2007 Temsa TS35
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Have the VIN?
Vehicles › Temsa › TS35 › 2007
These records cover every 2007 Temsa TS35. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
Recalls
2 recalls name the 2007 Temsa TS35. Newest first.
Temsa Global is recalling certain model year 2007-2010 TS35 buses for failing to comply with the requirements of Federal Motor Vehicle Safety Standard No. 217, "Bus Emergency Exits and Window Retention and Release." The buses may have one too few emergency exits on each side of the bus for the number of seats that the bus is equipped with.
Risk and remedy
Risk
Passengers may be delayed in exiting the vehicle during an emergency which can increase the risk of personal injury.
Remedy
Temsa will notify owners, and will install a third emergency exit window on each side side of the bus, free of charge. The recall began on January 3, 2013. Owners may contact Temsa at 1-404-602-0151.
Temsa global (temsa) IS recalling certain model year 2007-2012 TS35 buses for failing to comply with the requirements of federal motor vehicle safety standard no. 217, bus emergency exits and window retention and release. some of the emergency exit mechanism instruction labels may have been installed farther than 16 cm from the release mechanism.
Risk and remedy
Risk
Due to the distance between the operating instructions and the windows release mechanism, in the event of an emergency, passengers may not recognize and follow the instructions for releasing the emergency exit windows delaying their safe exit from the bus and , increasing the risk of personal injury.
Remedy
Temsa will notify owners, and new labels will be mailed to owners free of charge. the safety recall IS expected to begin on or before may 23, 2012. owners may contact temsa at 1-404-602-0151.
Service bulletins
Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.
- 10186878This bulletin defines alignment specifications of the TS35 vehicle. Alignment of TS 30.
- 10186278Bathroom lock latch bolt
- 10185889FIRE INSTRUCTIONS: Actions to Be Taken In The Event Of a Fire.
- 10185885New flap is to be installed in fuel tank filler cap
- 10185884New flap is to be installed in fuel tank filler cap
- 10185883Relocating Transmission Oil Dipstick
- 10185882Following document shows how to set tag axle steering system cylinders and bleeding the tag axle steering system
- 10184238Alignment Sepcifications of TS35. This bulletin defines alignment specifications of the TS35 vehicle.
- 10183910Information Document sheet.
- 10183888Preventing fuel leaking out
- 10183887Preventing fuel leaking out
- 10183886Relocating transmission oil dipstick.
- 10183885Instructions on how to set tag axle steering system cylinders and bleeding the axle steering system.
- 10183856Vehicle Schematics
- 10183855Temsa Non Exclusive Authorised Service Center Agreement
- 10183854TS 35 Epa13 Wiring. Refer to Section 6 and Section for hardware pin-out of MOKI, ZR32, MULTIPLEXERS, and CAN lines. As the multiplex unites are controlled by special algorithm, in case needed, the latest vehicle program should be downloaded from online system E-DOC.
- 10128114ZF Service Information Bulletin for retrofitting seal carrier and readjustment of king pin
- 10056006Temsa: information provided regarding the replacement of hydraulic hoses in some buses.
- 10045882Temsa: information provided regarding the torque value for intercooler clamp improvement. Model TS-35. No model years listed.
- 10044446Temsa bus: when ignition IS off or key switch IS removed, door control switch can not be use. A new relay flasher buzzer sound under dashboard will be installed. Modification to door control switch inside bus allows usage when ignition IS off or key switch IS removed.
Every Temsa TS35 model year
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.