1988 Pontiac 6000
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Vehicles › Pontiac › 6000 › 1988
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
These records cover every 1988 Pontiac 6000. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
3 recalls name the 1988 Pontiac 6000. Newest first.
Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes…
This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.
Honeywell will notify owners and replace the fuel filters free of charge. the recall began on october 18, 2006. owners may contact fram customer service at 1-800-890-2075 (option 1).
Fuel feed hose could leak at the coupling on the engine end of the hose assembly.
Fuel leakage into the engine compartment could result inan engine compartment fire that could spread to the passenger compartment.
Install new fuel feed hose assembly.
Front suspension lower control arm bracket could develop metal cracks.
These cracks may result in disengagement of the lowercontrol arm. if this occurs while vehicle IS in motion, it could result inloss of steering control and a vehicle crash could occur without prior warning.
Inspect all vehicles and replace engine cradle assembly on all suspect vehicles.
First transaxle was replaced at 175K miles because third gear was slipping, the replacement IS now doing the same, consumer has to start out in first gear and the reverse doesn't work. *Et
When the brakeis were applied they went to the floor and gave no respnose, to get a response , pedal has to be pumped hard. the consumer has had the anti-skid system deactivated so that the regular brake would work properly. The dealer has been contacted. *ak
Cold weather power steering failure. leaking seals. Replacement of rack and pinion and power steering pump. new rack and pinion failed again with onset of cold weather.
Steel fuel line IS rusted, and IS causing a leak by the rear of the gas tank. dealer has not been contacted. *ak
Front sway bar broke, causing vehicle to shimmy and sway to the right. Also trans axle malfunctioned.
Rack and pinion failure.
Driver and passenger plastic piece on seat belt locking mechanism have broken off; seat belts will not stay locked; often difficult to lock>ak
Passenger side seat belt will not retract shoulder and lap belt. tt
The backseat seatbelt behind the driver does not work at all and the front passenger seatbelt does not latch. Please describe. tt
The head gaskets seals will not tighten up so water gets in the oil and now the car will not run. Please describe. tt
During cold weather difficulty in turning steering wheel. tt
ABS braking system failed with hard pedal prior to failure warning lights came on. tt
Had to replace eight computers due to rough idle/stalling. tt
Having steering problems. tt
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
There is no summary currently available
There is no summary currently available
Summary:a chevrolet service bulletin dated july 1988 indicates that bothsockets must be replaced using part number 5972532.this service stockuses a new heat resistant material.production stock was also correctedbeginning with vins j7163799 and jj187909.===
There is no summary currently available
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.