2010 E-One Quest
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › E-One › Quest › 2010
These records cover every 2010 E-One Quest. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
1 recall names the 2010 E-One Quest. Newest first.
E-one IS recalling certain model year 2008 through 2011 cyclone II, typhoon, and quest vehicles manufactured from may 1, 2008, through november 28, 2011, and equipped with meritor wabco electronic stability control (esc) modules. under certain road and driving conditions, vehicle body roll and road inclination characteristics may adversely affect the slip…
Risk and remedy
Risk
If the driver IS slow to react during this esc intervention, the vehicle may deviate from the intended line of travel, increasing the risk of a crash.
Remedy
E-one will notify owners and IS working with meritor wabco to replace the control module free of charge. the safety recall began on december 16, 2011. owners may contact e-one customer service at 1-800-627-5050 or meritor on track customer service at 1-866-668-7221.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10171980E-ONE, Inc. TSB report for the month of February 2020.
- 10151806During a routine truck delivery inspection a malfunction of the air flow restriction indicator light was detected. Our investigation determined that the malfunction was introduced in 2007 with the launch of the new ISSPRO gauge cluster. The new dash gauge cluster changed the requirement for air flow sensor signal from active high to active low. This malfunction went unnoticed until now due to our published air filter routine maintenance requirements and the air filter?s longevity. Revised units affected by year.
- 10147323During a routine truck delivery inspection a malfunction of the air flow restriction indicator light was detected. Our investigation determined that the malfunction was introduced in 2010 with the launch of the new ISSPRO gauge cluster. The new dash gauge cluster changed the requirement for air flow sensor signal from active high to active low. This malfunction went unnoticed until now due to our published air filter routine maintenance requirements and the air filter?s longevity.
Every E-One Quest model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.