Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
Risk and remedy
Risk
If the ignition switch overheats there would be an increased risk of a fire.
Remedy
Mazda will notify owners, and dealers will replace the ignition switch, free of charge. The recall began on December 17, 2015. Owners may contact Mazda Customer Experience Center at 1-800-222-5500, option#6. Mazda's number for this recall is 8715J.
Certain spx filtran fuel filters with a 45-degree angle inlet tube, model 800f350-s1, sold as replacement filters for 1993-1997 ford probe,1993-2001 mazda 626 and MX-6, and 1983-1994 loyal, 3-door coupe, hatchback, sedan, wagon, brat, dl, GL, GL-10, RX, xt, and XT6 passenger vehicles with efi or turbo engines. these filters are packaged as wix, napa, and…
Risk and remedy
Risk
In the presence of an ignition source, a vehicle fire can occur.
Remedy
Spx will notify its customers and provide a full refund. the recall began september 27, 2005. owners may contact mr. Chris greeson at 704-869-3733 or contact the wix information hotline at 800-949-6698.
While driving the vehicle, automatic transmission doesn't shift properly from the second gear to over drive. Vehicle will not pass 40 mph. Dealer stated the transmission needed to be replaced at owner expense of $2800.00 dollars. Please provide further information. *ph
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
10213429Paint damage Mazda pocket paint guide
10213425Speedometer replacement procedure
10200527This service bulletin provides information regarding the proper use of the drivers floor mat to avoid any potential interference with the foot pedals. The following are possible causes of floor mat interference, which can be avoided with proper usage.
10188016This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
10188015The Mazda DCA-8000PM is required for all warranty battery testing. If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code.
10186703In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer
10170661In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.
10000248Inadvertent disabling of brake shift interlock.