2007 Prevost X3

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 10231093STEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139
• 10228667Air Tanks Draining Sequence. Revision: B - General Update
• 10226928Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
• 10226927Air Tanks Draining Sequence
• 10226925Halogen to LED fog light replacement kit. Revision: C - Advanced kits canceled
• 10217314STORAGE AND STARTUP GUIDELINES : part number updates
• 10214935Central hvac merv filters installation
• 10199007STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guidelines in this document during times when: The coach can be operated on a regular/weekly basis while in storage. The coach will be in storage for an extended period without any operation. The coach will return to service following an extended period of downtime.
• 10199002Central hvac merv filters installation reva
• 10189728TIE ROD 610052 FIRST INSTALLATION INSTRUCTIONS: Use these instructions when replacing the drop joint tie rod on S82, S84 / S84U I-beam axles. The new tie rod will be adjusted to the length of the original; however, a steering alignment needs to be performed after replacement.
• 10188231Introducing a new engine coolant into prevost service center network
• 10186398Rev A: Mention added concerning DDC Series 60 engine SCA requirement
• 10184354Introducing a new engine coolant into service
• 10179434STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020
• 10179388Sigma passenger seats partition kit
• 10177808JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
• 10176961STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
• 10174680Prevost vehicle disinfection procedure
• 10174679Storage and startup guidelines - all prevost vehicles & volvo 9700
• 10173171Added: Power cables for L.H. side alternator & fan drive breaker box
• 10171203Revision : Addition of Wiring Schematics at the end of this document
• 10165715This instruction sheet explains how to replace halogen fog light to led's
• 10164461This Maintenance Information explains how to install harness #7770134, designed to bypass the Engine Compartment Harness (Prevost part), connecting the DPF harness (10-pin connector) and the Engine Harness (31-pin connector).
• 10164156This Instruction Sheet explains how to perform the first installation of Tie Rod 610052 on Prevost vehicles equipped with Dana S82, S84 / S84U I-beam axles, 1994- today
• 10161720Message center display (mcd) replacement
• 10158592This instruction sheet explains how to install an ELD interface kit for Prevost Vehicles equipped with Multiplex Detroit Diesel Engines
• 10136789This instruction sheet explains how to install an ELD interface kit for Prevost Vehicles equipped with Multiplex Detroit Diesel Engines
• 10131546When replacing a vehicle sound selector model VSS04 with a new sound selector model VSS05, an interface harness is required to connect the vehicle harness to the new sound selector model and a new VSS05 compatible radio unit must also be installed. This procedure describes the steps required to perform this update.
• 10131545The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
• 10131543This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5/8po, 3/4po, 7/8po, 1 1/8po and 1 3/8po inside diameter (I.D) can be replaced by new WAVE SEAL type constant torque hose clamps.
• 10131537On the vehicles affected by this bulletin, relocate the video fuse in the SMI box closer to the door for better access.
• 10131536On the vehicles affected by this bulletin, at next service occasion, open the C69 connector located in the front compartment and check for presence of corrosion. Relocate the connector horizontally.
• 10131535On the vehicles affected by this bulletin, if needed, the celling panel needs to be removed and material glued again.
• 10131531On the vehicles affected by this bulletin, follow the enclosed procedure to remove corrosion around luggage doors.
• 10131435This Maintenance Information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
• 10131433This Maintenance Information explains how to perform an inspection of the vehicle power cables. Power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
• 10128689This internal instruction explains how to bench program the FMS gateway module used in the ELD (Electronic Logging Device) interface kit for pre-OBD13 vehicles.
• 10126470This Maintenance Information presents an improved differential breather kit, identical to the one now used in production. This new breather incorporates a "J" shaped hose that prevents oil leakage and water ingestion while allowing the axle to vent.
• 10126260This instruction sheet explains how to install latest radio models
• 10124092This Instruction sheet explains how to replace MASTER ID? WITH ?MCM? MODULE

Every Prevost X3 model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.