2008 Prevost X3

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 10231098Improved bearings are now available to replace the original bearings used on some Prevost vehicles idler pulleys.
• 10231093STEERING GATEWAY. Revision B - PIN 2 and 10 were inverted on connector A139
• 10228667Air Tanks Draining Sequence. Revision: B - General Update
• 10226928Air Tanks Draining Sequence. Revision: A - Erroneous Secondary & Accessory tanks location.
• 10226927Air Tanks Draining Sequence
• 10226925Halogen to LED fog light replacement kit. Revision: C - Advanced kits canceled
• 10217314STORAGE AND STARTUP GUIDELINES : part number updates
• 10214935Central hvac merv filters installation
• 10199007STORAGE AND STARTUP GUIDELINES: Periodically, circumstances arise requiring operators to temporarily park a coach in storage. Whether it is a few weeks or several months, sporadic out of service times or a full stop, Prevost recommends following the guidelines in this document during times when: The coach can be operated on a regular/weekly basis while in storage. The coach will be in storage for an extended period without any operation. The coach will return to service following an extended period of downtime.
• 10199002Central hvac merv filters installation reva
• 10189728TIE ROD 610052 FIRST INSTALLATION INSTRUCTIONS: Use these instructions when replacing the drop joint tie rod on S82, S84 / S84U I-beam axles. The new tie rod will be adjusted to the length of the original; however, a steering alignment needs to be performed after replacement.
• 10188231Introducing a new engine coolant into prevost service center network
• 10186398Rev A: Mention added concerning DDC Series 60 engine SCA requirement
• 10184354Introducing a new engine coolant into service
• 10179434STORAGE AND STARTUP GUIDELINES Revision: B Parts added to Suggested Material 08-10-2020
• 10179388Sigma passenger seats partition kit
• 10177808JERKY, NOISY OR HARD TO TURN STEERING GEARBOX. HYDRAULIC END LIMITER ADJUSTMENT. All models equipped with RB Bosch/ZF Servocom or Servocomtronic steering gearbox
• 10176961STORAGE AND STARTUP GUIDELINES: Rev A: 21516229 replaced by 23381562 20523393 replaced by 21454749 800383 removed 611471 replaced by 611360 70376808 replaced by 21036050 21396642 replaced by 20967831
• 10174680Prevost vehicle disinfection procedure
• 10174679Storage and startup guidelines - all prevost vehicles & volvo 9700
• 10173171Added: Power cables for L.H. side alternator & fan drive breaker box
• 10165715This instruction sheet explains how to replace halogen fog light to led's
• 10164156This Instruction Sheet explains how to perform the first installation of Tie Rod 610052 on Prevost vehicles equipped with Dana S82, S84 / S84U I-beam axles, 1994- today
• 10161720Message center display (mcd) replacement
• 10158592This instruction sheet explains how to install an ELD interface kit for Prevost Vehicles equipped with Multiplex Detroit Diesel Engines
• 10158588This Instruction sheet explains how to replace the ?MASTER ID? WITH ?MCM? Module
• 10153359On the vehicles affected by this bulletin, proceed to the replacement of the drag link.
• 10153349This Instruction sheet explains how to replace the "MASTER ID WITH MCM" Module
• 10138427On the vehicles affected by this bulletin, proceed to the replacement of the drag link.
• 10136795On the vehicles affected by this bulletin, replace the drag link.
• 10136789This instruction sheet explains how to install an ELD interface kit for Prevost Vehicles equipped with Multiplex Detroit Diesel Engines
• 10131557A new software version (v1.06) is available to update the CANtrak (Tire Pressure Monitoring System) module. This new version will allows a 10 min. delay before the ?SYSTEM ERROR NOT ALL TIRES MONITORED? message appears in the vehicle cluster when a tire pressure sensor loses its connection. NOTE: The new software version will only delays the cluster message, the CANtrak screen will still displays a ??? code for the corresponding pressure sensor.
• 10131546When replacing a vehicle sound selector model VSS04 with a new sound selector model VSS05, an interface harness is required to connect the vehicle harness to the new sound selector model and a new VSS05 compatible radio unit must also be installed. This procedure describes the steps required to perform this update.
• 10131545The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. Corrective action is presented.
• 10131543This Maintenance Information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5/8po, 3/4po, 7/8po, 1 1/8po and 1 3/8po inside diameter (I.D) can be replaced by new WAVE SEAL type constant torque hose clamps.
• 10131537On the vehicles affected by this bulletin, relocate the video fuse in the SMI box closer to the door for better access.
• 10131536On the vehicles affected by this bulletin, at next service occasion, open the C69 connector located in the front compartment and check for presence of corrosion. Relocate the connector horizontally.
• 10131535On the vehicles affected by this bulletin, if needed, the celling panel needs to be removed and material glued again.
• 10131533On the vehicles affected by this bulletin, take the following measure to improve dust handling. Seal the evaporator compartment to prevent dust entry, add ribs inside the duct to prevent collapse by the weight of accumulated dust, modify the trim molding above the evaporator door opening, and remove the additional mud pad under the vehicle.
• 10131531On the vehicles affected by this bulletin, follow the enclosed procedure to remove corrosion around luggage doors.

Every Prevost X3 model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.