2009 Ford F-750

Recalls

1 recall names the 2009 Ford F-750. Newest first.

• Exterior lighting

  Dec 15, 2009NHTSA 09V47600042 vehicles

  Ford IS recalling model years 2009 F-650 and F-750 trucks. the chassis wire harness may have been assembled without a connector seal if this seal IS missing, the connector terminals may corrode affecting the proper illumination of the vehicle's rear brake lamps, tail lamps, turn signal lamps or trailer lamps (if equipped.) also, the function of the…

  Risk and remedy

  Risk

  Inoperative lamps may increase the risk of a crash.

  Remedy

  Dealers will inspect the connector and repair the main and rear chassis wire harness if necessary. a missing seal will be replaced and electrical grease applied to prevent future corrosion. the safety recall began on december 16, 2009. owners may contact ford at 1-866-436-7332 or through the internet at www.fordowner.com.

  Full recall details →

Owner complaints

Latest complaints

• Aug 14, 2013MD7,000 mi
  Service brakes
  TL* the contact owns a 2009 ford F-750. The contact stated that while driving 30 mph, the brakes failed with the illumination of the ABS and brake lights on two separate occasions. The contact was able to stop the vehicle. The vehicle was towed to an independent mechanic for diagnosis where it was…

  TL* the contact owns a 2009 ford F-750. The contact stated that while driving 30 mph, the brakes failed with the illumination of the ABS and brake lights on two separate occasions. The contact was able to stop the vehicle. The vehicle was towed to an independent mechanic for diagnosis where it was stated that the brake unit needed to be replaced. The vehicle was not repaired and the manufacturer was notified. The vin was not available. The approximate failure mileage was 7,000.

Service bulletins

Technical service bulletins and other communications the manufacturer sent dealers about this vehicle. Ask a dealer for the full document by its number.

• 10254138All accessory stick-on keyless entry keypads come with a wallet card containing the master code. If the accessory keypad was factory installed, this card will be placed in the glove box and should be handed to the vehicles owner during initial delivery. Unlike the integrated (wired) factory keypad, the accessory keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool. If the wallet card for an accessory keypad is lost, follow these steps to recover the code. Dealer Key Code access is granted through the Dealer Program Enrollment System (DPES); dealership management can authorize users. The authorized user must go to FMCDealer.com > Parts and Service > Parts Product Line Information > Keys/Entry Devices > Aftermarket Keyless Entry Keypad Code Access. Follow the instructions on the screen to obtain the master code for the accessory keypad.
• 10235153For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.
• 10183762Some 2006-2015 F-Super Duty 650/750 vehicles equipped with exterior tubular stainless steel west coast style mirrors may have a loose mounting bracket due to poor rivet retention.
• 10074664Summary to be provided on a future date.
• 10039053Ford: if there IS an intermittent lack of power, surge, or hesitation while driving the brakes will override acceleration.
• 10038965Comm-trans lund: some 2009-2011 models may have the air bag inicator flashing with a stored trouble code. This IS a software problem.
• 10034631Ford: supply/return lines installation at high pressure pump-revised washer for trucks equipped with 6.4L engines. When installing supply or return lines at high pressure pump on diesel engines, do not use the bonded style washer (w302870), use only the hybrid style washer (w303659).

Every Ford F-750 model year

Bars are owner complaints, dots mark years with recalls. Select a year to open its report.