1999 Chevrolet P30
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Chevrolet › P30 › 1999
These records cover every 1999 Chevrolet P30. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
1 recall names the 1999 Chevrolet P30. Newest first.
Certain honeywell fram racing brand HP4 and HP8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. the affected filters are marked with a date code a61451 through a72571 sequentially. the date code and part number appear on the filter housing. fram racing…
Risk and remedy
Risk
This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
Remedy
Honeywell will replace the affected oil filters free of charge. the recall began during november 2007. owners can contact fram customer service toll-free at 1-800-890-2075.
Owner complaints
2 complaints
What owners report most
Latest complaints
- Service brakes · Service brakes, hydraulic › Fluid
The contact owns a 1999 Chevrolet P30 Truck. The contact stated while driving approximately 20 MPH in stop and go traffic, the brake pedal was depressed and went to the floorboard. The contact was able to drive the vehicle to his destination. The contact stated no warning light was illuminated. The…
The contact owns a 1999 Chevrolet P30 Truck. The contact stated while driving approximately 20 MPH in stop and go traffic, the brake pedal was depressed and went to the floorboard. The contact was able to drive the vehicle to his destination. The contact stated no warning light was illuminated. The contact drove the vehicle to an independent mechanic who diagnosed that the brake fluid needed to be flushed and replaced. The contact had the vehicle repaired. The failure reoccurred after replacing the brake fluid. The vehicle was towed to another independent mechanic. The vehicle had not been diagnosed or repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 41,000.
- Electronic stability control (esc) · Service brakes, hydraulic · Suspension
1999 chevy P-30 ABS activation at very low speed unable to stop. Both sensors replaced at cost of $350 each and still does it. New brakes and wheel bearings on front for $700 and still does it. Disconnected ABS and brakes work fine. *Tr
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10248444Vehicle Recalls
- 10246631Expanded Availability for Remanufacture and Return (R&R) Electronic Control Modules
- 10232287This warranty administration bulletin provides information regarding the field action courtesy transportation policy.
- 10190934Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the component is constructed of an aluminum alloy.
- 10190933Underbody Component Corrosion The following information may be helpful when addressing underbody component corrosion with customers. Some customers may comment that one or more of their vehicle's underbody components are showing some form of corrosion. This corrosion may be red in appearance (rust) if the component is steel, forged iron or cast iron. This corrosion may also be grey or white in color if the component is constructed of an aluminum alloy.
- 10190932Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes, gouges, etc. The Dealer must insure that such damage is not deeper than what can be sanded or polished off. The wheel must be inspected for cracks. If cracks are found, discard the wheel. Any wheels with bent rim flanges must not be repaired or refinished. Wheels that have been refinished by an outside company must be returned to the same vehicle. The Dealer must record the wheel ID stamp or the cast date on the wheel in order to assure this requirement. Refer to Refinisher's Responsibility Outside Company later in this bulletin.
- 10190931Refinishing Aluminum Wheels This bulletin updates General Motor's position on refinishing aluminum wheels. GM does not endorse any repairs that involve welding, bending, straightening o re-machining. Only cosmetic refinishing of the wheel's coatings, using recommended procedures, is allowed. Evaluating Damage In evaluating damage, it is the GM Dealer's responsibility to inspect the wheel for corrosion, scrapes, gouges, etc. The Dealer must insure that such damage is not deeper than what can be sanded or polished off. The wheel must be inspected for cracks. If cracks are found, discard the wheel. Any wheels with bent rim flanges must not be repaired or refinished. Wheels that have been refinished by an outside company must be returned to the same vehicle. The Dealer must record the wheel ID stamp or the cast date on the wheel in order to assure this requirement. Refer to Refinisher's Responsibility Outside Company later in this bulletin.
Every Chevrolet P30 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.