2018 Freightliner Sprinter 1500
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Freightliner › Sprinter 1500 › 2018
These records cover every 2018 Freightliner Sprinter 1500. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
6 recalls name the 2018 Freightliner Sprinter 1500. Newest first.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2015-2020 Mercedes Benz Sprinter and Freightliner Sprinter vehicles. The hydraulic power steering return line hoses may detach at their connection points under certain operating conditions, causing hydraulic fluid to leak.
Risk and remedy
Risk
The sudden loss of power steering assist and hydraulic steering fluid leaking onto the roadway may increase the risk of a crash.
Remedy
DVUSA will notify owners, and dealers will check the return line connections of the power steering system, correcting it as needed, free of charge. The recall began December 23, 2020. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this campaign is NV3LETULPE.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2018-2019 Mercedes-Benz Sprinter and Freightliner Sprinter vehicles. The spare tire label may indicate the maximum speed at 55 kilometers per hour (kph) rather than as 34 miles per hour (mph).
Risk and remedy
Risk
With only the metric speed listed on the spare tire label, the driver could misinterpret the kph as mph and operate the vehicle with the spare tire installed at higher speeds than the tire can withstand, increasing the risk of a crash.
Remedy
DVUSA will notify owners, and Mercedes-Benz or Freightliner Sprinter dealers will replace it with the label with the correct maximum speed information indicated in miles per hour, free of charge. The recall began May 15, 2020. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this recall is VS3BEGRESS.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2018-2019 Mercedes-Benz Sprinter and Freightliner Sprinter vehicles. The spare tire label indicating the maximum speed may have not been affixed to the spare tire.
Risk and remedy
Risk
Without the label, an operator may be unaware of the maximum speed limit of the spare tire and operate the vehicle at a excessive speed, increasing the risk of tire failure and a crash.
Remedy
DVUSA will notify owners, and Mercedes-Benz or Freightliner Sprinter dealers will attach the speed limitation label on the spare wheel, free of charge. The recall began May 15, 2020. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this recall is VS3BEGREPP.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2018-2019 Mercedes-Benz and Freightliner Sprinter vehicles. The airbag systems may not have been activated after vehicle production. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
Risk and remedy
Risk
An inactive airbag system can increase the risk of injury in the event of a crash.
Remedy
DVUSA will notify owners, and dealers will inspect the vehicles to determine if the airbag systems have been activated, correcting them as necessary, free of charge. DVUSA issued owners an interim notification on November 22, 2019. The recall began February 10, 2020. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this recall is VS3AIRIGEL.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2018-2019 Mercedes-Benz and Freightliner Sprinter vehicles. The screw connection on the upper hood catch may have been improperly tightened. As a result, factors such as the vehicle's speed, wind resistance and road conditions may cause the hood to open while the vehicle is being driven.
Risk and remedy
Risk
A hood that opens while driving can reduce the driver's visibility, increasing the risk of a crash.
Remedy
DVUSA will notify owners, and dealers will inspect the screw connection, tightening it as necessary, free of charge. The recall began November 1, 2019. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this recall is VS3HAUBOSS.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2018-2019 Mercedes-Benz and Freightliner Sprinter 1500, 2500, 3500 and 4500 vehicles. The rear side windows may be single-pane safety glass instead of laminated safety glass.
Risk and remedy
Risk
In the event of a side impact crash or vehicle rollover, the fitted side windows may not adequately protect the rear occupants from being ejected, increasing their risk of injury.
Remedy
DVUSA will notify owners, and Mercedes-Benz or Freightliner dealers will replace the single-pane safety glass with laminated safety glass., free of charge. DVUSA issued owners an interim notification on August 16, 2019. The recall began January 21, 2020. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this recall is VS3VERGLAS.
Defect investigations
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
- Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant…
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 11011223SMOG/Emissions Test fail due to one or more Readiness Monitors not set Complaint: The vehicle has failed the State Emissions Certification because one or more of the OBDII readiness monitors are not completely set. Cause: One or more of the following Readiness Monitors are not fully set within XENTRY: Misfire Monitoring - Injection System Fuel System Monitoring - Injection System, Fuel System, EGR Valve, O2 Sensor NMHC Catalyst Monitoring - NMHC/Diesel Oxidation Catalyst NOx Aftertreatment Monitoring - SCR Catalyst System Boost Pressure System Monitoring - Turbocharger, Charge Air System Exhaust Gas Sensor Monitoring - O2 Sensor, NOx Sensors Diesel Particulate Filter Monitoring - Diesel Particulate Filter System Exhaust Gas Recirculation System Monitoring - EGR Valve and system Remedy: Please complete the required driving conditions to fully set the incomplete Readiness Monitor. DO NOT: - Erase any fault codes. If fault codes are present, process these and allow the readiness drives to clear fault codes. - Flash or SCN code the CDI or SCR control units. - Perform a manual DPF regeneration, unless instructed below. - Disconnect the main battery.
- 11005573Complaint A: The engine is jolting/bucking between 1700 and 1900 rpm. Complaint B: One or more mechanical related fault codes for EGR Valve stored in CDI control unit, with possible Check Engine Light. Review list of mechanical fault codes in table below. NOTE: If one or more electrical related fault codes for EGR Valve are also present in CDI, utilize Complaint C. Review list of electrical fault codes PDF document in attachments. Complaint C: One or more electrical related fault codes for EGR Valve stored in CDI control unit, with possible Check Engine Light. Review list of electrical fault codes PDF document attached. NOTE: This LI supersedes LI14.20-N-073813, which is no longer valid. Cause Cause of Complaint A: Increased friction between the EGR Valve blade and seat due to soot deposits causing a delay of the EGR Valve being able to reach the target value of the EGR Valve position controller. NOTE: This causes the EGR Valve blade and potentially the boost pressure controller to oscillate. Cause of Complaint B: Soot deposits between the EGR Valve blade and seat leading to the EGR Valve no longer being able to meet the desired target of the EGR Valve position controller. Cause of Complaint C: Internal EGR Valve or other electrical faults related to the EGR Valve function.
Every Freightliner Sprinter 1500 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.