Vehicle recalls
30,429 recall campaigns from NHTSA, newest first. Decode a VIN to see the ones for your car.
Vehicle recalls per year
Most recalled systems
Latest recalls
On certain buses equipped with sure-lok wheelchair securement systems, the sprocket teeth of the retractor assembly IS out of alignment.
On certain trucks equipped with valeo wiper systems, the wiper motor may be susceptive to salt intrusion that could possibly lead to a condition where the connector overheats to a point where the connector could ignite.
Certain passenger vehicles have the possibility that the recess retains a rubber seal ring, which IS located at the end of the cylinder body, and may be corroded due to an improper washing process.
Certain terex aerial devices p/n HR37 and HR40 installed on trucks to transport the aerial device to the work site. these units have a leveling sprocket weldment at the elbow end that may contain defective welds.
On certain boat trailers, the trailer/boat combination may exceed the gross vehicle weight rating (gvwr).
On certain boat trailers, the vehicle's gross vehicle weight rating (gvwr) of 2990 lbs. IS inadequate.
Certain avrinmeritor axles, p/nos. Mfs-14-143a-nn58 and mfs-14-143a-nn60 manufactured between november 2002 and may 2003 and sold for use on international vehicles. the tie rod arms installed had not been induction hardened and…
On certain trucks equipped with liquid natural gas (lng) style tanks, neither the primary nor the secondary relief valves have opened to relieve tank pressure under certain conditions. specifically, the introduction of water into the…
Certain my 2004 sbfx-a and sd u.s. Bus school buses built on ford E-350 and E-450 chassis. the vacuum pump may become disengaged from the engine's drive mechanism causing loss of the vehicle's primary braking system.
On certain trailers, the wheel assembly hub spindle nut on each axle may have been installed without a "keeper." the purpose of the keeper IS to lock the spindle nut in place and, thereby, secure the wheel to the axle.
Cetain eaton hydraulics motor manifold assemblies model mcd 7810, rev g, p/n 02-198616, part of motor manifold assembly 100at00002a produced between december 2002 and march 2004 and sold for use on north american bus industries (nabi)…
On certain passenger and sport utility vehicles, under certain operating conditions, some electric cooling fans may overheat potentially causing heat damage and, in rare instances, a fire in the engine compartment.
On certain trucks built with the optional dana spl driveline, the u-joint fasteners at the output yoke of the transmission were not properly tightened.
On certain buses, the battery storage sliding tray locking toggle was not tightened sufficiently. the battery door can open allowing the battery tray to slide out from the stored position.
Certain minivans may have been produced with front wheel hub assemblies that were not heat treated correctly. this condition may lead to the development of small cracks in the hub.
On certain vans, the air filter element material process resulted in an air filter paper element that can smolder or burn. this change in filter paper composition combined with the configuration of the air induction system, may allow hot…
On certain vans, a diode in the anti-lock braking system (ABS) module may experience an electrical short.
On certain trucks equipped with 4.2L, 4.6L and 5.4L gasoline engines, the fuel tank may have a depression at the seam between the top and bottom halves of the tank. if a depression IS large enough, fuel may permeate the fuel tank wall…
On certain sport utility vehicles, the liftgate glass strut may become disengaged or the hinge may fracture allowing the glass to fall and possibly break.
On certain motorhomes equipped with cummins engines, oil can leak into the engine compartment from a crack in the cup plug.
On certain cab and chassis trucks, when excessive force IS applied to the accelerator pedal, beyond that required to achieve full acceleration, the pedal may become wedged between the floor panel and the carpet.
On certain motorcycles, at lower temperatures, wiring within the anti-theft control unit may press against the fuel pump relay. the fuel pump relay contacts could open, interrupting the fuel supply to the engine, resulting in stalling.
On certain trucks, the rebound cushion may stick to the hook hinge bracket, due to improper rubber composition of the cushion. this condition could result in the hook pin bracket remaining in the up (cab closed) position when the cab…
On certain motorhomes equipped with caterpillar engines, the adjustable pedal return springs may return the pedal shaft to the home position while not fully returning the potentiometer key to its home position.
Certain rodia motorcycle helmets model no. RF2. these helmets do not comply with the head protection requirements of federal motor vehicle safety standard no. 218, motorcycle helmets.
On certain trucks, the clearance between the cab main hook and the surrounding components may be insufficient. repeated normal cab tilting operation could cause the cab tilt system components to become damaged in the area of the cab main…
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." the daytime running lights do not meet luminous intensity…
Certain rodia motorcycle helmets manufactured between august 12, 2003, and august 10, 2004, model nos. Rhd 200, rhd 200V, rhd 300, and rhd 500. the chin straps do not have adequate stitching. these helmets do not comply with federal…
Certain galvanized tailgate cables for use on heavy trucks p/n 14600301 and 14600341. water gets trapped in the covering around the steel cable, eventually corroding it. during use, the cable(s) can break, allowing the tailgate to drop…
Certain mbii and mbiv school and commercial buses built on ford E-350 & E-450, gm 3500 chassis, manufactured between june 1, 1999, and december 31, 2003, and equipped with sure-lok wheelchair tie-down securement assemblies p/n 8625-13.…