex's number for this recall is SN621.
Terex South Dakota, Inc. (Terex) is recalling certain model year 2011-2015 SCM48, SCM50, and SCM55 aerial devices manufactured August 24, 2011, to November 5, 2015. The affected vehicles have a leveling cylinder linkage that can be forced past its intended stop position, causing damage to, and failure of, the leveling system.
Risk and remedy
Risk
If the leveling system fails, the aerial platform may tilt, increasing the risk of injury to the user or those nearby.
Remedy
Terex will notify owners, and dealers will install a stop to prevent excessive cylinder linkage movement, free of charge. The recall began on February 22, 2016. Owners may contact Terex customer service at 1-800-982-8975. Terex's number for this recall is SN627.
Terex South Dakota, Inc. (Terex) is recalling certain model year 2006-2014 TLM series models manufactured from December 2006 through February 2014 which were installed on Ford F550 vehicles. The affected vehicles may develop a crack in a notch of the vehicle frame.
Risk and remedy
Risk
A crack in the frame may cause frame failure, resulting in a loss of vehicle control, increasing the risk of a crash.
Remedy
Terex will notify owners, and dealers will repair any cracked frames and install a preventative reinforcement on the affected vehicles which have not cracked, free of charge. The recall began on July 8, 2014. Owners may contact Terex customer service at 1-605-882-4000. Terex's number for this recall is SN610.
Terex is recalling certain model year 2012-2013 Aerial Devices and Digger Derricks manufactured September 2012 through February 2013. The lock valve cavity in the outrigger cylinder may be machined incorrectly and the seals may be damaged.
Risk and remedy
Risk
Damaged seals may allow the outrigger to drift. If the outrigger cylinder drifts, stability may be affected and the unit may overturn, increasing the risk of injury.
Remedy
Terex will notify owners, and dealers will inspect the affected outriggers to determine if they were machined correctly. The inspection and any necessary repairs will be performed free of charge. The recall began on May 30, 2013. Owners may contact Terex at 1-605-884-3892. Terex's recall campaign number is SN607.
Terex South Dakota, Inc. (Terex) is recalling certain model year 2012 T292, TL, and NT Aerial Devices installed on utility trucks and equipped with a 110 VAC inverters. The Ground Fault Interrupt (GFI) may not offer GFI protection due to the neutral wire being ungrounded in the inverter.
Risk and remedy
Risk
If the GFI does not function, and a tool that is plugged into the inverter has a short, the operator could receive an electrical shock, resulting in electrocution.
Remedy
Terex will notify owners, and dealers will add a jumper wire between the neutral and ground wire, free of charge. The recall began on April 18, 2013. Owners may contact Terex at 1-605-882-4000.
Terex South Dakota, Inc. (Terex) is recalling certain model year 2012 utility trucks with SCM Aerial Devices. The lifting device's leveling arm may flex at the elbow and contact the boom structure. This may cause the leveling arm to break.
Risk and remedy
Risk
If the leveling arm fails, the platform could tilt and the occupants may fall from the platform.
Remedy
Terex will notify owners, and dealers will replace the leveling arm free of charge. The recall began during April 2013. Owners may contact Terex at 1-605-882-4000.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10199094SA696 Contamination in Auxiliary Power Check valve: Informs service personnel that the check valve will not function if contaminated. The only time the check valve is needed is when auxiliary power option are used. If not checked as part of the daily pre-shift inspection the Auxiliary Power may not function when needed.
- 10173607Advisory to move the lanyard location on end mount aerials to a position the lanyard snap hook can not hang into the platform.
- 10115678Inform users of changes to OSHA fall protection requirements for platform occupants of Aerial Devices and Digger Derricks. Due to rewrite of OSHA 1926 Subpart V.
- 10082040Letter and bulletin sent to owners of off road track vehicles which may see cracks in mounting due to flexibility in the track vehicle frame. This mounting IS unique to off road track vehicles.
Every Terex Aerial Devices model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.