1995 Plymouth Breeze
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Plymouth › Breeze › 1995
These records cover every 1995 Plymouth Breeze. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
3 recalls name the 1995 Plymouth Breeze. Newest first.
Qualis automotive IS recalling certain aftermarket ball joints sold for use on certain passenger vehicles. the socket may have been excessively hardened which could cause it to crack near the retaining ring groove allowing the ball stud to separate under impact load. the subject ball joints were sold as four part numbers, d10945, d10946, g10945, and…
Risk and remedy
Risk
Separation of the ball stud from the socket of the ball joint housing would allow the control arm to collapse and the wheel to fold in causing loss of steering control, possibly resulting in a crash.
Remedy
Qualis automotive will replace the ball joints free of charge. the safety recall began on november 9, 2009. owners may contact qualis automotive at 1-800-493-4128.
Certain tigas fuel pump modules manufactured between june 1 and september 24, 2006, sold under various brand names and p/nos. these fuel pump modules are sold as aftermarket for use in certain daimlerchrysler vehicles listed above. silicone material used in manufacture of the flapper valve was out-of-specification, leading to excess swell of the flapper…
Risk and remedy
Risk
Fuel restriction could result in loss of power and/or engine stall, possibly resulting in a vehicle crash.
Remedy
Ti automotive will notify owners and replace the defective fuel pump modules free of charge. the recall began on october 6, 2006. owners may contact ti automotive toll-free at 1-877-461-1834.
Vehicle description: passenger vehicles. the lower control arm ball joint can separate due to loss of lubrication.
Risk and remedy
Risk
Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash.
Remedy
Dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. if the cover seal leaks or the boot IS damaged, the lower control arm will be replaced.
Defect investigations
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
- Auto trans ignition-park interlock
The manufacturer reports above are based on daimlerchrysler?s (dc) analysis of model year (my) 1998 (population = 356,384) and 1999 (population = 486,948) ja, JX and lh family subject vehicle data (earlier mys excluded).the population number includes all mys.the precise number of duplicates between odi and dc reports…
The manufacturer reports above are based on daimlerchrysler?s (dc) analysis of model year (my) 1998 (population = 356,384) and 1999 (population = 486,948) ja, JX and lh family subject vehicle data (earlier mys excluded).the population number includes all mys.the precise number of duplicates between odi and dc reports cannot be determined due to missing or incomplete information.the fatality incident involved an elderly person who attempted to stop a roll away vehicle and received fatal injuries.odi also gathered information on my 1997-99 prowler vehicles in this investigation. The prowler vehicles were manufactured with a different design shifter mechanism (the shift lever IS shorter).there are no complaints of prowler interlock failure in odi?s database, and dc has received no reports either.the prowler IS excluded from the recall scope.the investigation involved a condition where the interlock system could fail (or be made inoperative by the operator) during vehicle use, possibly inadvertently.the interlock system IS required under fmvss 114.with the transmission in the park position and the ignition key off, the combined action of pressing the shift button and pulling the shift lever rearward may result in the operator overcoming the interlock system and cause the mechanical linkage of the system to disconnect.when this occurs, there IS no overt indication to an operator that the system IS defeated, and an increased risk of vehicle roll-away exists.under recall 04v021, dc will replace damaged shift mechanisms, and will install on all vehicles a device which inhibits the operator?s ability to overcome the interlock and defeat the system.beginning with my 2000, dc incorporated a brake and transmission shifter interlock (btsi) system into the subject vehicles.introduction of btsi involved design changes to the shift mechanism, one of which resulted in reduced mechanical advantage (rma) of the shift button.the rma shifter requires increased forces to overcome the interlock system, making the shifter less susceptible to damage.
