1979 Chevrolet Malibu
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
Vehicles › Chevrolet › Malibu › 1979
Safety record from NHTSA: recalls, owner complaints, investigations and service bulletins.
These records cover every 1979 Chevrolet Malibu. To see whether one car still needs a recall repair, decode its VIN or check it with NHTSA.
6 recalls name the 1979 Chevrolet Malibu. Newest first.
Certain honeywell fram racing brand HP4 and HP8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. the affected filters are marked with a date code a61451 through a72571 sequentially. the date code and part number appear on the filter housing. fram racing…
This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
Honeywell will replace the affected oil filters free of charge. the recall began during november 2007. owners can contact fram customer service toll-free at 1-800-890-2075.
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. consequence of defect: a loss of brake fluid leads to loss…
Rear axle assembly may have axles that were improperly manufactured. This condition may result in separation of the axle shaft and wheel assembly from the vehicle.
The dealer will inspect the rear axle to determine whether it was manufactured at the buffalo plant. If so, they will make axle measurements and if necessary replace or modify affected axle components without charge.
The bolts that attach the lower rear control arm to the frame may fracture. The rear control arm supports and positions the rear axle. Fracture of the bolts would allow the control arm to drop free.
Both rear control arm attachment bolts will be replaced without charge.
The electro-clear rear window defoggers contain a defect which causes the glass to shatter without impact during or some time after use of the defogger. Vertical electrical strips may deteriorate and cause hot spots that can result in breakage of the rear glass.
Vehicles will be inspected for presence of a particular weatherstrip. If present, a layer of a special conductive epoxy will be added to the vertical bar on the rear window glass. This epoxy IS a new conductive material which will not react with the weatherstrip.
The invovled vehicles fail to conform to federal motor vehicle safety standard no. 201, "occupant protection in interior impacts". Incorrect head restraints may have been installed.
Dealer will inspect and, if necessary, install new head restraints at no cost to owner.
Consumer IS requesting information on where to find safety belts for his 1979 chevrolet malibu. *mr one of the consumers seat belts started to fray. *sc *jb
Brake cylinder ruptured the hydraulic brake line causing brake failure, not included in recall due to location of assembly.
Rear wheel brake failure occurred due to brake cylinder only being attached to backing plate at one point, allowing it to turn/rupture brake line. *Dsh
Defective rear wheel brake cylinder, caused brake failure. *skd
NHTSA’s Office of Defects Investigation opened these reviews into vehicles including this one.
Summary:gm IS conducting a voluntary recall campaign (85v-048)involving 2,136,826 vehicles. The recall IS limited to vehicles built atcertain assembly plants which, according to gm, overtorqued the brakepipe nut,thereby overstressing the wheel cylinder support area of thebacking plate.analysis:front brakes provide sufficient braking for passenger carsin most non-emergency situations. All affected trucks are included inthe current recall.in most cases the problem IS discovered during brakemaintenance.the recall appears to cover those groups of cars with thehighest failure rates.status:analyzing gm ir response and new complaint data. Draft closingreport by 5/15/88.===
Bars are owner complaints, dots mark years with recalls. Select a year to open its report.