2004 Hyundai XG300
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Hyundai › XG300 › 2004
These records cover every 2004 Hyundai XG300. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
1 recall names the 2004 Hyundai XG300. Newest first.
Hyundai IS recalling 188,282 my 2001-2004 sonata and my 2001-2004 xg300 and xg350 vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia…
Risk and remedy
Risk
If that happens, the vehicle may lose drive power to the wheels, and the front wheel may make contact with the fender or wheel well, thereby increasing the risk of a crash.
Remedy
Dealers will measure the thickness of the front sub-frame and inspect the front sub-frame for corrosion damage and, if necessary, the front sub-frame will be replaced with a new sub-frame that incorporates additional holes in the upper and lower panels. if the front sub-frame does not require replacement, the dealer will add drainage holes to the sub-frame and will treat the sub-frame with rust-proofing material to stop the corrosion process. this procedure will be performed free of charge. the recall IS expected to begin during april 2009. owners may contact the hyundai customer assistance center at 1-800-633-5151.
Owner complaints
1 complaints1 involved a fire
What owners report most
Latest complaints
- Engine · Structure › Body · Unknown or other
My car randomly caught on fire and burned to thw ground I had to have the fire department put it out and not sure what happened never had a problem with it until now crunk it up was sounding off and next thing I know my friend screamimg my car was on fire something underneath towards the rear end…
My car randomly caught on fire and burned to thw ground I had to have the fire department put it out and not sure what happened never had a problem with it until now crunk it up was sounding off and next thing I know my friend screamimg my car was on fire something underneath towards the rear end in the middle was pouring fire and then I guess the gas tank went up and the fire was huge everything burmed to the tires inside everywhere its just metal nowmy car was parked I had juat crunk it up to leave my friends house I can see if my friend has a photo I had to buy new phone as mime was inside the car with my wallet and all
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10251285This bulletin contains information about the proper removal of the windshield wiper blade protective cover on all models. If the protective cover is not removed correctly, there is a possibility of the rubber insert and rail spring becoming partially separated on the inner side of the wiper blade, which could lead to poor wiping performance and/or possible scratching of the windshield glass. Follow the procedure in this bulletin to properly remove the windshield wiper blade protective cover on all new wiper blades.
- 10247189This bulletin provides important checkpoint guidelines when performing engine oil and filter change services.
- 10235566Hyundai applies a Paint Protection Film (PPF) on new vehicles before delivery to dealerships. It provides a barrier between the paint and contaminants, such as rail dust, acid rain, and industrial fallout. In rare cases, the paint can become clouded under the PPF. These spots are the result of moisture trapped between the PPF and the paint.
- 10230904This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation.
- 10217258Effective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) established a threshold for correcting load carrying capacity information indicated on tire placards when vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of GVWR or 100 pounds. If the total added weight exceeds the lesser of the limit, a label must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard.
- 10217251Follow the guidelines outlined in this bulletin to inspect and clean or replace certain components of the engine intake system accordingly during engine short block or sub-assembly replacement.
- 10196546Hyundai approves only the ATF, DCT gear oil and IVT gear oil specified in the vehicles owners manual. Use of other ATF may result in improper shift quality or other drivability conditions. Use of other DCT and IVT gear oil may result in reduced durability. Hyundai does not approve the use of any aftermarket ATF or gear oil additives.
- 10190044This bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
- 10190038This bulletin provides best practice recommendations when performing brake service procedures.
- 10189989This bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
- 10183963This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
- 10183960This bulletin provides tire vibration service procedures, including how to optimize vehicle vibration performance. For all wheel/tire balance claims, the Tire Balance Data Sheet must be fully completed including imbalance and Road Force Variation (RFV) data. The Data Sheet can be found at the end of this bulletin.
- 10178175This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.
- 10176182This bulletin provides information on tire maintenance best practices and procedures for dealers and customers to maximize tire life and performance.
- 10176178This bulletin describes the general guidelines to help disinfect and protect vehicle exterior/interior surfaces using recommended safe chemical products.
- 10174808This bulletin provides information on identifying dealer stock vehicles with either: A Battery SOC alert - low Battery State of Charge (SOC) at or below 50%. A 30 Day alert - vehicle has not started and reported an SOC in 30 days.
- 10174807The automatic transmission warranty repair policy authorizes in-dealership repairs of the following components for both OEM (new) and remanufactured automatic transmissions:
- 10173546This bulletin describes the general guidelines to disinfect and protect vehicle interior surfaces using certain safe chemical products.
- 10172142This bulletin describes the requirements for all wheel alignment and/or vehicle tracking claims and best practices when diagnosing and conducting alignment-related repairs for all models and model years.
- 10170883This bulletin provides guidelines to inspect the USB, head unit, and multi-box for common connection conditions. 2. This bulletin presents guidelines to inspect for common Android Auto and Apple CarPlay connection conditions. 3. This bulletin provides physical differences between the USB 2.0 port and USB 3.0 port.
- 10169370The Blind Spot Detection (BSD) or Blind-Spot Collision Warning (BCW) is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached in the rear bumper. The BSD/BCW detects vehicles within the blind spot zone and gives off an alarm (visual and audible). The two magnetic radar sensors provide these functions for BSD/BCW: ? Senses other vehicles in the BSD/BCW zone and turns on the BSD/BCW warning lamp for the driver. The warning lamp starts blinking, along with an audible sound, when the driver turns on the turn signal lamp to enter the lane where another vehicle is driving.
- 10167253This bulletin provides instruction detailing the proper methodology for scanning and uploading captured GDS data files to the Techline Repository. Compliance with this bulletin ensures that the GDS data files are correctly transferred and matched with a Techline Case number.
- 10059631Summary to be provided on a future date.
- 10032908Hyundai: ata solenoid diagnostic trouble codes p0740, p0741, p0742, p0743, p0746, p0748, p0750, p0755, p0760, p0765, p0770. Incorrect operation of the transaxle solenoids may result in the following symptoms-check engine light illuminated; transaxle held in 3RD gear fail safe.
- 10030984Hyundai: automatic transaxle range switch diagnostic trouble codes p0705 (range switch signal problems), p0707 (range switch open circuit), and p0708 (range switch short circuit or multiple inputs). An improperly adjusted or improperly operating range switch may result in the above mentioned conditions. Malfunction indicator light (mil) illuminated; impossible engine start in p or n.
Every Hyundai XG300 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.