- Steering column separation
Mr. Larry a. Sackey submitted a petition to the national highway traffic safety administration (nhtsa) by letter dated april 18, 2003, requesting that nhtsafurther investigate the defective collapsible steering shaft system on 1987-1995 vehicles manufactured by the daimlerchrysler corporation.in part because of 49 cfr…
Mr. Larry a. Sackey submitted a petition to the national highway traffic safety administration (nhtsa) by letter dated april 18, 2003, requesting that nhtsafurther investigate the defective collapsible steering shaft system on 1987-1995 vehicles manufactured by the daimlerchrysler corporation.in part because of 49 cfr ? 30120(G), nhtsa has decided to limit the scope of the petition vehicles to 1993-1995 models, excluding the 1993 jeep grand cherokee and 1994-1995 dodge RAM series trucks that were recalled (93v210 & 96v230) for steering column failure.if the analysis of these vehicles had identified a potential problem, the scope could have been expanded in an investigation.a review of odi's data base shows no recent complaints and a lack of a complaint trend concerning the subject issue on the subject vehicles as a whole or by individual models.therefore, the petition IS denied.for details, see federal register notice volume 68, no. 130, july 8, 2003.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10191460Valve Body. These may cause over drive cycling.
- 10150552Child Seat Tether Anchor Installation This bulletin describes procedures to install Child Seat Tether Anchors based on Customer Request. Retrofits are subject to part availability. Vehicles in the following list that are marked **** for the model year are no longer supported with OEM retrofit kits. NOTE: Dealers are encouraged to honor any customers? request for the installation of the Child Seat Tether Anchors and Dealer reimbursement will be made by FCA US LLC regardless of vehicle age or mileage. See the Warranty Policy and Procedure Manual and/or Warranty Bulletin D-08-33 for reimbursement detail.
- 10001520Seat belt cinch bar service for various models including 2004 models.
- 6092304Subject regarding non-deployed airbag handling procedures.
- 6089800Daimlerchrysler corporation IS now offerinb airbag on / off switches for selected vehicles.
- 6089311Concerns with a/c evaporator odor. *Nlm
- 6089038Information on tire and wheel runout. *Nlm
- 6089036Concerns with transmission fluid auxiliary cooler. *Nlm
- 6089028Information on 41te/42le service information. *Nlm
- 6088988Concerns with 41te/42le transaxle shudder during an emcc (electronically modulated converter clutch) shift. *Nlm
- 6088858Information on gasket surface preparation on aluminum engine components. *Nlm
- 6088834Information regarding nhtsa authorized airbag deactivation for medical necessity. *Nlm
- 6088786Concerns with engine coolant usage. *Nlm
- 634272Flash programming failure recovery. *Slc
- 623153Exhibiting rough idle, hard start and start & stall.*cls
- 621898Automatic transmission fluid usage ATF+4.
- 620066Subject regarding generic scan tool (gst), publication no. 81-170-00008 provided with this technical service bulletin to provide reference information when using generic scan tool on obdii vehicles.
- 620059Subject regarding airbag / clock spring service for various models including 2002 model year jeep liberty.
- 618396This bulletin involves installation of a new component to assist cam seal retention.
- 618049Subject regarding wire splice repairs.
- 615688Subject regarding child seat tether anchors.
- 612160Subject on the child seat tether anchors. *Mjs
- 612149Vehicles may experience clunking or rattle in steering wheel/steering column. *Mjs
- 610635Subject regarding child seat tether anchors.
- 610007Daimlerchrysler corporation IS now offering internal emergency trunk releases for selection vehicles.
- 609995This bulletin provides a revised wire splice procedure and related parts.
- 608371Daimler chrysler IS now offering internal emergency trunk releases for selected vehicles.
- 607963Information on child seat tether anchors.
- 607959This bulletin announces the availability and installation of a resuable automatic transmission oil pan gasket.
- 607916Technical service bulletin regarding multi-layer steel (mls) head gasket installation procedures.
- 607914Information regarding 2.5L V-6 head gasket application.
- 607554Subject regarding the internal emergency trunk release.
- 607553Information pertaining to internal emergency trunk release dealer reimbursement.
- 606174Diamler chrysler corporation IS now offering internal emergency trunk releases for selected vehicles.
- 606160Brief information on the use of asbestos fiber brake linings.
- 605014Conditions with intermittent loss of speed control.
- 604696Subject regarding reusable automatic transmission oil pan gasket.
- 604364Service and parts information on 1999 running changes to transmission range sensor (trs)
- 603635Subject on flash programming failure recovery.
- 603153Subject regarding airbag on - off switches.
Every Plymouth Breeze model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.