2016 Triumph Speed Triple R
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Vehicles › Triumph › Speed Triple R › 2016
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
These records cover every 2016 Triumph Speed Triple R. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
1 recall names the 2016 Triumph Speed Triple R. Newest first.
Triumph Motorcycles America, LTD (Triumph) is recalling certain 2016-2017 Speed Triple R and Speed Triple S motorcycles. A wire for the charging system may rub against a bracket for the ABS modulator, potentially resulting in an electrical short.
An electrical short could cause the engine to stall, increasing the risk of a crash.
Triumph will notify owners, and dealers will replace the affected wire, rerouting it to avoid contact with the bracket, free of charge. The recall began on December 14, 2017. Owners may contact Triumph customer service at 1-678-854-2010. Triumph's number for this recall is SB552.
Soft front brake lever that constantly returns after multiple brake bleeds. First pull of the front brake lever IS soft, followed by a more firm second pull. Happens when stationary or when moving.
Front brake lever IS always very soft on first pull and produces reduced braking ability. the lever IS firm on the second pull and the front brakes operate and stop properly. I usually squeeze the lever twice to stop, but that could take too long in an emergency stop.
The front brake lever's travel decreases up to one inch when not in use in as little as 2 days of inactivity. Bleeding of system's brake fluid, cleaning of pistons and seal replacement have been performed but no permanent change.
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE21017) on July 9, 2021 for model year (MY) 2016-2019 Triumph Thruxton and Speed Triple model motorcycles based on allegations of loss of front braking performance.Vehicle Owner Questionnaires (VOQ) indicated riders were experiencing a soft front brake lever that could result in an unexpected extended stopping distance. On July 28, 2021, ODI sent an Information Request letter to Triumph to learn more about the subject components and alleged defect.On September 24, 2021, Triumph submitted its response, which ODI analyzed.ODI learned that the majority of the VOQ incidents occurred two or more years after the motorcycle was manufactured. The manufacturer recommends changing the brake fluid every two years, regardless of mileage. As the manufacturer’s warranty lasts for two years from the date of sale, many dealers covered the complicated brake fluid replacement procedure under warranty. However, most of the motorcycles involved in these incidents were overdue to have their brake system serviced. Triumph conducted testing of the brake system to better quantify what riders were experiencing.Triumph found pulling the lever a second time immediately after an initial pull did result in less lever travel for the same force exerted on the lever.This reduction was two millimeters or less.Additional testing was conducted to ascertain the caliper force generated relative to various lever forces.Triumph found that the caliper force varied +/- 2% between the first and second pull of the front brake lever and any given applied force. Triumph claimed that the lack of proper maintenance was the cause of the soft brake lever.Triumph conducted additional testing to quantify this claim.The lever travel between the first and second pull increased 150% on an improperly maintained system versus a properly maintained system.However, the caliper force only decreased 2-3% on average with this increased lever travel, further indicating that the subject motorcycles are capable of fully stopping. ODI located and evaluated a subject motorcycle.Measurements were taken and confirmed there was a small decrease in lever travel between the first and second pull.ODI then conducted a series of hard braking events, which did not produce evidence that the difference in lever travel resulted in an extended stopping distance. ODI also considered Fatal Accident Reporting System (FARS) data.ODI identified six fatal events that involved a subject vehicle.The service history records were reviewed for each motorcycle, however,none of the records included any mention of braking problems and thus there is no indication that the alleged defect may have contributed to the fatal crashes. As of this time there are no VOQ or manufacturer claims reporting an injury, fatality, or crash arising from this issue.Based on the available information, including the absence of such events after nine years of service on the oldest motorcycles, ODI is closing this investigation.The closing of this investigation does not constitute a finding by NHTSA that no safety-related defect exists. The agency reserves the right to take further action if warranted by the circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.