1988 Chevrolet Corsica
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Vehicles › Chevrolet › Corsica › 1988
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
These records cover every 1988 Chevrolet Corsica. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
5 recalls name the 1988 Chevrolet Corsica. Newest first.
Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes…
This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.
Honeywell will notify owners and replace the fuel filters free of charge. the recall began on october 18, 2006. owners may contact fram customer service at 1-800-890-2075 (option 1).
The front shoulder belt retractors may have reduced sensitivity of the lock-up feature and would not function in a sudden deceleration or crash.
Failure of the shoulder belt retractor would result inthe seat occupant only being restrained by the lap belt in a crash or suddenstop, and an increased possibility of injury.
Secondary hood latch assembly on these vehicles may not be properly adjusted and could become bent. This will lead to a condition where full primary latch engagement IS not attained.
A bent secondary hood latch could lead to the primarylatch not being fully engaged, allowing the hood to unexpectedly open. If thiswere to occur while the vehicle was in motion, the hood may contact thewindshield, reducing the forward vision area of the driver and a vehicle crashcould occur without prior warning.
Replace the primary hood latch assembly, the secondary hood latch assembly, and the support bracket.
A door hinge (upper or lower) may break while opening or closing the door making it difficult to reposition and close properly.
Hinge separation may reduce the structural integrity ofthe side of the car and increase risk of injury in certain types of accidents.
Replace door hinges on both doors.
Secondary hood latch assembly may not have been properly adjusted resulting in latch becoming bent.
A bent secondary hood latch could cause the primarylatch to malfunction. if this occured the hood could unexpectedly open. ifthis happened while vehicle IS in motion reduction of forward visibility couldcause a vehicle crash without prior warning.
Inspect and replace secondary hood latch assemblies as required.
In 8/98 we began to have problems with the a/c. We have spent almost $2000, in repairs and it IS still not working. We are now being told it IS the compressor, even though we had it replaced in 8/98, along with the accumulator. We have had fan motors and fan blades replaced. Also we had the evaporator cleaned and serviced. We no cannot afford to purchase a new vehicle at this time. We just someone to help us with our problem. We live in florida and really need the a/c when it IS 98degrees outside!*ak
Lock problems would not unlock with or without a key and paint problems on the hood. *Ak
Side windows faulty. nlm
Hood latch failed while driving causing damage to roof and windshield when hood opened. (Ohio traffic crash report). Mjs
When it rains the vehicle IS flooded on the passenger's side only. water IS coming in from the windshield, but the dealer can't find out the cause of the problem. *ak
Mechanism that retracts and locks the seatbelts in place, does not function for front driver's and passenger's sides seatbelts. *ak
Coming out of parking lot the gas pedal got stuck, causing the vehicle to suddenly accelerate, resulting in an accident. *ak
Vehicle stalls at idle and on deceleration.
Bracket holding the front of driver's seat broke.
Unspecified.
Left bracket broke away from the bottom mounting bolt, to the mounting bracket for the power steering rack and pinion.
Ignition module failed twice, causing vehicle to shut down in traffic. (qcaw)
Paint on body and top of vehicle appears to be oxidizing. was told that there was a recall for 1990 and earlier models.
Paint IS peeling from vehicle.
While driving at about 35mph, the hood of the vehicle flew up and broke the windshield; it also obstructed the driver's view. Driver managed to steer vehicle to side of road. Will be taking to dealer. *ak
Driver's seat became loose and seperated from the seat track. this was caused by metal pieces falling off. *ak
Hood latch failed, causing hood to fly open/cracking windshield/roof damage.
Booster push rod retainer clip broke.
While drivng the vehicle about (25) mph the belt tensioner bracket on the engine cracked and came apart. The owner IS replacing part himself. *ak
When starting the vehicle the steering seems to have no power until it gets warm. it seems like driving a tractor. *ak *jb
Water pump failed.
Thermostat replaced. *Sd
High beam headlights failed, causing poor visibility. *Sd
Timing chain failed. *Sd
Both driver's side and passenger side seat belts are broken. Please describe details. *ak
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
There is no summary currently available
There is no summary currently available
There is no summary currently available
There is no summary currently available
There is no summary currently available
There is no summary currently available
===
There is no summary currently available
Inadequate brakes
===
There is no summary currently available
There is no summary currently available
There is no summary currently available
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.